- 您现在的位置：买卖IC网 > PDF目录11813 > SC16C554IB64,128 (NXP Semiconductors)IC UART QUAD SOT314-2 PDF资料下载
参数资料
| 型号： | SC16C554IB64,128 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 55/55页 |
| 文件大小： | 0K |
| 描述： | IC UART QUAD SOT314-2 |
| 标准包装： | 1,500 |
| 通道数： | 4，QUART |
| FIFO's： | 16 字节 |
| 电源电压： | 2.5V，3.3V，5V |
| 带自动流量控制功能： | 是 |
| 带IrDA 编码器/解码器： | 是 |
| 带故障启动位检测功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 带CMOS： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-LQFP |
| 供应商设备封装： | 64-LQFP（10x10） |
| 包装： | 带卷 (TR) |
| 其它名称： | 935270074128 SC16C554IB64-T SC16C554IB64-T-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页当前第55页
Philips Semiconductors
SC16C554/554D
Quad UART with 16-byte FIFO and infrared (IrDA) encoder/decoder
Product data
Rev. 05 — 10 May 2004
9 of 55
9397 750 13132
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
5.2 Pin description
Table 2:
Pin description
Symbol
Pin
Type
Description
PLCC68 LQFP64 LQFP80
16/68
31
-
I
16/68 Interface type select (input with internal pull-up). This input
provides the 16 (Intel) or 68 (Motorola) bus interface type select. The
functions of IOR, IOW, INT A-INTD, and CSA-CSD are re-assigned
with the logical state of this pin. When this pin is a logic 1, the 16
mode interface (16C554) is selected. When this pin is a logic 0, the
68 mode interface (68C554) is selected. When this pin is a logic 0,
IOW is re-assigned to R/W, RESET is re-assigned to RESET, IOR is
not used, and INTA-INTD are connected in a wire-OR conguration.
The wire-OR outputs are connected internally to the open drain IRQ
signal output. This pin is not available on 64-pin packages which
operate in the 16 mode only.
A0
34
24
48
I
Address 0 select bit. Internal registers address selection in 16 and
68 modes.
A1
33
23
47
I
Address 1 select bit. Internal registers address selection in 16 and
68 modes.
A2
32
22
46
I
Address 2 select bit. Internal registers address selection in 16 and
68 modes.
A3, A4
20, 50
-
I
Address 3-4 select bits. When the 68 mode is selected, these pins
are used to address or select individual UARTs (providing CS is a
logic 0). In the 16 mode, these pins are re-assigned as chip selects,
see CSB and CSC.
CDA, CDB,
CDC, CDD
9, 27,
43, 61
64, 18,
31, 49
19, 42,
59, 2
I
Carrier Detect (Active-LOW). These inputs are associated with
individual UART channels A through D. A logic 0 on this pin indicates
that a carrier has been detected by the modem for that channel.
CS
16
-
I
Chip Select (Active-LOW). In the 68 mode, this pin functions as a
multiple channel chip enable. In this case, all four UARTs (A-D) are
enabled when the CS pin is a logic 0. An individual UART channel is
selected by the data contents of address bits A3-A4. when the
16 mode is selected (68-pin devices), this pin functions as CSA (see
denition under CSA, CSB).
CSA, CSB,
CSC, CSD
16, 20,
50, 54
7, 11,
38, 42
28, 33,
68, 73
I
Chip Select A, B, C, D (Active-LOW). This function is associated
with the 16 mode only, and for individual channels ‘A’ through ‘D’.
When in 16 mode, these pins enable data transfers between the user
CPU and the SC16C554/554D for the channel(s) addressed.
Individual UART sections (A, B, C, D) are addressed by providing a
logic 0 on the respective CSA-CSD pin. When the 68 mode is
selected, the functions of these pins are re-assigned. 68 mode
functions are described under their respective name/pin headings.
CTSA, CTSB,
CTSC, CTSD
11, 25,
45, 59
2, 16,
33, 47
23, 38,
63, 78
I
Clear to Send (Active-LOW). These inputs are associated with
individual UART channels A through D. A logic 0 on the CTS pin
indicates the modem or data set is ready to accept transmit data from
the SC16C554/554D. Status can be tested by reading MSR[4]. This
pin only affects the transmit or receive operations when Auto CTS
function is enabled via the Enhanced Feature Register EFR[7] for
hardware ow control operation.
相关PDF资料 |
PDF描述 |
|---|---|
| SC16C554IB64,151 | IC UART QUAD SOT314-2 |
| AT89C51RB2-RLRUL | IC 8051 MCU 16K FLASH 44-VQFP |
| VI-B7N-IW-F2 | CONVERTER MOD DC/DC 18.5V 100W |
| VI-B7N-IW-F1 | CONVERTER MOD DC/DC 18.5V 100W |
| VI-B7M-IX-F4 | CONVERTER MOD DC/DC 10V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SC16C554IB80 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Quad UART with 16-byte FIFO and infrared (IrDA) encoder/decoder |
| SC16C554IB80,528 | 功能描述:UART 接口集成电路 Quad UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C554IB80,551 | 功能描述:UART 接口集成电路 16C 2.5V-5V 4CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C554IB80,557 | 功能描述:UART 接口集成电路 16C 2.5V-5V 4CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C650A | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Universal Asynchronous Receiver/Transmitter (UART) with 32-byte FIFO and infrared (IrDA) encoder/decoder |
发布紧急采购，3分钟左右您将得到回复。