- 您现在的位置：买卖IC网 > PDF目录15504 > SP6136ER1-L (Exar Corporation)IC REG CTRLR BUCK PWM VM 16-QFN PDF资料下载
参数资料
| 型号： | SP6136ER1-L |
| 厂商： | Exar Corporation |
| 文件页数： | 5/18页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 16-QFN |
| 标准包装： | 490 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 680kHz |
| 占空比： | 92% |
| 电源电压： | 5 V ~ 24 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-VFQFN 裸露焊盘 |
| 包装： | 散装 |
| 其它名称： | 1016-1394 |
PIN DESCRIPTION
PIN
#
2
3
4
5
6
7
8
9
0
2
3
4
5
6
PIN
NAME
GL
PGND
GND
VFB
COMP
EN
PWRGD
SS
ISN
ISP
SWN
GH
BST
VIN
UVIN
VCC
DESCRIPTION
High current driver output for the low side NFET switch. It is always low if GH is high or
during a fault. Resistor pull down ensures low state at low voltage.
Ground Pin. The power circuitry is referenced to this pin. Return separately from other
ground traces to the (-) terminal of Cout.
Ground pin. The control circuitry of the IC is referenced to this pin.
Feedback Voltage and Short Circuit Detection pin. It is the inverting input of the Error
Amplifier and serves as the output voltage feedback point for the Buck Converter. The
output voltage is sensed and can be adjusted through an external resistor divider.
Whenever VFB drops 0.25V below the positive reference, a short circuit fault is detected
and the IC enters hiccup mode.
Output of the Error Amplifier. It is internally connected to the non-inverting input of the PWM
comparator. An optimal filter combination is chosen and connected to this pin and either
ground or VFB to stabilize the voltage mode loop.
Enable Pin. Pulling this pin below 0.4V will place the IC into sleep mode. This pin is
internally pulled to VCC with a μA current source.
Power Good Output. This open drain output is pulled low when VOUT is outside of the
regulation. Connect an external resistor to pull high.
Soft Start/Fault Flag. Connect an external capacitor between SS and GND to set the soft
start rate based on the 0μA source current. The SS pin is held low via a mA (min) current
during all fault conditions.
Negative Input for the Sense Comparator. There should be a 60mV offset between PSENSE
and NSENSE. Offset accuracy + 0%.
Positive Input for the Inductor Current Sense.
Lower supply rail for the GH high-side gate driver. Connect this pin to the switching node at
the junction between the two external power MOSFET transistors.
High current driver output for the high side NFET switch. It is always low if GL is high or during a fault.
High side driver supply pin. Connect BST to the external boost diode and capacitor as shown
in the Application Schematic of page . High side driver is connected between BST pin and SWN pin.
Supply Input -- supplies power to the internal LDO.
Under Voltage lock-out for VIN voltage. Internally has a resistor divider from VIN to ground.
Can be overridden with external resistors.
Output of the Internal LDO. If VIN is less than 5V then Vcc should be powered from an
external 5V supply.
Note: Die attach paddle is internally connected to GND.
THEORY OF OPERATION
General Overview
The SP6136 is a fixed frequency, voltage
mode, synchronous PWM controller opti-
mized for high efficiency. The part has been
designed to be especially attractive for single
supply input voltages ranging between 5V
and 24V.
The heart of the SP6 36 is a wide bandwidth
transconductance amplifier designed to ac -
commodate Type II and Type III compensa-
tion schemes. A precision 0.8V reference
present on the positive terminal of the error
amplifier permits the programming of the
output voltage down to 0.8V via the V FB pin.
The output of the error amplifier, COMP,
compared to a V peak-to-peak ramp is
responsible for trailing edge PWM control.
This voltage ramp and PWM control logic
are governed by the internal oscillator that
accurately sets the PWM frequency to 600kHz.
Oct 3 -06 Rev L
SP6 36 Synchronous Buck Controller
5
? 2006 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3822EDD#PBF | IC REG CTRLR BUCK PWM CM 10-DFN |
| SP6133ER1-L | IC REG CTRLR BUCK PWM VM 16-QFN |
| MIC3809YMM | IC REG CTRLR ISO PWM CM 8-MSOP |
| MIC38C43YN | IC REG CTRLR BST FLYBK ISO 8-DIP |
| MIC38C45YN | IC REG CTRLR BST FLYBK ISO 8-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP6136ER1-L/TR | 功能描述:DC/DC 开关控制器 Synchronous Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| SP6137 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input, 900KHz Synchronous PWM Controller |
| SP6137CU | 制造商:Exar Corporation 功能描述:SMPS Controller |
| SP6137CU/TR | 制造商:Exar Corporation 功能描述:SMPS Controller |
| SP6137CU-L | 功能描述:开关变换器、稳压器与控制器 Wide Input, 900KHz Synchronous RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。