参数资料
型号: SI3018-F-FS
厂商: Silicon Laboratories Inc
文件页数: 29/94页
文件大小: 0K
描述: IC ISOMODEM LINE-SIDE DAA 16SOIC
标准包装: 48
系列: ISOmodem®
数据格式: V.92
电源电压: 3 V ~ 3.6 V
安装类型: 表面贴装
封装/外壳: 16-SOIC(0.154",3.90mm 宽)
供应商设备封装: 16-SOIC N
包装: 管件
Si3056
Si3018/19/10
Rev. 1.05
35
5.22. Overload Detection
The Si3056 can be programmed to detect an overload
condition that exceeds the normal operating power
range of the DAA circuit. To use the overload detection
feature, the following steps should be followed:
1. Set the OH bit (Register 5, bit 0) to go off-hook, and
wait 25 ms to allow line transients to settle.
2. Enable overload detection by then setting the OPE
bit high (Register 17, bit 3).
If the DAA then senses an overload situation, it
automatically presents an 800
impedance to the line
to reduce the hookswitch current. At this time, the DAA
also sets the OPD bit (Register 19, bit 0) to indicate that
an overload condition exists. The line current detector
within the DAA has a threshold that is dependant upon
the ILIM bit (Register 26). When ILIM = 0, the overload
detection threshold equals 160 mA. When ILIM = 1, the
overload detection threshold equals 60 mA. The OPE
bit should always be cleared before going off-hook.
5.23. Gain Control
The Si3056 supports different gain and attenuation
settings depending on the line-side device being used.
For both devices, gains of 0, 3, 6, 9, and 12 dB can be
selected for the receive path with the ARX[2:0] bits. The
receive path can also be muted with the RXM bit.
Attenuations of 0, 3, 6, 9, and 12 dB can also be
selected for the transmit path with the ATX[2:0] bits. The
transmit path also can be muted with the TXM bit
(Register 15).
When using the Si3019 line-side device, the Si3056
provides even more flexible gain and attenuation
settings. The TXG2 and RXG2 bits (registers 38–39)
enable gain or attenuation in 1 dB increments up to
15 dB for the transmit and receive paths. The TGA2 and
RGA2 bits select either gain or attenuation for these
registers. The TXG3 and RXG3 bits (registers 40–41)
enable gain or attenuation in 0.1 dB increments up to
1.5 dB for the transmit and receive paths. The TGA3
and RGA3 bits select either gain or attenuation for these
registers. These additional gain/attenuation registers
are active only when the ARX[2:0] and ATX[2:0] bits are
set to all 0s.
Figure 24. Line-Side Device Signal Flow Diagram
Figure 25. Si3056 Signal Flow Diagram
To
Si3056
ADC
DAC
Link
Analog
Hybrid
ACT
TX
CO
Digital
Hybrid
IIRE
Digital
Filter
TXG2
To
Line-side
Device
Link
TXG3
TXA3
SDI
SDO
1 dB
Gain
Steps
0.1 dB
Gain/ATT
Steps
TXA2
1 dB
Attenuation
Steps
RXA2
1 dB
Attenuation
Steps
Digital
IIRE
Filter
RXG3
0.1 dB
Gain/ATT
Steps
RXA3
1 dB
Gain
Steps
RXG2
相关PDF资料
PDF描述
SI3050-E1-GT IC VOICE DAA SYSTEM SIDE 24QFN
VE-2NM-IX-F4 CONVERTER MOD DC/DC 10V 75W
VE-2NM-IX-F3 CONVERTER MOD DC/DC 10V 75W
VE-2NM-IX-F2 CONVERTER MOD DC/DC 10V 75W
VE-2NM-IX-F1 CONVERTER MOD DC/DC 10V 75W
相关代理商/技术参数
参数描述
SI3018-F-FSR 制造商:Silicon Laboratories Inc 功能描述:Voice DAA Chipset 16-Pin SOIC T/R 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET 56KBPS 16SOIC - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET 0.56KBPS 16-PIN SOIC 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM LINE-SIDE DAA 16SOIC
SI3018-F-FS-R 功能描述:电信线路管理 IC Si2457 ISOmodem Line-Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray
Si3018-F-FT 功能描述:电信线路管理 IC Si3050 Global Voice DAA Line-Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray
SI3018-F-FTR 制造商:Silicon Laboratories Inc 功能描述:SI3050 GLOBAL VOICE DAA LINE-SIDE - LEAD-FREE - Tape and Reel
SI3018-F-GM 制造商:SILABS 制造商全称:SILABS 功能描述:PROGRAMMABLE VOICE DAA SOLUTIONS