- 您现在的位置：买卖IC网 > Datasheet目录57 > SI4021-A1-FT (Silicon Laboratories Inc)IC TX FSK 915MHZ 5.4V 16-TSSOP Datasheet资料下载
参数资料
| 型号： | SI4021-A1-FT |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 25/34页 |
| 文件大小： | 783K |
| 描述： | IC TX FSK 915MHZ 5.4V 16-TSSOP |
| 标准包装： | 96 |
| 频率： | 433MHz，868MHz，915MHz |
| 调制或协议： | FSK，OOK |
| 数据传输率 - 最大： | 512kbps |
| 功率 - 输出： | 8dBm |
| 电流 - 传输： | 24mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 电源电压： | 2.2 V ~ 5.4 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 585 (CN2011-ZH PDF) |
| 其它名称： | 336-1622-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
Si4021
25
RESET MODES
The chip will enter into reset mode if any of the following conditions are met:
? Power-on reset: During a power up sequence until the Vdd has reached the correct level and stabilized
? Power glitch reset: Transients present on the V
dd
line
? Software reset: Special control command received by the chip
Power-on reset
After power up the supply voltage starts to rise from 0V. The reset block has an internal ramping voltage reference (reset-ramp signal), which
is rising at 100mV/ms (typical) rate. The chip remains in reset state while the voltage difference between the actual Vdd and the internal
reset-ramp signal is higher than the reset threshold voltage, which is 600 mV (typical). As long as the Vdd voltage is less than 1.6V (typical)
the chip stays in reset mode regardless the voltage difference between the Vdd and the internal ramp signal.
The reset event can last up to 150ms supposing that the V
dd
reaches 90% its final value within 1ms. During this period the chip does not
accept control commands via the serial control interface.
Power-on reset example:
Power glitch reset
The internal reset block has two basic mode of operation: normal and sensitive reset. The default mode is sensitive, which can be changed
by the appropriate control command (see Related control commands at the end of this section). In normal mode the power glitch detection
circuit is disabled.
There can be spikes or glitches on the V
dd
line if the supply filtering is not satisfactory or the internal resistance of the power supply is too
high. In such cases if the sensitive reset is enabled an (unwanted) reset will be generated if the positive going edge of the V
dd
has a rising
rate greater than 100mV/ms and the voltage difference between the internal ramp signal and the V
dd
reaches the reset threshold voltage
(600 mV). Typical case when the battery is weak and due to its increased internal resistance a sudden decrease of the current consumption
(for example turning off the power amplifier) might lead to an increase in supply voltage. If for some reason the sensitive reset cannot be
disabled step-by-step decrease of the current consumption (by turning off the different stages one by one) can help to avoid this problem.
Any negative change in the supply voltage will not cause reset event unless the Vdd level reaches the reset threshold voltage (250mV in
normal mode, 1.6V in sensitive reset mode).
If the sensitive mode is disabled and the power supply turned off the Vdd must drop below 250mV in order to trigger a power-on reset event
when the supply voltage is turned back on. If the decoupling capacitors keep their charges for a long time it could happen that no reset will
be generated upon power-up because the power glitch detector circuit is disabled.
Note that the reset event reinitializes the internal registers, so the sensitive mode will be enabled again.
相关PDF资料 |
PDF描述 |
|---|---|
| SI4022-A0-FT | IC TX FSK UNI 868/915MHZ 16TSSOP |
| SI4711-B30-GM | IC TX FM RADIO 76-108MHZ 20UQFN |
| SI4713-B30-GMR | IC TX FM RADIO RPS/RDS 20UQFN |
| SKY12146-321LF | IC VAR VOLT ATTEN 12QFN |
| SN171GG-NR | SNAP PROTOBOARD W/NO RADIO |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI4021-A1-FTR | 功能描述:射频发射器 Transmitter EZRadio RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel |
| SI-40222 | 制造商:BEL 制造商全称:Bel Fuse Inc. 功能描述:SI-40222 |
| SI-40223 | 制造商:BEL 制造商全称:Bel Fuse Inc. 功能描述:SI-40223 |
| SI-40227 | 制造商:BEL 制造商全称:Bel Fuse Inc. 功能描述:SI-40227 |
| SI-40228 | 制造商:Bel Fuse 功能描述:CONN RJ-45 RCP 32 POS 2.54MM SLDR RA TH 48TERM 4PORT - Trays |
发布紧急采购，3分钟左右您将得到回复。