参数资料
| 型号： | P89LPC901FD,112 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 27/53页 |
| 文件大小： | 0K |
| 描述： | IC 80C51 MCU FLASH 1K 8-SOIC |
| 产品培训模块： | Migrating from 8/16-Bit MCUs to 32-Bit ARMs |
| 标准包装： | 1 |
| 系列： | LPC900 |
| 核心处理器： | 8051 |
| 芯体尺寸： | 8-位 |
| 速度： | 18MHz |
| 外围设备： | 欠压检测/复位，LED，POR，PWM，WDT |
| 输入/输出数： | 6 |
| 程序存储器容量： | 1KB（1K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 128 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.4 V ~ 3.6 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 剪切带 (CT) |
| 配用： | 622-1009-ND - BOARD FOR LPC901 8-DIP 622-1008-ND - BOARD FOR LPC9103 10-HVSON 622-1006-ND - SOCKET ADAPTER BOARD 622-1002-ND - USB IN-CIRCUIT PROG LPC9XX 568-1759-ND - EMULATOR DEBUGGER/PROGRMMR LPC9X |
| 其它名称： | 568-1994-1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页
Philips Semiconductors
P89LPC901/902/903
8-bit microcontrollers with two-clock 80C51 core
Product data
Rev. 05 — 17 December 2004
33 of 53
9397 750 14465
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
8.14.1
Idle mode
Idle mode leaves peripherals running in order to allow them to activate the processor
when an interrupt is generated. Any enabled interrupt source or reset may terminate
Idle mode.
8.14.2
Power-down mode
The Power-down mode stops the oscillator in order to minimize power consumption.
The P89LPC901/902/903 exits Power-down mode via any reset, or certain interrupts.
In Power-down mode, the power supply voltage may be reduced to the RAM
keep-alive voltage VRAM. This retains the RAM contents at the point where
Power-down mode was entered. SFR contents are not guaranteed after VDD has
been lowered to VRAM, therefore it is highly recommended to wake up the processor
via reset in this case. VDD must be raised to within the operating range before the
Power-down mode is exited.
Some chip functions continue to operate and draw power during Power-down mode,
increasing the total power used during Power-down. These include: Brownout detect,
Watchdog Timer, Comparators (note that Comparators can be powered-down
separately), and Real-Time Clock (RTC)/System Timer. The internal RC oscillator is
disabled unless both the RC oscillator has been selected as the system clock and the
RTC is enabled.
8.14.3
Total Power-down mode
This is the same as Power-down mode except that the brownout detection circuitry
and the voltage comparators are also disabled to conserve additional power. The
internal RC oscillator is disabled unless both the RC oscillator has been selected as
the system clock and the RTC is enabled. If the internal RC oscillator is used to clock
the RTC during Power-down, there will be high power consumption. Please use an
external low frequency clock to achieve low power with the Real-Time Clock running
during Power-down.
8.15 Reset
The P1.5/RST pin can function as either an active-LOW reset input or as a digital
input, P1.5. The RPE (Reset Pin Enable) bit in UCFG1, when set to ‘1’, enables the
external reset input function on P1.5. When cleared, P1.5 may be used as an input
pin.
Remark: During a power-up sequence, the RPE selection is overridden and this pin
will always function as a reset input. An external circuit connected to this pin
should not hold this pin LOW during a power-on sequence as this will keep the
device in reset. After power-up this input will function either as an external reset
input or as a digital input as dened by the RPE bit. Only a power-up reset will
temporarily override the selection dened by RPE bit. Other sources of reset will not
override the RPE bit.
characteristics”) before power is reapplied, in order to ensure a power-on reset.
相关PDF资料 |
PDF描述 |
|---|---|
| DS80C320-ENL | IC MCU HI SPEED 33MHZ IND 44TQFP |
| DS80C323-END | IC MCU HI SPEED 18MHZ IND 44TQFP |
| DS80C320-ENG | IC MCU HI SPEED 25MHZ IND 44TQFP |
| DS89C450-ENG | IC MCU FLASH 64KB 25MHZ 44-TQFP |
| DS89C440-QNL | IC MCU FLASH 32KB 33MHZ 44-PLCC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| P89LPC901FN | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit microcontrollers with two-clock 80C51 core 1 kB 3 V Flash with 128-byte RAM |
| P89LPC901FN,129 | 功能描述:8位微控制器 -MCU 80C51 1K FL 128B RAM RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| P89LPC901FN.129 | 制造商:NXP Semiconductors 功能描述:8BIT MCU 1K FLASH 89LC901 DIP8 制造商:NXP Semiconductors 功能描述:8BIT MCU 1K FLASH, 89LC901, DIP8 |
| P89LPC901FN129 | 制造商:NXP Semiconductors 功能描述:IC 8BIT MCU 80C51 12MHZ DIP-8 |
| P89LPC902 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit microcontrollers with two-clock 80C51 core 1 kB 3 V Flash with 128-byte RAM |
发布紧急采购，3分钟左右您将得到回复。