- 您现在的位置：买卖IC网 > PDF目录18782 > SI4770-A20-GM (Silicon Laboratories Inc)IC RECEIVER AM/FM CE HP PDF资料下载
参数资料
| 型号： | SI4770-A20-GM |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 36/54页 |
| 文件大小： | 0K |
| 描述： | IC RECEIVER AM/FM CE HP |
| 特色产品： | Si477x Pro-Audio, High-Performance AM/FM Receiver and HD Radio Tuner |
| 标准包装： | 490 |
| 频率： | 520kHz ~ 1.71MHz，64MHz ~ 108MHz |
| 调制或协议： | AM，FM，RDS |
| 应用： | 通用 |
| 电流 - 接收： | 140mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 特点： | 配有 RSSI |
| 电源电压： | 4.5 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | * |
| 供应商设备封装： | * |
| 包装： | * |
| 配用： | 336-2267-ND - EVAL MODULE AM/FM CE SI4770 336-2269-ND - BOARD EVAL FOR CE AM/FM SI4770 |
| 其它名称： | 336-2268 SI4770-A10-GM SI4770-A10-GM-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
Si4770/77-A20
4.10. IBOC Blend Mode for HD Radio
(Si4777 Only)
For HD-Radio reception IBOC blend is supported on the
Si4777. This feature supports the ability to blend
between analog and digital audio. When the bit error
rate (BER) of the HD-Radio digital signal falls below a
predefined threshold (set by the HD-Radio
demodulator) and the digital audio fades out, the analog
audio is blended in. This prevents the received audio
from muting when the digital signal is lost. The audio will
"blend to digital" upon reacquisition of the digital signal.
Figure 22 illustrates the system implementation with a
third party HD-Radio demodulator. ZIF I/Q data is output
to the HD-Radio demodulator. The HD-Radio
demodulator demodulates and decodes the received
HD-Radio signal. It outputs digital audio (I 2 S three-wire
mode) to the Si4777 where the IBOC blend is
performed. An on-chip asynchronous resampling
converter (ASRC) allows the Si4777 to be slaved to the
HD-Radio demodulator digital audio output at any
sample rate from 32 kHz to 48 kHz.
The HD-R demodulator sends a 1-bit "BLEND" signal to
the Silicon Labs tuner. When this signal is "1", the
Si4777 initiates a crossover from full AM/FM analog
audio into full HD-R audio following a time ramp at a
programmable ramp rate. This process continues until
HD-R audio is fully blended to analog or until the
BLEND bit becomes a "0". When the BLEND bit is "0",
the reverse crossover occurs (crossover from HD-R to
AM/FM analog following a programmable ramp rate).
This process continues until AM/FM is fully blended or
until BLEND becomes "1".
The blended audio can be output on the analog output
pins, LOUT and ROUT and/or a digital audio port to a
third party audio DSP.
An on-chip asynchronous re-sampling converter
(ASRC) allows the Si4777 to be slaved to the Audio
DSP’s digital frame sync and bit clock from 32 kHz to
48 kHz.
Audio level alignment and calibration is implemented in
the Si4777 by multiplying the input HD-R audio signal
by a scaling constant (determined at manufacturing time
in the factory) and a dynamic constant that is HD-R
station-dependent. The dynamic constant is determined
by the HD-R demodulator during reception and is
relayed to the Si4777 by the host controller for the
blend.
4.10.1. IBOC Blend and I 2 C Device Address
Selection
In applications not requiring HD-Radio reception and
IBOC blend, with the Si4777, two I 2 C device addresses,
A0 and A1 (pins 11 and 12), are available, allowing up
to four Si4777 receivers to share the same I 2 C bus (see
"7. I2C Control Bus" on page 44). However in utilizing
IBOC blend for HD-radio reception on the Si4777, only
one device address A0 (pin 11) is available. Pin 12 is
repurposed for the Interrupt output INTB, whilst Pin 18
is repurposed for the digital audio clock input DFS2.
The 7-bit device address consists of a fixed part (6
MSBs), followed by a programmable 1-bit part. The LSB
of the device address signals whether a read or write
I 2 C operation occurs. The voltage on the A0 pin is used
to set the programmable 1-bit part of the device
address. The A0 pin is tied to ground and or is left to
float for address selection. The various I 2 C device
addresses can be selected as summarized in Table 16.
Table 16. I 2 C Device Address Selection in IBOC Blend Mode for Si4777
36
Device Address [6…1]
110001
110001
Device Address [0]
1
0
Rev. 0.9
A0 Voltage (Pin connection)
VIO1
GND
相关PDF资料 |
PDF描述 |
|---|---|
| 6494 | OSCILLOSCOPE PROBE 150 MHZ X10 |
| ZVN0545GTA | MOSFET N-CH 450V 140MA SOT223 |
| IRF9520NSPBF | MOSFET P-CH 100V 6.8A D2PAK |
| SP150B | PROBE OSCILLOSCOPE 1X/X10 RATIO |
| SI4840-A10-GU | IC AM/FM RX FOR DIGITAL RADIOS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| Si4770-A20-GMR | 功能描述:射频接收器 Cons. Elect. Pro-Aud AM/FM RDS Rx RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel |
| Si4770-A-EVB | 功能描述:射频开发工具 SI4770 EVAL BOARD. 40P 6X6X0.85 RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| Si4770Module-A-EVB | 功能描述:射频开发工具 Hi-Performance CE AM/FM Module RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| SI4774DY | 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:N-Channel 30 V (D-S) MOSFET with Schottky Diode |
| Si4774DY-T1-GE3 | 功能描述:MOSFET 30 Volts 16 Amps 5 Watts RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。