- 您现在的位置：买卖IC网 > PDF目录378041 > PBL40215 (ERICSSON) RF Transceiver circuit for the Digital Enhanced Cordless Telecommunications (DECT) system PDF资料下载
参数资料
| 型号： | PBL40215 |
| 厂商： | ERICSSON |
| 英文描述： | RF Transceiver circuit for the Digital Enhanced Cordless Telecommunications (DECT) system |
| 中文描述： | RF收发器电路的数字增强无线电话（DECT）系统 |
| 文件页数： | 14/22页 |
| 文件大小： | 214K |
| 代理商： | PBL40215 |
14
PBL 402 15
Hard Wire Control Lines.
The 3 hardwire control lines EN, RXEN and TXEN allow control of the IC by a controller with limited interface access or capabili-
ties. Typically, controllers with only one access per slot or no access between slots.
For correct operation the 3 hard wire lines require appropriate programming of the CE and CL flags.
The hardwire lines directly force the state of the appropriate word B flags as detailed below.
×
2
-
φ
PLL
Modulator
÷
R
÷
2
IF
LO and Modulation Section.
The LO section consists of a TX VCO with a frequency doubler, a RX VCO and a charge pump PLL.
The VCO′s are fully integrated and are phase/frequency locked to an external reference frequency applied to the REF pin. The
frequency is programmed by the 3-wire interface. Lock detect is available on the LD pin. When neither TX_EN or RX_EN are active,
lock detect is also available at the DRX output.
The RX VCO runs at twice the frequency. The frequency of the RX VCO is divided by 2 for the PLL. The TX VCO runs at half the
TX frequency to improve pulling immunity to TX harmonics. A frequency doubler generates the TX LO for the PLL.
The TX VCO is modulated by an external signal applied to the DTX pin. The DTX input is permanently connected to the TXVCO.
An active MOD_EN signal disables the PLL charge pump output which allows modulation to be applied. A hardware modulation
enable signal may be applied to either the MOD pin or SHOLD pin depending upon setting of the MOD_SW flag.
Hard wire line
EN
Description
Powers the serial bus interface.
Upon the rising edge of ST and provided CL is set to 1, the effect is as SYN_EN.
Provided EN is active and CL is set to 1, the effect is as IF_EN and RX_EN.
RXEN
TXEN
Provided EN is active and CL is set to 1, the effect is as TX_EN.
相关PDF资料 |
PDF描述 |
|---|---|
| PBL40305 | Multiband GSM Power Amplifier |
| PBL40307 | GSM Dual Band Tx_VCO |
| PBL40309 | 3.6 V Differential Power Amplifier for DECT Telecommunications system |
| PBL40310 | 3.5 V GSM 900 MHz Power Amplifier |
| PBM39601NS | Microstepping Controller/Dual Digital-to-Analog Converter |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PBL403 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:4.0A BRIDGE RECTIFIER |
| PBL40305 | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:Multiband GSM Power Amplifier |
| PBL40307 | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:GSM Dual Band Tx_VCO |
| PBL40309 | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:3.6 V Differential Power Amplifier for DECT Telecommunications system |
| PBL40310 | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:3.5 V GSM 900 MHz Power Amplifier |
发布紧急采购，3分钟左右您将得到回复。