参数资料
型号: PowerPC 750
厂商: IBM Microeletronics
英文描述: 32-Bit Embedded Microprocessor(32位精简指令集嵌入式微处理器)
中文描述: 32位嵌入式微处理器(32位精简指令集嵌入式微处理器)
文件页数: 17/46页
文件大小: 610K
代理商: POWERPC 750
9/30/99
Version 2.0
Datasheet
Page 13
PowerPC 750 SCM RISC Microprocessor
Preliminary Copy
PID8p-750
60x Bus Output AC Specifications
The following table provides the 60x bus output AC timing specifications for the PID8p-750 as defined in
Figure 5. Output timing specification for the L2 bus are provided in the Section “L2 Bus Output AC Specifica-
tions,” on page 18.
60X Bus Output AC Timing Specifications
1
See Table “Recommended Operating Conditions1,2,3,” on page 6 for operating conditions, C
L
= 50pF
2
Num
Characteristic
300, 333, 350, 366,
375, 400, 433, 450, 466, 500MHz
Unit
Notes
Minimum
Maximum
12
SYSCLK to Output Driven (Output Enable Time)
0.5
ns
8
13
SYSCLK to Output Valid (TS, ABB, ARTRY, DBB, and TBST)
4.5
ns
5
14
SYSCLK to all other Output Valid (all except TS, ABB, ARTRY,
DBB, and TBST)
5.0
ns
5
15
SYSCLK to Output Invalid (Output Hold)
1.0
ns
3, 8, 9
16
SYSCLK to Output High Impedance (all signals except ABB,
ARTRY, and DBB)
6.0
ns
8
17
SYSCLK to ABB and DBB high impedance after precharge
1.0
t
SYSCLK
4, 6, 8
18
SYSCLK to ARTRY high impedance before precharge
5.5
ns
8
19
SYSCLK to ARTRY precharge enable
0.2
×
t
SYSCLK
+ 1.0
ns
3, 4, 7
20
Maximum delay to ARTRY precharge
1
t
SYSCLK
4, 7
21
SYSCLK to ARTRY high impedance after precharge
2
t
SYSCLK
4, 7, 8
Note:
1. All output specifications are measured from the midpoint voltage of the rising edge of SYSCLK to the midpoint voltage of the signal in question. Both
input and output timings are measured at the pin. Midpoint voltage (VM) is 1.4v for OVdd in 3.3v mode and OVDD/2 for all other I/O modes.
2. All maximum timing specifications assume C
L
= 50pF.
3. This minimum parameter assumes CL = 0pF.
4. t
is the period of the external bus clock (SYSCLK) in nanoseconds (ns). The numbers given in the table must be multiplied by the period of
SYSCLK to compute the actual time duration of the parameter in question.
5. Output signal transitions from GND to 2.0V or OV
DD
to 0.8V.
6. Nominal precharge width for ABB and DBB is 0.5 t
SYSCLK
.
7. Nominal precharge width for ARTRY is 1.0 t
SYSCLK
.
8. Guaranteed by design and characterization, and not tested.
9. L2_TSTCLK should be tied to OV
DD
.
相关PDF资料
PDF描述
PP-MOD1V2 ISP INTERFACE MODULE
PP01002 GEHOERSCHUTZ OHRSTOEPSEL 250ST Inhalt pro Packung: 250 Stk.
PP0901SA Direct ProTek Replacement:PP0901SA
PP0901SB Direct ProTek Replacement:PP0901SB
PP1101SB Direct ProTek Replacement:PP1101SB
相关代理商/技术参数
参数描述
POWERPLUG15W 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:AC/DC POWER SUPPLY
POWERPLUG24W 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:AC/DC POWER SUPPLY
POWERPLUS 2C 2500MAH 制造商:Energizer Battery Company 功能描述:
POWERPLUS 2D 2500MAH 制造商:Energizer Battery Company 功能描述:
POWERPLUS 4AAA 850MAH 制造商:Energizer Battery Company 功能描述: