- 您现在的位置：买卖IC网 > PDF目录4507 > R1EX24128BTAS0A#S0 (Renesas Electronics America)IC EEPROM 128K 400KHZ 8TSSOP PDF资料下载
参数资料
| 型号： | R1EX24128BTAS0A#S0 |
| 厂商： | Renesas Electronics America |
| 文件页数： | 6/18页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 128K 400KHZ 8TSSOP |
| 标准包装： | 1 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 128K (16K x 8) |
| 速度： | 400kHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 标准包装 |
| 其它名称： | R1EX24128BTAS0A#S0DKR |
R1EX24128BSAS0A/R1EX24128BTAS0A
Pin Function
Serial Clock (SCL)
The SCL pin is used to control serial input/output data timing. The SCL input is used to positive edge clock data into
EEPROM device and negative edge clock data out of each device. Maximum clock rate is 400 kHz.
Serial Input/Output Data (SDA)
The SDA pin is bidirectional for serial data transfer. The SDA pin needs to be pulled up by resistor as that pin is open-
drain driven structure. Use proper resistor value for your system by considering V OL , I OL and the SDA pin capacitance.
Except for a start condition and a stop condition which will be discussed later, the SDA transition needs to be completed
during the SCL low period.
Data Validity (SDA data change timing waveform)
SCL
SDA
Data
change
Data
change
Note:
High-to-low and low-to-high change of SDA should be done during the SCL low period.
Device Address (A0, A1, A2)
Eight devices can be wired for one common data bus line as maximum. Device address pins are used to distinguish
each device and device address pins should be connected to V CC or V SS . When device address code provided from SDA
pin matches corresponding hard-wired device address pins A0 to A2, that one device can be activated.
Pin Connections for A0 to A2
Pin connection
Memory size
128k bit
Max connect number
8
A2
V CC /V SS * 1
A1
V CC /V SS * 1
A0
V CC /V SS * 1
Note
Note:
1. During floating, “V CC /V SS ” are fixed to V SS .
Write Protect (WP)
When the Write Protect pin (WP) is high, the write protection feature is enabled and operates as shown in the following
table. Also, acknowledgment "0" is outputted after inputting device address and memory address. After inputting write
data, acknowledgment "1" (NO ACK) is outputted.
When the WP is low, write operation for all memory arrays are allowed. The read operation is always activated
irrespective of the WP pin status.
Write Protect Area
Write protect area
WP pin status
V IH
V IL
R10DS0006EJ0100 Rev.1.00
Aug. 04, 2010
128k bit
Full (128k bit)
Normal read/write operation
Page 6 of 16
相关PDF资料 |
PDF描述 |
|---|---|
| RMA50DRSD-S288 | CONN EDGECARD 100POS .125 EXTEND |
| HSM36DSAI | CONN EDGECARD 72POS R/A .156 SLD |
| HMM36DSAI | CONN EDGECARD 72POS R/A .156 SLD |
| A3P600L-FGG144 | IC FPGA 1KB FLASH 600K 144-FBGA |
| RSC65DREN-S93 | CONN EDGECARD 130POS .100 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| R1EX24128BTAS0G | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Two-wire serial interface 128k EEPROM |
| R1EX24128BTAS0I | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Two-wire serial interface 128k EEPROM (16-kword × 8-bit) |
| R1EX24128BTAS0I#S0 | 制造商:Renesas Electronics Corporation 功能描述:SERIAL EEPROM 128K I2C,TSSOP(8), I-GRADE - Tape and Reel 制造商:Renesas Electronics Corporation 功能描述:IC EEPROM 128KBIT 400KHZ 8TSSOP |
| R1EX24256ASA00A | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Two-wire serial interface 256k EEPROM (32-kword × 8-bit) |
| R1EX24256ASA00I | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Two-wire serial interface 256k EEPROM (32-kword × 8-bit) |
发布紧急采购，3分钟左右您将得到回复。