参数资料
型号: PCF8563TD-T
厂商: NXP SEMICONDUCTORS
元件分类: XO, clock
英文描述: Real-time clock/calendar
中文描述: 0 TIMER(S), REAL TIME CLOCK, PDSO8
封装: 3.90 MM, PLASTIC, SO-8
文件页数: 27/32页
文件大小: 711K
代理商: PCF8563TD-T
Philips Semiconductors
PCF8563
Real-time clock/calendar
Product specication
16 April 1999
4 of 30
9397 750 04855
Philips Electronics N.V. 1999. All rights reserved.
8.
Functional description
The PCF8563 contains sixteen 8-bit registers with an auto-incrementing address
register, an on-chip 32.768 kHz oscillator with an integrated capacitor, a frequency
divider which provides the source clock for the Real-Time Clock (RTC), a
programmable clock output, a timer, an alarm, a voltage-low detector and a 400 kHz
I2C-bus interface.
All 16 registers are designed as addressable 8-bit parallel registers although not all
bits are implemented. The rst two registers (memory address 00H and 01H) are
used as control and/or status registers. The memory addresses 02H through 08H are
used as counters for the clock function (seconds up to year counters). Address
locations 09H through 0CH contain alarm registers which dene the conditions for an
alarm. Address 0DH controls the CLKOUT output frequency. 0EH and 0FH are the
timer control and timer registers, respectively.
The Seconds, Minutes, Hours, Days, Months, Years as well as the Minute alarm,
Hour alarm and Day alarm registers are all coded in BCD format. The Weekdays and
Weekday alarm register are not coded in BCD format.
When one of the RTC registers is read the contents of all counters are frozen.
Therefore, faulty reading of the clock/calendar during a carry condition is prevented.
8.1 Alarm function modes
By clearing the MSB (bit AE = Alarm Enable) of one or more of the alarm registers,
the corresponding alarm condition(s) will be active. In this way an alarm can be
generated from once per minute up to once per week. The alarm condition sets the
alarm ag, AF (bit 3 of Control/Status 2 register). The asserted AF can be used to
generate an interrupt (INT). Bit AF can only be cleared by software.
8.2 Timer
The 8-bit countdown timer (address 0FH) is controlled by the Timer Control register
(address 0EH; see Table 25). The Timer Control register selects one of 4 source
clock frequencies for the timer (4096, 64, 1, or 1
60 Hz), and enables/disables the
timer. The timer counts down from a software-loaded 8-bit binary value. At the end of
every countdown, the timer sets the timer ag TF (see Table 7). The timer ag TF can
only be cleared by software. The asserted timer ag TF can be used to generate an
interrupt (INT). The interrupt may be generated as a pulsed signal every countdown
period or as a permanently active signal which follows the condition of TF. TI/TP (see
Table 7) is used to control this mode selection. When reading the timer, the current
countdown value is returned.
8.3 CLKOUT output
A programmable square wave is available at the CLKOUT pin. Operation is controlled
by the CLKOUT frequency register (address 0DH; see Table 23). Frequencies of
32.768 kHz (default), 1024, 32 and 1 Hz can be generated for use as a system clock,
microcontroller clock, input to a charge pump, or for calibration of the oscillator.
CLKOUT is an open-drain output and enabled at power-on. If disabled it becomes
high-impedance.
相关PDF资料
PDF描述
PIC12C671T-10E 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter
PIC12C671T-10I 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter
PIC12C672 EPROM Memory Programming Specification
PIC12C672-10 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter
PIC12C672-10E 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter
相关代理商/技术参数
参数描述
PCF8563T-F4 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Real-time clock/calendar
PCF8563TF4.118 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Real-time clock/calendar
PCF8563TS 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Real-time clock/calendar
PCF8563TS/4 制造商:NXP Semiconductors 功能描述:RTC/Calender,1.8-5.5V,PCF8563TS/4
PCF8563TS/4,118 功能描述:实时时钟 ULTRA LOW PWR CLOCK CALENDAR RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube