- 您现在的位置：买卖IC网 > PDF目录18722 > SI1000DK (Silicon Laboratories Inc)DEVELOPMENT KIT SI101X PDF资料下载
参数资料
| 型号： | SI1000DK |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 17/26页 |
| 文件大小： | 0K |
| 描述： | DEVELOPMENT KIT SI101X |
| 应用说明： | SI1000 Code Examples AppNote |
| 视频文件： | Wireless MCU in a Metering M-Bus Application |
| 特色产品： | Si100x/1x Wireless MCUs with Integrated Sub-GHz RF Transceivers |
| 标准包装： | 1 |
| 类型： | 开发套件 |
| 频率： | 240MHz ~ 960MHz |
| 适用于相关产品： | Si100x |
| 已供物品： | 板，天线，线缆，电源，软件 |
| 产品目录页面： | 626 (CN2011-ZH PDF) |
| 其它名称： | 336-1880 |
Si10xx-DK
10.5. Switches and LEDs
Three push-button switches are provided on the target board. Switch SW1 is connected to the reset pin of the
MCU. Pressing SW1 puts the device into its hardware-reset state. Switches SW2 and SW3 are connected to the
MCU’s general purpose I/O (GPIO) pins through headers. Pressing SW2 or SW3 generates a logic low signal on
the port pin. Remove the shorting block from the header (J8) to disconnect the switches from the port pins. The
port pin signal is also routed to pins on the J2 and P1 I/O connectors. See Table 1 for the port pins and headers
corresponding to each switch.
Two touch sensitive (contactless) switches are provided on the target board. The operation of these switches
require appropriate firmware running on the Si10xx MCU that can sense the state of the switch.
Five power LEDs are provided on the target board to serve as indicators. Each of the two regulators has a red LED
used to indicate the presence of power at the output of the regulator. A red USB Power LED turns on when a USB
cable is plugged into the USB connector P3. One power LED is also added to each of the two primary supply nets
powering the MCU (VDD/DC+ and VBAT). The LEDs connected to the supply nets may be disabled by removing
the shorting blocks from J1 and J5.
Two LEDs are connected to GPIO pins P1.5 and P1.6 for use by application software. See Table 1 for the port pins
and headers corresponding to each LED.
A potentiometer (R15) is also provided on the target board for generating analog signals. Place a shorting block on
J16 to connect the wiper to P0.6/CNVSTR. The header J15 allows the negative terminal of the potentiometer to be
tied to GND or to P2.7. When tied to GND, the potentiometer is always enabled and will draw a measurable
amount of supply current. When tied to P2.7, it only draws current when P2.7 is driving a logic 0 and draws no
current when P2.7 is driving a logic 1.
Table 1. Target Board I/O Descriptions
Description
SW1
SW2
SW3
P0.6 (Touch Sense Switch)
Red LED (P1.5)
Yellow LED (P1.6)
Red LED (VDD/DC+)
Red LED (VBAT)
Red LED (USB Power)
Red LED (+1 VD Power)
Red LED (+3 VD Power)
Potentiometer (R15)
I/O
Reset
P0.2
P0.3
P0.6
P1.5
P1.6
VDD/DC+ Supply Net
VBAT Supply Net
USB VBUS
+1 VD Regulator Output
+3 VD Regulator Output
P0.6/P2.7
Rev. 0.1
Header(s)
none
J8[5–6]
J8[7–8]
none
J8[1–2]
J8[3–4]
J5
J1
none
none
none
J15, J16
17
相关PDF资料 |
PDF描述 |
|---|---|
| 7020-01038-0 | TRANSFORMER CURRENT 100A |
| 7020-01036-0 | TRANSFORMER CURRENT 50A |
| TC25M3C32K7680 | OSCILLATOR 32.7680 KHZ 1.8V SMD |
| TC25L3C32K7680 | OSCILLATOR 32.7680 KHZ 3.3V SMD |
| CGH40120F-TB | BOARD DEMO AMP CIRCUIT CGH40120 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| Si1000-E-GM | 功能描述:射频微控制器 - MCU 64kB 4kB RAM +20 dBm progrmble XCVR QFN42 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:Si100x 数据总线宽度:8 bit 最大时钟频率:24 MHz 程序存储器大小:64 KB 数据 RAM 大小:4 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LGA-42 安装风格:SMD/SMT 封装:Tube |
| Si1000-E-GM2 | 制造商:Silicon Laboratories Inc 功能描述:64KB, 4KB RAM, +20 DBM, PROGRAMMABLE XCVR, QFN42 - Rail/Tube 制造商:Silicon Laboratories Inc 功能描述:64KB 4KB RAM 20DB XCVR QFN42 制造商:Silicon Laboratories Inc 功能描述:RF Microcontrollers - MCU 64kB, 4kB RAM +20 dBm |
| SI1000-E-GM2R | 制造商:Silicon Laboratories Inc 功能描述:64KB, 4KB RAM, +20 DBM, PROGRA 制造商:Silicon Laboratories Inc 功能描述:64KB, 4KB RAM, +20 DBM, PROGRAMMABLE XCVR - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC MCU 64KB FLASH EZ PRO 42LGA |
| SI1000-E-GMR | 制造商:Silicon Laboratories Inc 功能描述:64KB, 4KB RAM, +20 DBM, PROGRAMMABLE XCVR, QFN42 - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:MCU 64KB FLASH EXRADIO PRO 42LGA 制造商:Silicon Laboratories Inc 功能描述:64kB 4kB RAM +20 dBm progrmble XCVR QFN42 制造商:Silicon Laboratories 功能描述:SI1000-E-GMR |
| SI1000-ESA2-GM | 制造商:Silicon Laboratories Inc 功能描述:MCU 915MHZ SNAP ENABLED 42QFN |
发布紧急采购，3分钟左右您将得到回复。