参数资料
型号: SC174MLTRT
厂商: Semtech
文件页数: 19/27页
文件大小: 0K
描述: IC REG BUCK SYNC ADJ 4A 10MLPD
产品培训模块: Power Supplies 101
标准包装: 1
系列: EcoSpeed®
类型: 降压(降压)
输出类型: 可调式
输出数: 1
输出电压: 0.75 V ~ 5.23 V
输入电压: 3 V ~ 5.5 V
频率 - 开关: 200kHz ~ 1MHz
电流 - 输出: 4A
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 10-VFDFN 裸露焊盘
包装: 标准包装
供应商设备封装: 10-MLPD(3x3)
其它名称: SC174MLDKR
SC174
Applications Information (continued)
The use of 1% feedback resistors may result in up to an
additional 1% error. If tighter DC accuracy is required, re-
sistors with lower tolerances should be used.
The output inductor value may change with current. This
will change the output ripple and therefore will have a
minor effect on the DC output voltage. The output ESR
also affects the output ripple and thus has a minor effect
on the DC output voltage.
Switching Frequency Variation
The switching frequency will vary depending on line and
load conditions. The line variations are a result of fixed
propagation delays in the on-time one-shot, as well as
unavoidable delays in the power FET switching. As V IN
increases, these factors make the actual DH on-time
slightly longer than the ideal on-time. The net effect is
that frequency tends to fall slightly with increasing input
voltage.
The switching frequency also varies with load current
as a result of the power losses in the MOSFETs and the
inductor. For a conventional PWM constant-frequency
converter, as load increases the duty cycle also increases
slightly to compensate for IR and switching losses in the
MOSFETs and inductor. A adaptive on-time converter
must also compensate for the same losses by increasing
the effective duty cycle (more time is spent drawing en-
ergy from V IN as losses increase). The on-time is essential-
ly constant for a given V OUT and V IN combination, to offset
the losses the off-time will tend to reduce slightly as load
increases. The net effect is that switching frequency in-
creases slightly with increasing load.
Switching Node Voltage Spike
Due to parasitic board inductance, the transient LX pin
voltage at the point of measurement may appear larger
than that which exists on silicon. With an input multilay-
er ceramic capacitor of 10uF placed less than 3mm away
from the PVIN pin, the device is designed and guaranteed
to tolerate the short transient voltages, of maximum
20ns duration, that will appear on the LX pin due to the
? 2010 Semtech Corporation
deadtime diode conduction, as long as the transient volt-
age on PVIN is less than 6.0V. The time duration of the
transient LX pin voltage is measured on the voltage por-
tion which is either over 6.0V for positive voltage spike
or under -1V for negative voltage spike. The LX voltage
is measured from the LX pin to the PGND pin by using a
probing loop which is as short as possible to minimize or
eliminate the switching noise pick up.
19
相关PDF资料
PDF描述
SC183CULTRT IC REG BUCK SYNC ADJ 2A 16MLPQ
SC185HULTRT IC REG BUCK SYNC 1.5V 4A 16MLPQ
SC186ULTRT IC REG BUCK SYNC ADJ 4A 16MLPQ
SC189LULTRT IC REG BUCK SYNC 1.8V 1.5A 6MLPD
SC190CIMLTRT IC REG BUCK SYNC ADJ 0.3A 10MLP
相关代理商/技术参数
参数描述
SC175F 制造商:LISTA 功能描述:SC Drawer, 6-1/16 Usable Ht, 440lb Cap. 制造商:Lista International Corp 功能描述:SC Drawer, 6-1/16 Usable Ht, 440lb Cap.
SC1766 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:BATTERY CHARGE CONTROLLER
SC1766CS08 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:BATTERY CHARGE CONTROLLER
SC1766CS14 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:BATTERY CHARGE CONTROLLER
SC177 制造商:TE Connectivity 功能描述:- Bulk