- 您现在的位置：买卖IC网 > PDF目录10909 > SI3018-F-FS (Silicon Laboratories Inc)IC ISOMODEM LINE-SIDE DAA 16SOIC PDF资料下载
参数资料
| 型号： | SI3018-F-FS |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 19/94页 |
| 文件大小： | 0K |
| 描述： | IC ISOMODEM LINE-SIDE DAA 16SOIC |
| 标准包装： | 48 |
| 系列： | ISOmodem® |
| 数据格式： | V.92 |
| 电源电压： | 3 V ~ 3.6 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC N |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页
Si3056
Si3018/19/10
26
Rev. 1.05
These registers can help determine the following:
When on-hook, detect if a line is connected.
When on-hook, detect if a parallel phone is off-hook.
When off-hook, detect if a parallel phone goes on or
off-hook.
Detect if enough loop current is available to operate.
When used in conjunction with the OPD bit, detect if
an overcurrent condition exists. (See "5.22.Overload
5.8.1. Line Voltage Measurement
The Si3056 device reports line voltage with the LVS[7:0]
bits (Register 29) in both on- and off-hook states with a
resolution of 1 V per bit. The accuracy of these bits is
approximately ±10%. Bits 0 through 6 of this register
indicate the value of the line voltage in 2s compliment
format. Bit 7 of this register indicates the polarity of the
tip/ring voltage.
If the INTE bit (Register 2) and the POLM bit (Register
3) are set, a hardware interrupt is generated on the
AOUT/INT pin when bit 7 of the LVS register changes
state. The edge-triggered interrupt is cleared by writing
0 to the POLI bit (Register 4). The POLI bit is set each
time bit 7 of the LVS register changes state and must be
written to 0 to clear it.
The default state of the LVS register forces the LVS bits
to 0 when the line voltage is 3 V or less. The LVFD bit
(Register 31, bit 0) disables the force-to-zero function
and allows the LVS register to display non-zero values
of 3 V and below. This register might display
unpredictable values at line voltages between 0 to 2 V.
At 0 V, the LVS register displays all 0s.
5.8.2. Loop Current Measurement
When the Si3056 is off-hook, the LCS2[7:0] and
LCS[4:0] bits measure loop current in 1.1 mA/bit and
3.3 mA/bit resolution respectively. These bits enable
detection of another phone going off-hook by monitoring
the dc loop current. The LCS bits are decoded from
LCS2; so, both are available at the same time. The line
current sense transfer function is shown in Figure 19
and detailed in Table 16. The LCS and LCS2 bits report
loop current down to the minimum operating loop
current for the DAA. Below this threshold, the reported
value of loop current is unpredictable.
5.9. Off-Hook
The communication system generates an off-hook
command by applying a logic 0 to the OFHK pin or by
setting the OH bit (Register 5, bit 0).The OFHK pin must
be enabled by setting the OHE bit (Register 5, bit 1).
The polarity of the OFHK pin is selected by the OPOL
bit (Register 5, bit 4). With OFHK asserted, the system
is in an off-hook state.
The off-hook state seizes the line for incoming/outgoing
calls and also can be used for pulse dialing. With OFHK
deasserted, negligible dc current flows through the
hookswitch. When the OFHK pin is asserted, the
hookswitch transistor pair, Q1 and Q2, turn on. This
applies a termination impedance across TIP and RING
and causes dc loop current to flow. The termination
impedance has an ac and dc component.
Figure 19. Typical Loop Current LCS Transfer Function
Table 16. Loop Current Transfer Function
LCS[4:0]
Condition
00000
Insufficient
line
current
for
normal
operation. Use the DOD bit (Register 19,
bit 1) to determine if a line is connected.
00100
Minimum line current for normal operation.
11111
Loop current is greater than 127 mA. An
overcurrent situation may exist.
0
3.3
6.6
9.9 13.2 16.5 19.8 23.1 26.4
33
36.3 39.6 42.9 46.2 49.5 52.8 56.1 59.1 62.7 66
69.3 72.6 75.9 79.2
127
82.5 85.8 89.1 92.4 95.7 99 102.3
Loop Current (mA)
LCS
BITS
29.7
0
5
10
15
20
25
30
Possible Overload
相关PDF资料 |
PDF描述 |
|---|---|
| SI3050-E1-GT | IC VOICE DAA SYSTEM SIDE 24QFN |
| VE-2NM-IX-F4 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NM-IX-F3 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NM-IX-F2 | CONVERTER MOD DC/DC 10V 75W |
| VE-2NM-IX-F1 | CONVERTER MOD DC/DC 10V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI3018-F-FSR | 制造商:Silicon Laboratories Inc 功能描述:Voice DAA Chipset 16-Pin SOIC T/R 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET 56KBPS 16SOIC - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET 0.56KBPS 16-PIN SOIC 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM LINE-SIDE DAA 16SOIC |
| SI3018-F-FS-R | 功能描述:电信线路管理 IC Si2457 ISOmodem Line-Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| Si3018-F-FT | 功能描述:电信线路管理 IC Si3050 Global Voice DAA Line-Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| SI3018-F-FTR | 制造商:Silicon Laboratories Inc 功能描述:SI3050 GLOBAL VOICE DAA LINE-SIDE - LEAD-FREE - Tape and Reel |
| SI3018-F-GM | 制造商:SILABS 制造商全称:SILABS 功能描述:PROGRAMMABLE VOICE DAA SOLUTIONS |
发布紧急采购，3分钟左右您将得到回复。