- 您现在的位置：买卖IC网 > Datasheet目录349 > PCA9553DP/01,118 (NXP Semiconductors)IC LED DRIVER LINEAR 8-TSSOP Datasheet资料下载
参数资料
| 型号： | PCA9553DP/01,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 9/26页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVER LINEAR 8-TSSOP |
| 产品培训模块： | LED Controllers I²C Bus Fundamentals |
| 标准包装： | 1 |
| 拓扑： | 开路漏极，PWM |
| 输出数： | 4 |
| 内部驱动器： | 是 |
| 类型 - 主要： | LED 闪烁器 |
| 频率： | 400kHz |
| 电源电压： | 2.3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 产品目录页面： | 844 (CN2011-ZH PDF) |
| 其它名称： | 568-3392-6 |
NXP Semiconductors
SDA
SCL
S
START condition
PCA9553
4-bit I 2 C-bus LED driver with programmable blink rates
SDA
SCL
P
STOP condition
mba608
Fig 9.
De?nition of START and STOP conditions
8.2 System con?guration
A device generating a message is a ‘transmitter’; a device receiving is the ‘receiver’. The
device that controls the message is the ‘master’ and the devices which are controlled by
the master are the ‘slaves’ (see Figure 10 ).
SDA
SCL
MASTER
TRANSMITTER/
RECEIVER
SLAVE
RECEIVER
SLAVE
TRANSMITTER/
RECEIVER
MASTER
TRANSMITTER
MASTER
TRANSMITTER/
RECEIVER
I 2 C-BUS
MULTIPLEXER
SLAVE
002aaa966
Fig 10. System con?guration
8.3 Acknowledge
The number of data bytes transferred between the START and the STOP conditions from
transmitter to receiver is not limited. Each byte of eight bits is followed by one
acknowledge bit. The acknowledge bit is a HIGH level put on the bus by the transmitter,
whereas the master generates an extra acknowledge related clock pulse.
A slave receiver which is addressed must generate an acknowledge after the reception of
each byte. Also a master must generate an acknowledge after the reception of each byte
that has been clocked out of the slave transmitter. The device that acknowledges has to
pull down the SDA line during the acknowledge clock pulse, so that the SDA line is stable
LOW during the HIGH period of the acknowledge related clock pulse; set-up time and hold
time must be taken into account.
A master receiver must signal an end of data to the transmitter by not generating an
acknowledge on the last byte that has been clocked out of the slave. In this event, the
transmitter must leave the data line HIGH to enable the master to generate a STOP
condition.
PCA9553_6
? NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 06 — 29 December 2008
9 of 26
相关PDF资料 |
PDF描述 |
|---|---|
| PCA9624PW,118 | IC LED DRIVER RGBA 24-TSSOP |
| PCA9625D/S911,518 | IC LED DRIVER RGBA 32-SOIC |
| PCA9626BS,518 | IC LED DRIVER RGBA 48HVQFN |
| PCA9632DP2,118 | IC LED DRIVER RGBA 10-TSSOP |
| PCA9633BS,118 | IC LED DRIVER RGBA 16-HVQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9553DP02 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:4-bit I2C LED driver with programmable blink rates |
| PCA9553TK | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:4-bit I2C-bus LED driver with programmable blink rates |
| PCA9553TK,118 | 功能描述:LED照明驱动器 4BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9553TK/02 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:4-bit I2C-bus LED driver with programmable blink rates |
| PCA9553TK/02,118 | 功能描述:LED照明驱动器 LED DRVR 4Segment 2.5V/3.3V/5V 8-Pin RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
发布紧急采购，3分钟左右您将得到回复。