- 您现在的位置：买卖IC网 > PDF目录3813 > PIC18F452-I/PT (Microchip Technology)IC MCU FLASH 16KX16 EE 44TQFP PDF资料下载
参数资料
| 型号： | PIC18F452-I/PT |
| 厂商： | Microchip Technology |
| 文件页数： | 57/134页 |
| 文件大小： | 0K |
| 描述： | IC MCU FLASH 16KX16 EE 44TQFP |
| 产品培训模块： | Asynchronous Stimulus 8-bit PIC® Microcontroller Portfolio |
| 标准包装： | 160 |
| 系列： | PIC® 18F |
| 核心处理器： | PIC |
| 芯体尺寸： | 8-位 |
| 速度： | 40MHz |
| 连通性： | I²C，SPI，UART/USART |
| 外围设备： | 欠压检测/复位，LVD，POR，PWM，WDT |
| 输入/输出数： | 34 |
| 程序存储器容量： | 32KB（16K x 16） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 256 x 8 |
| RAM 容量： | 1.5K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 4.2 V ~ 5.5 V |
| 数据转换器： | A/D 8x10b |
| 振荡器型： | 外部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 44-TQFP |
| 包装： | 托盘 |
| 配用： | XLT44PT3-ND - SOCKET TRAN ICE 44MQFP/TQFP AC164305-ND - MODULE SKT FOR PM3 44TQFP 444-1001-ND - DEMO BOARD FOR PICMICRO MCU AC164020-ND - MODULE SKT PROMATEII 44TQFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页当前第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页
Micrel, Inc.
KSZ8864RMN
April 2012
29
M9999-043012-1.5
The KSZ8864RMN will not forward the following packets:
1. Error Packets.
These include framing errors, Frame Check Sequence (FCS) errors, alignment errors, and illegal size packet errors.
2. IEEE802.3x PAUSE Frames.
KSZ8864RMN intercepts these packets and performs full duplex flow control accordingly.
3. "Local" Packets.
Based on destination address (DA) lookup, if the destination port from the lookup table matches the port from which
the packet originated, the packet is defined as "local."
Half-Duplex Back Pressure
The KSZ8864RMN also provides a half-duplex back pressure option (note: this is not listed in IEEE 802.3 standards). The
activation and deactivation conditions are the same as the ones given for full-duplex mode. If back pressure is required,
the KSZ8864RMN sends preambles to defer the other station's transmission (carrier sense deference). To avoid jabber
and excessive deference as defined in IEEE 802.3 standard, after a certain period of time, the KSZ8864RMN
discontinues carrier sense but raises it quickly after it drops packets to inhibit other transmissions. This short silent time
(no carrier sense) is to prevent other stations from sending out packets and keeps other stations in a carrier sense
deferred state. If the port has packets to send during a back pressure situation, the carrier-sense-type back pressure is
interrupted and those packets are transmitted instead. If there are no more packets to send, carrier-sense-type back
pressure becomes active again until switch resources are free. If a collision occurs, the binary exponential backoff
algorithm is skipped and carrier sense is generated immediately, reducing the chance of further colliding and maintaining
carrier sense to prevent reception of packets.To ensure no packet loss in 10BASE-T or 100BASE-TX half-duplex modes,
the user must enable the following:
Aggressive backoff (Register 3, bit 0)
No excessive collision drop (Register 4, bit 3)
Back pressure (Register 4, bit 5)
These bits are not set as the default because this is not the IEEE standard.
Broadcast Storm Protection
The KSZ8864RMN has an intelligent option to protect the switch system from receiving too many broadcast packets.
Broadcast packets are normally forwarded to all ports except the source port and thus use too many switch resources
(bandwidth and available space in transmit queues). The KSZ8864RMN has the option to include “multicast packets” for
storm control. The broadcast storm rate parameters are programmed globally and can be enabled or disabled on a per
port basis. The rate is based on a 50ms (0.05s) interval for 100BT and a 500ms (0.5s) interval for 10BT. At the beginning
of each interval, the counter is cleared to zeroand the rate limit mechanism starts to count the number of bytes during the
interval. The rate definition is described in Registers 6 and 7. The default setting for Registers 6 and 7 is 0x4A (74
decimal). This is equal to a rate of 1%, calculated as follows:
148,800 frames/sec X 50ms (0.05s)/interval X 1% = 74 frames/interval (approx.) = 0x4A.
MII Interface Operation
The media independent interface (MII) is specified by the IEEE 802.3 committee and provides a common interface
between physical layer and MAC layer devices. The KSZ8864RMN provides two MAC layer interfaces for MAC 3 and
MAC 4. Each of these MII/RMII interfaces contains two distinct groups of signals, one for transmission and the other for
receiving.
Switch MAC3/MAC4 SW3/SW4-MII Interface
Table 3 shows two connection manners,
1. The first is an external MAC connects to SW3/SW4-MII PHY mode.
2. The second is an external PHY connects to SW3/SW4-MII MAC mode.
相关PDF资料 |
PDF描述 |
|---|---|
| PIC18F6622-I/PT | IC PIC MCU FLASH 32KX16 64TQFP |
| 201828-1 | CONN JACKSCREW SHORT-SHORT FMALE |
| 608489070001049 | CONN CONTACT FOR 8483/8484 PLUGS |
| PIC18LF258-I/SO | IC MCU CAN FLASH 16K LP 28-SOIC |
| DSPIC33FJ256GP710-I/PT | IC DSPIC MCU/DSP 256K 100TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PIC18F452T-E/ML | 功能描述:8位微控制器 -MCU 40MHz 16KB Flash RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC18F452T-I/L | 功能描述:8位微控制器 -MCU 32KB 1536 RAM 34I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC18F452T-I/ML | 功能描述:8位微控制器 -MCU 32KB 1536 RAM 34I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC18F452T-I/PT | 功能描述:8位微控制器 -MCU 32KB 1536 RAM 34I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| PIC18F452T-I/PTG | 功能描述:8位微控制器 -MCU 32KB 1536 RAM 34I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。