- 您现在的位置：买卖IC网 > PDF目录15504 > SP6136ER1-L (Exar Corporation)IC REG CTRLR BUCK PWM VM 16-QFN PDF资料下载
参数资料
| 型号： | SP6136ER1-L |
| 厂商： | Exar Corporation |
| 文件页数： | 12/18页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 16-QFN |
| 标准包装： | 490 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 680kHz |
| 占空比： | 92% |
| 电源电压： | 5 V ~ 24 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-VFQFN 裸露焊盘 |
| 包装： | 散装 |
| 其它名称： | 1016-1394 |
APPLICATION INFORMATION
{ I
}
I L(RMS) =
I OUT(MAX) X
√
+ ?
3
I PP
OUT(MAX)
2
Δ V OUT = Peak to Peak Output Voltage Ripple
I PK - PK = Peak to Peak Inductor Ripple Current
The total output ripple is a combination of
the ESR and the output capacitance value
and can be calculated as follows:
√
{ C I
Output Capacitor Selection
The required ESR (Equivalent Series Re -
sistance) and capacitance drive the selec-
tion of the type and quantity of the output
capacitors. The ESR must be small enough
that both the resistive voltage deviation due
Δ V OUT = .
(I PP ?R ESR ) 2 +
PP ? (1-D)
OUT ? F S
}
2
.
to a step change in the load current and
the output ripple voltage do not exceed
the tolerance limits expected on the output
voltage. During an output load transient,
the output capacitor must supply all the ad-
ditional current demanded by the load until
the SP6 36 adjusts the inductor current to
the new value.
Therefore, the capacitance must be large
enough so that the output voltage is held up
while the inductor current ramps up or down
to the value corresponding to the new load
current. Additionally, the ESR in the output
capacitor causes a step in the output voltage
equal to the current. Because of the fast tran -
sient response and inherent 00% and 0%
duty cycle capability provided by the SP6 36
when exposed to output load transients, the
output capacitor is typically chosen for ESR,
not for capacitance value.
The output capacitor ’s ESR, combined with
the inductor ripple current, is typically the
main contributor to output voltage ripple.
The maximum allowable ESR required to
maintain a specified output voltage ripple
can be calculated by:
R ESR < Δ V OUT
I PK - PK
where:
where:
Fs = Switching Frequency
D = Duty Cycle
C OUT = Output Capacitance Value
Input Capacitor Selection
The input capacitor should be selected for
ripple current rating, capacitance and voltage
rating. The input capacitor must meet the
ripple current requirement imposed by the
switching current. In continuous conduction
mode, the source current of the high-side
MOSFET is approximately a square wave
of duty cycle V OUT /V IN . Most of this current
is supplied by the input bypass capacitors.
The RMS value of input capacitor current is
determined at the maximum output current
and under the assumption that the peak to peak
inductor ripple current is low, it is given by:
.
I CIN ( RMS ) = I OUT(MAX) X √ D ? ( -D)
Schottky Diode Selection
When paralleled with the bottom MOSFET,
an optional Schottky diode can improve
efficiency and reduce noise. Without this
Schottky diode, the body diode of the bot-
tom MOSFET conducts the current during
the non-overlap time when both MOSFETs
are turned off. Unfortunately, the body di-
Oct 3 -06 Rev L
SP6 36 Synchronous Buck Controller
2
? 2006 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3822EDD#PBF | IC REG CTRLR BUCK PWM CM 10-DFN |
| SP6133ER1-L | IC REG CTRLR BUCK PWM VM 16-QFN |
| MIC3809YMM | IC REG CTRLR ISO PWM CM 8-MSOP |
| MIC38C43YN | IC REG CTRLR BST FLYBK ISO 8-DIP |
| MIC38C45YN | IC REG CTRLR BST FLYBK ISO 8-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP6136ER1-L/TR | 功能描述:DC/DC 开关控制器 Synchronous Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| SP6137 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input, 900KHz Synchronous PWM Controller |
| SP6137CU | 制造商:Exar Corporation 功能描述:SMPS Controller |
| SP6137CU/TR | 制造商:Exar Corporation 功能描述:SMPS Controller |
| SP6137CU-L | 功能描述:开关变换器、稳压器与控制器 Wide Input, 900KHz Synchronous RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。