参数资料
| 型号： | SC4518HSETRT |
| 厂商： | Semtech |
| 文件页数： | 7/15页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK 2A 8-SOIC |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出数： | 1 |
| 输入电压： | 4.4 V ~ 24 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 600kHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-SO 裸露焊盘 |
| 产品目录页面： | 1358 (CN2011-ZH PDF) |
| 其它名称： | SC4518HSEDKR |
SC4518H
POWER MANAGEMENT
Application Information
General Overview
The SC4518H is a high frequency current mode buck
PWM regulator. It has an internal clock with fixed-
frequency. The SC4518H uses two feedback loops
(voltage loop and current loop) that control the duty cycle
of the internal power switch. The error amplifier functions
like that of the voltage mode controller. The output of
the error amplifier provides a switch current reference.
This technique effectively removes one of the double
poles in the output LC filter stage. With this, it is easier
to compensate a current mode converter for better
performance. A minimum 2.7V voltage is required to
saturate the NPN power switch when it is ON to reduce
its conduction loss.
Current Limit and Over Current Protection
The current sense amplifier in the SC4518H monitors
the switch current during each cycle. Overcurrent
protection (OCP) is triggered when the current limit
exceeds the upper limit of 2A, detected by a voltage on
COMP being greater than about 2V. When an OCP fault
is detected, the switch is turned off and the external
COMP capacitor is discharged at the rate of dv/dt = 3 μ A/
C comp . Once the COMP voltage has fallen below 250mV,
the part enters a normal startup cycle. C comp is the total
capacitance value attached to COMP. In the case of
sustained overcurrent or dead-short, the part will
continually cycle through the retry sequence as described
above, at a rate dependent on the value of Ccomp. During
start up, the voltage on COMP rises roughly at the rate of
dv/dt = 120 μ A/C comp . Therefore, the retry time for a
sustained overcurrent can be approximately calculated
Enable
Pulling and holding the EN pin below 0.4V activates the
shut down mode of the SC4518H which reduces the input
supply current to less than 150μA. During the shut down
mode, the switch is turned off. The SC4518H is turned
on if the EN pin is pulled high.
Oscillator
Its internal free running oscillator sets the PWM frequency
at 600kHz for the SC4518H without any external
components to program the frequency. An external clock
with a duty cycle from 20% to 80% connected to the
SYNC pin activates synchronous mode. The frequency
of the external clock can be from 750kHz to 1.2MHz.
UVLO
When the EN pin is pulled and held above 1.8V, the voltage
on Pin IN determines the operation of the SC4518H. As
VIN increases during power up, the internal circuit senses
VIN and keeps the power transistor off until VIN reaches
4.4V.
Load Current
The peak current I PEAK in the switch is internally limited.
For a specific application, the allowed load current I OMAX
will change if the input voltage drifts away from the original
design as given for continuous current mode:
as:
T retry
= C comp ?
2V
120uA
+ C comp ?
2 V
3 uA
I OMAX = 2 ?
V O ? (1 ? D )
2 ? L ? f s
Where:
Figure 1 shows the voltage on COMP during a sustained
overcurrent condition.
Figure 1. Voltage on COMP for Startup and OCP
fs = switching frequency,
Vo = output voltage and
D = duty ratio, V O /V I
V = input voltage.
I
Figure 2 shows the theoretical maximum load current
for the specific cases. In a real application, however, the
allowed maximum load current also depends on the layout
and the air cooling condition. Therefore, the maximum
load current may need to be derated according to the
thermal situation of the application.
? 2007 Semtech Corp.
7
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| SC4519HSETRT | IC REG BUCK 3A 8-SOIC |
| SC4524ASETRT | IC REG BUCK 2A 8SOIC |
| SC4524BSETRT | IC REG BUCK 2A 8SOIC |
| SC4524CSETRT | IC REG BUCK ADJ 2A 8SOIC |
| SC4524DSETRT | IC REG BUCK ADJ 2A 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SC4518ISTRT | 制造商:Semtech Corporation 功能描述:Conv DC-DC Single Step Down 3V to 16V 8-Pin SOIC T/R 制造商:Semtech Corporation 功能描述:IC 1.5 AMP STP DWN SWTCH REG 制造商:Semtech Corporation 功能描述:Voltage Regulator IC Leaded Process Comp 制造商:Semtech Corporation 功能描述:SC Series 3 to 16 V 600 kHz SMT Step-Down Switching Regulator - SOIC-8LEDP |
| SC4519 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:600kHz, 3A Step-Down Switching Regulator |
| SC4519ASETRT | 制造商:Semtech Corporation 功能描述: |
| SC4519H | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:600kHz, 3A Step-Down Switching Regulator |
| SC4519H_07 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:600kHz, 3A Step-Down Switching Regulator |
发布紧急采购，3分钟左右您将得到回复。