参数资料
型号: SI3452C-B01-GM
厂商: Silicon Laboratories Inc
文件页数: 11/36页
文件大小: 0K
描述: IC POE CONTROLLER MIDSPAN 40QFN
特色产品: Si3452 Quad High-Voltage Port Controller for PoE and PoE+PSEs
标准包装: 50
控制器类型: 以太网供电控制器(POE)
接口: I²C
电源电压: 3 V ~ 3.6 V
电流 - 电源: 14mA
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 40-VFQFN 裸露焊盘
供应商设备封装: 40-QFN(6x6)
包装: 管件
配用: SMARTPSE24-KIT-ND - KIT EVAL REF 24PORT SPI/UART
SI3480MS8-KIT-ND - KIT EVAL 8PORT SI3480/52/SI3500
其它名称: 336-1834-5
Si3452
Rev. 1.3
19
5.5. Command and Return Registers (Registers 0x12–0x1C)
The global command register enables manual port turn-on or turn-off, chip reset, port reset, and measurement of
port current and VEE. Register 0x12 is a Write only register. See Table 24 on page 24 for a list of all available
commands.
If the command results in a numerical return value, that value is stored in the measurement registers, which are
read-only. Each of the five possible measurements results in a 2 byte return value, and that value is stored in a
unique register. VEE is encoded in mV units; so, the full scale is 65.535 V. Iport is encoded in 100 A units; so, the
full scale is 6.5535 A.
The output data is updated by the proper command register write operation (see Table 23). This means that the
numerical value of the port current or VEE voltage in the measurement register will be the value at the time the
command was issued. If the port turns off due to an overload or disconnect, the port current register contents will
not be set to zero. If a command to read port current is issued and the port is off, the return value will be zero.
5.6. Device Status Register (0x1D)
The device event bits are listed in Table 18.
The Device status register is RO. The VEE, UVLO, and overtemp bits reflect the device status. They are set if VEE
or temperature is out of range and reset if the VEE or temperature is in range. Bit 6 of the Interrupt register is set if
there is a change in the overtemp status (bit 6 of 0x1D), and bit 5 of the Interrupt register is set if there is a change
in the VEE UVLO status (bit 5 of 0x1D). Reading register 0x1D clears these bits of the Interrupt register but does
not clear the device status register.
In addition, bit B0 indicates whether or not detection back-off is used. For PSEs that are wired as Alternative B
(power on the spare pair–typically used for midspans), the time between detection pulses is increased to slightly
over two seconds to avoid interference with Alternative A (power on the data pair–typically used for endpoints). Bit
B0 can be toggled using the 0x10 command code.
Table 18. Device Status Bits
Bit
Description
B6—OverTemp
The Si3452 has per-port thermal shutdown sensors as well a global thermal shutdown
at a slightly higher temperature. The global thermal shutdown bit of the device event
register is set if this occurs.
B5—VEE UVLO
VEE UVLO. The part is put in its reset state if VEE is not in a valid range.
相关PDF资料
PDF描述
V300C48M75BG CONVERTER MOD DC/DC 48V 75W
W2L1ZC473KAT1S CAP CER 0.047UF 10V 10% X7R 0508
V300C48M75BF2 CONVERTER MOD DC/DC 48V 75W
VE-213-IX-S CONVERTER MOD DC/DC 24V 75W
VE-21N-IX-S CONVERTER MOD DC/DC 18.5V 75W
相关代理商/技术参数
参数描述
SI3452C-B01-GMR 功能描述:热插拔功率分布 Quad PoE+ PSE Port Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
SI3452C-B02-GM 制造商:Silicon Laboratories Inc 功能描述:QUAD POE+ PSE PORT CONTROLLER (AUTO, ENDPOINT, DV/DT DISCONN - Rail/Tube 制造商:Silicon Laboratories Inc 功能描述:IC POE PSE PORT CTLR QUAD 40QFN
SI3452C-B02-GMR 制造商:Silicon Laboratories Inc 功能描述:QUAD POE+ PSE PORT CONTROLLER (AUTO, ENDPOINT, DV/DT DISCONN - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC POE PSE PORT CTLR QUAD 40QFN
Si3452D-B01-GM 功能描述:热插拔功率分布 Quad PoE+ PSE Port Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
SI3452D-B01-GMR 功能描述:热插拔功率分布 Quad PoE+ PSE Port Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube