- 您现在的位置：买卖IC网 > PDF目录189451 > OV09121-C00A (Electronic Theatre Controls, Inc.) OV9625 Color CMOS SXGA (1.3 MPixel) CAMERACHIP OV9121 B&W CMOS SXGA (1.3 MPixel) CAMERACHIP PDF资料下载
参数资料
| 型号： | OV09121-C00A |
| 厂商： | Electronic Theatre Controls, Inc. |
| 英文描述： | OV9625 Color CMOS SXGA (1.3 MPixel) CAMERACHIP OV9121 B&W CMOS SXGA (1.3 MPixel) CAMERACHIP |
| 中文描述： | OV9625彩色CMOS SXGA（1.3万像素）的CameraChip OV9121乙 |
| 文件页数： | 28/30页 |
| 文件大小： | 361K |
| 代理商： | OV09121-C00A |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页
Functional Description
Version 1.3, September 15, 2003
Proprietary to OmniVision Technologies
7
Omni
ision
Timing Generator
In general, the timing generator controls the following
functions:
Frame Exposure Mode Timing
Frame Rate Timing
Frame Rate Adjust
Frame Exposure Mode Timing
OV9625/OV9121
supports
frame
exposure
mode.
Typically the frame exposure mode must work with the aid
of an external shutter.
The frame exposure pin, FREX (pin 8) is the frame
exposure mode enable pin and EXPSTB (pin 12) serves
as the exposure start trigger for the sensor. There are two
ways to set Frame Exposure mode:
Control both FREX and EXPSTB pins - Frame
Exposure mode can be set by pulling both FREX and
EXPSTB pins high at the same time (see Figure 19).
Control FREX only and keep EXPSTB low - In this
case, the pre-charge time is tline and sensor
exposure time is the period after pre-charge until the
shutter closes (see Figure 18).
When the external master device asserts the FREX pin
high, the sensor array is quickly pre-charged and stays in
reset mode until the EXPSTB pin is pulled low by the
external master (sensor exposure time can be defined as
the period between EXPSTB low to shutter close). After
the FREX pin is pulled low, the video data stream is then
clocked to the output port in a line-by-line manner. After
completing one frame of data output, OV9625/OV9121
will output continuous live video data unless in single
frame transfer mode. Figure 18 and Figure 19 show the
detailed timing for this mode.
For frame exposure, register AEC (0x10) must be set to
0xFF and register GAIN (0x00) should be no larger than
0x10 (maximum 2x gain).
Frame Rate Timing
Default frame timing is illustrated in Figure 16 and
Figure 17. Refer to Table 2 for the actual pixel rate at
different frame rates.
Frame Rate Adjust
OV9625/OV9121 offers three methods of frame rate
adjustment.
1.
Clock prescaler (see “CLKRC” on page 20)
By changing the system clock divide ratio, the frame
rate and pixel rate will change together. This
method can be used for dividing the frame/pixel rate
by: 1/2, 1/3, 1/4 … 1/64 of the input clock rate.
2.
Line adjustment (see “COML” on page 24 and see
“FRARL” on page 25)
By adding dummy pixel timing in each line, the
frame rate can be changed while leaving the pixel
rate as is.
3.
Vertical sync adjustment
By adding dummy line periods to the vertical sync
period (see “ADDVSL” on page 25 and see
“ADDVSH” on page 25), the frame rate can be
altered while the pixel rate remains the same.
After changing registers COML (0x2A) and FRARL (0x2B)
to adjust the dummy pixels, it is necessary to write to
register COMH (0x12) or CLKRC (0x11) to reset the
counter. Generally, OmniVision suggests users write to
register COMH (0x12) (to change the sensor mode) as the
last one. However, if you want to adjust the cropping
window, it is necessary to write to those registers after
changing register COMH (0x12). To use COMH to reset
the counter, it is necessary to generate a pulse on
resolution control register bit COMH[6].
Table 2
Frame and Pixel Rates
Frame Rage (fps)
15
10
7.5
6
5
PCLK (MHz)
24
16
12
9.6
8
NOTE: Based on 24 MHz external clock and internal PLL
on, frame rate is adjusted by the main clock divide method.
相关PDF资料 |
PDF描述 |
|---|---|
| OV09625-C00A | OV9625 Color CMOS SXGA (1.3 MPixel) CAMERACHIP OV9121 B&W CMOS SXGA (1.3 MPixel) CAMERACHIP |
| OV1564C2/B32.768KHZ | CRYSTAL OSCILLATOR, CLOCK, 0.032768 MHz, CMOS OUTPUT |
| OV7141 | OV7640 Color CMOS VGA (640 x 480) CAMERACHIP OV7141 B&W CMOS VGA (640 x 480) CAMERACHIP |
| OV7604C7/A | CRYSTAL OSCILLATOR, CLOCK, 0.032768 MHz, HCMOS OUTPUT |
| OV7604C7/BM | CRYSTAL OSCILLATOR, CLOCK, 0.032768 MHz, HCMOS OUTPUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| OV09215-F48V | 制造商:OMNIVISION 制造商全称:OMNIVISION 功能描述:High-Performance Video for Automotive Vision Applications |
| OV09620-C00A | 制造商:Omnivision Technologies Inc 功能描述:1.3 MEGA PIXEL CAMERA CHIP |
| OV09625-C00A | 制造商:未知厂家 制造商全称:未知厂家 功能描述:OV9625 Color CMOS SXGA (1.3 MPixel) CAMERACHIP OV9121 B&W CMOS SXGA (1.3 MPixel) CAMERACHIP |
| OV09630-C00A | 制造商:Omnivision Technologies Inc 功能描述:1.3 MPIXEL CAMERA CHIP, 1/3"" |
| OV09655-ECJFAA1A-SR | 制造商:Omnivision Technologies Inc 功能描述:SXGA Camera Evaluation kit USB 2.0 |
发布紧急采购，3分钟左右您将得到回复。