- 您现在的位置：买卖IC网 > PDF目录18722 > SI4133-EVB (Silicon Laboratories Inc)BOARD EVALUATION FOR SI4133 PDF资料下载
参数资料
| 型号： | SI4133-EVB |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 9/36页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION FOR SI4133 |
| 标准包装： | 1 |
| 类型： | 频率合成器 |
| 频率： | 900MHz ~ 1.8GHz，750MHz ~ 1.5GHz |
| 适用于相关产品： | SI4133 |
| 已供物品： | 板，CD |
| 产品目录页面： | 585 (CN2011-ZH PDF) |
| 其它名称： | 336-1557 SI4133-EVB-ND |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
Si4133
Rev. 1.61
17
Figure 15. External Inductance Connection
As a design example, consider that the goal is to
synthesize frequencies in a 25 MHz band between
1120 and 1145 MHz using the Si4133-GT. The center
frequency should be defined as midway between the
two extremes, or 1132.5 MHz. The PLL can adjust the
VCO output frequency ±5% of the center frequency, or
±56.6 MHz of 1132.5 MHz (i.e., from approximately
1076 to 1189 MHz). The RF2 VCO has a CNOM of
4.8 pF. A 4.1 nH inductance in parallel with this
capacitance yields the required center frequency. An
external inductance of 1.8 nH should be connected
between RFLC and RFLD as shown in Figure 15. This,
in addition to 2.3 nH of package inductance, presents
the
correct
total
inductance
to
the
VCO.
In
manufacturing, the external inductance can vary ±10%
of its nominal value and the Si4133 corrects for the
variation with the self-tuning algorithm.
For more information on designing the external trace
inductors, refer to Application Note 31: Inductor Design
for the Si41xx Synthesizer Family.
3.3. Extended Frequency Operation
The Si4133 may operate at an extended frequency
range of 1850 MHz to 2050 MHz by connecting the
RFLA and RFLB pins directly. For information on
configuring
the
Si4133
for
extended
frequency
operation, refer to Application Note 41: Extended
Frequency Operation of Silicon Laboratories Frequency
Synthesizers.
3.4. Self-Tuning Algorithm
The self-tuning algorithm is initiated immediately after
powerup of a PLL or, if the PLL is already powered, after
a change in its programmed output frequency. This
algorithm attempts to tune the VCO so that its free-
running frequency is near the required output frequency.
In
doing
so,
the
algorithm
compensates
for
manufacturing tolerance errors in the value of the
external inductance connected to the VCO. It also
reduces the frequency error for which the PLL must
correct to get the precise required output frequency. The
self-tuning algorithm leaves the VCO oscillating at a
frequency in error by somewhat less than 1% of the
desired output frequency.
After self-tuning, the PLL controls the VCO oscillation
frequency. The PLL completes frequency locking,
eliminating any remaining frequency error. From then
on, it maintains frequency-lock, compensating for
effects of temperature and supply voltage variations.
The Si4133’s self-tuning algorithm compensates for
component value errors at any temperature within the
specified temperature range. However, the ability of the
PLL to compensate for drift in component values that
occur
after
self-tuning
is
limited.
For
external
inductances
with
temperature
coefficients
approximately ±150 ppm/oC, the PLL can maintain lock
for changes in temperature of approximately ±30 oC.
Applications where the PLL is regularly powered down
or the frequency is periodically reprogrammed minimize
or eliminate the potential effects of temperature drift
because the VCO is re-tuned in either case. In
applications where the ambient temperature can drift
substantially after self-tuning, it might be necessary to
monitor the lock-detect bar (LDETB) signal on the
AUXOUT pin to determine whether a PLL is about to
run out of locking capability. See “3.10. Auxiliary Output
Table 6. Si4133-GT VCO Characteristics
VCO fCEN Range
(MHz)
CNOM
(pF)
LPKG
(nH)
LEXT Range
(nH)
Min
Max
Min
Max
RF1
947
1720
4.3
2.0
0.0
4.6
RF2
789
1429
4.8
2.3
0.3
6.2
IF
526
952
6.5
2.1
2.2
12.0
Table 7. Si4133-GM VCO Characteristics
VCO fCEN Range
(MHz)
CNOM
(pF)
LPKG
(nH)
LEXT Range
(nH)
Min
Max
Min
Max
RF1
947
1720
4.3
1.5
0.5
5.1
RF2
789
1429
4.8
1.5
1.1
7.0
IF
526
952
6.5
1.6
2.7
12.5
L
PKG
2
L
PKG
2
L
EXT
相关PDF资料 |
PDF描述 |
|---|---|
| LM113-200.0M | OSC 200.0000 MHZ 3.3V LVDS |
| TC32M6A32K7680 | OSCILLATOR 32.7680 KHZ 1.8V SMD |
| CGH40010F-TB | BOARD DEMO AMP CIRCUIT CGH40010 |
| DV75C-012.8M | OSC TCXO 12.800 MHZ 3.3V SMD |
| 53070C | XFRMR CURR SENSE 10A 1:70 SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI4133G | 制造商:未知厂家 制造商全称:未知厂家 功能描述:DUAL-BAND RF SYNTHESIZER WITH INTEGRATED VCOS FOR GSM AND GPRS WIRELESS COMMUNICATIONS |
| SI4133G-BM | 制造商:Silicon Laboratories Inc 功能描述: |
| SI4133G-BMR | 功能描述:射频无线杂项 CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:Texas Instruments 工作频率:112 kHz to 205 kHz 电源电压-最大:3.6 V 电源电压-最小:3 V 电源电流:8 mA 最大功率耗散: 工作温度范围:- 40 C to + 110 C 封装 / 箱体:VQFN-48 封装:Reel |
| SI4133G-BT | 制造商:SILABS 制造商全称:SILABS 功能描述:DUAL-BAND RF SYNTHESIZER WITH INTEGRATED VCOS FOR GSM AND GPRS WIRELESS COMMUNICATIONS |
发布紧急采购，3分钟左右您将得到回复。