参数资料
型号: SC16C550BIB48,128
厂商: NXP Semiconductors
文件页数: 5/48页
文件大小: 0K
描述: IC UART SINGLE W/FIFO 48-LQFP
标准包装: 2,000
特点: 可编程
通道数: 1,UART
FIFO's: 16 字节
电源电压: 2.5V,3.3V,5V
带自动流量控制功能:
带故障启动位检测功能:
带调制解调器控制功能:
带CMOS:
安装类型: 表面贴装
封装/外壳: 48-LQFP
供应商设备封装: 48-LQFP(7x7)
包装: 带卷 (TR)
其它名称: 935274388128
SC16C550BIB48-F
SC16C550BIB48-F-ND
SC16C550B_5
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 1 October 2008
13 of 48
NXP Semiconductors
SC16C550B
5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
6.4 Hardware/software and time-out interrupts
Following a reset, the transmitter interrupt is enabled, the SC16C550B will issue an
interrupt to indicate that the Transmit Holding Register is empty. This interrupt must be
serviced prior to continuing operations. The ISR register provides the current singular
highest priority interrupt only. Only after servicing the higher pending interrupt will the
lower priority be reected in the status register. Servicing the interrupt without
investigating further interrupt conditions can result in data errors.
When two interrupt conditions have the same priority, it is important to service these
interrupts correctly. Receive Data Ready and Receive Time-Out have the same interrupt
priority (when enabled by IER[0]). The receiver issues an interrupt after the number of
characters have reached the programmed trigger level. In this case, the SC16C550B
FIFO may hold more characters than the programmed trigger level. Following the removal
of a data byte, the user should re-check LSR[0] for additional characters. A Receive
Time-Out will not occur if the receive FIFO is empty. The time-out counter is reset at the
center of each stop bit received or each time the Receive Holding Register (RHR) is read.
The actual time-out value is 4 character time, including data information length, start bit,
parity bit, and the size of stop bit, that is, 1
×, 1.5×, or 2× bit times.
(1) RTS is de-asserted when the receiver receives the rst data bit of the sixteenth byte. The receive FIFO is full after nishing the
sixteenth byte.
(2) RTS is asserted again when there is at least one byte of space available and no incoming byte is in processing, or there is more
than one byte of space available.
(3) When the receive FIFO is full, the rst receive buffer register read re-asserts RTS.
Fig 9.
RTS functional timing waveforms, RX FIFO trigger level = 14 bytes
byte 14
byte 15
RX
RTS
IOR
Start
byte 18
Stop
Start
byte 16
Stop
002aaa051
RTS released after the
first data bit of byte 16
相关PDF资料
PDF描述
FT232HQ-REEL IC HS USB TO UART/FIFO 48QFN
FT232RQ-REEL IC USB FS SERIAL UART 32-QFN
SC16C550BIA44,512 IC UART SINGLE W/FIFO 44-PLCC
SC16C550BIA44,518 IC UART SINGLE W/FIFO 44-PLCC
SC16IS750IPW,128 IC UART I2C/SPI 24-TSSOP
相关代理商/技术参数
参数描述
SC16C550BIB48-S 功能描述:UART 接口集成电路 1CH. UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C550BIBS 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C550BIBS,128 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C550BIBS,151 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C550BIBS,157 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel