参数资料
型号: SC101161DGMPVR2
厂商: FREESCALE SEMICONDUCTOR INC
元件分类: 微控制器/微处理器
英文描述: 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP112
封装: LQFP-112
文件页数: 15/142页
文件大小: 6464K
代理商: SC101161DGMPVR2
Device User Guide — 9S12DT128DGV2/D V02.15
111
Freescale Semiconductor
A.3 NVM, Flash and EEPROM
NOTE:
Unless otherwise noted the abbreviation NVM (Non Volatile Memory) is used for
both Flash and EEPROM.
A.3.1 NVM timing
The time base for all NVM program or erase operations is derived from the oscillator. A minimum
oscillator frequency fNVMOSC is required for performing program or erase operations. The NVM modules
do not have any means to monitor the frequency and will not prevent program or erase operation at
frequencies above or below the specified minimum. Attempting to program or erase the NVM modules at
a lower frequency a full program or erase transition is not assured.
The Flash and EEPROM program and erase operations are timed using a clock derived from the oscillator
using the FCLKDIV and ECLKDIV registers respectively. The frequency of this clock must be set within
the limits specified as fNVMOP.
The minimum program and erase times shown in (Table A-11) are calculated for maximum fNVMOP and
maximum fbus. The maximum times are calculated for minimum fNVMOP and a fbus of 2MHz.
A.3.1.1 Single Word Programming
The programming time for single word programming is dependant on the bus frequency as a well as on
the frequency fNVMOP and can be calculated according to the following formula.
A.3.1.2 Row Programming
This applies only to the Flash where up to 32 words in a row can be programmed consecutively by keeping
the command pipeline filled. The time to program a consecutive word can be calculated as:
The time to program a whole row is:
Row programming is more than 2 times faster than single word programming.
A.3.1.3 Sector Erase
Erasing a 512 byte Flash sector or a 4 byte EEPROM sector takes:
t
swpgm
9
1
f
NVMOP
---------------------
25
1
f
bus
----------
+
=
t
bwpgm
4
1
f
NVMOP
---------------------
9
1
f
bus
----------
+
=
t
brpgm
t
swpgm
31 t
bwpgm
+
=
相关PDF资料
PDF描述
SPAKMC332VFV16 32-BIT, 16 MHz, MICROCONTROLLER, PQFP144
SPAKMC332MFV20 32-BIT, 20 MHz, MICROCONTROLLER, PQFP144
SPAKMC332MFC20 32-BIT, 20 MHz, MICROCONTROLLER, PQFP132
SPAKMC332GMFV20 32-BIT, 20 MHz, MICROCONTROLLER, PQFP144
SPAKMC332GCFV20 32-BIT, 20 MHz, MICROCONTROLLER, PQFP144
相关代理商/技术参数
参数描述
SC101161DJ 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:nullDevice User Guide
SC101161DT 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:nullDevice User Guide
SC10-11CGKWA 制造商:KINGBRIGHT COMPANY LLC 功能描述:DISPLAY 570NM GRN 1DIG 1 TH 制造商:Kingbright Corporation 功能描述:DISPLAY 570NM GRN 1DIG 1 TH 制造商:Kingbright Corporation 功能描述:LED Displays & Accessories 1" SINGLE DIGIT GRN LED DISPLAY
SC10-11EWA 功能描述:LED 显示器和配件 Single Red 625nm Common Cathode RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube
SC10-11GWA 功能描述:LED 显示器和配件 Single Green 568nm Common Cathode RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube