- 您现在的位置：买卖IC网 > PDF目录17417 > SP6656EB (Exar Corporation)EVAL BOARD FOR SP6656 PDF资料下载
参数资料
| 型号： | SP6656EB |
| 厂商： | Exar Corporation |
| 文件页数： | 10/16页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR SP6656 |
| 标准包装： | 1 |
| 系列： | * |
THEORY OF OPERATION
Low Dropout and Load Transient
Operation
Using AND logic function the loop compara-
tor also increases the duty ratio past the
ideal D= V OUT /V IN up to and including 100%.
Under a light to heavy load transient, the
loop comparator will hold the main switch
on longer than the minimum on timer until
the output is brought back into regulation.
Also, as the input voltage supply drops
down close to the output voltage, the main
MOSFET resistance loss will dictate a much
higher duty ratio to regulate the output.
Eventually as the input voltage drops low
shot. The off-time one shot forces the loop
into the discharge phase for a minimum
T OFF time causing the inductor current to
decrease. At the end of the off-time, loop
control is handed back to the AND logic
function on-time signal. If the output voltage
is still low, charging begins until the output
is in regulation or the current limit has been
reached again. During startup and overload
conditions, the converter behaves like a
current source at the programmed limit mi-
nus half the current ripple. The minimum
T OFF is controlled by the equation:
enough, the output voltage will follow, caus-
ing the loop comparator to hold the con-
verter at 100% duty cycle.
T OFF (MIN) =
K OFF
V OUT
This mode is critical in extending battery life
when the output voltage is at or above the
minimum usable input voltage. The dropout
voltage is the minimum (V IN -V OUT ) below
which the output regulation cannot be main-
tained. The dropout voltage of SP6656 is
equal to I L * (0.3 ? + R L1 ) where 0.3 ? is the
typical R DS(ON) of the P-Channel MOSFET
and R L is the DC resistance of the inductor.
The SP6656 has been designed to operate
in dropout with a light load Iq of only 80 μ A.
The on-time control circuit seamlessly op-
erates the converter between CCM, DCM,
and low dropout modes without the need for
compensation. The converter’s transient
response is quick since there is no compen-
sated error amplifier in the loop.
Inductor Over-Current Protection
To reduce the light load dropout Iq, the
SP6656 over-current system is only en-
abled when I L1 > 400mA. The inductor over-
current protection circuitry is programmed
to limit the peak inductor current to 0.625A.
This is done during the on-time by compar-
ing the source to drain voltage drop of the
PMOS passing the inductor current with a
second voltage drop representing the maxi-
mum allowable inductor current. As the two
voltages become equal, the over-current
comparator triggers a minimum off-time one
Under-Voltage Lockout
The SP6656 is equipped with a program-
mable under-voltage lockout to protect the
input battery source from excessive cur-
rents when substantially discharged. When
the input supply is below the UVLO thresh-
old both power switches are open to pre-
vent inductor current from flowing. The level
of falling input voltage has a typical hyster-
esis of 120mV to prevent chattering due to
the impedance of the input source.
Under-Current Detection
The synchronous rectifier is comprised of
an inductor discharge switch, a voltage com-
parator, and a driver latch. During the off-
time, positive inductor current flows into the
PGND pin 9 through the low side NMOS
switch to LX pin 10, through the inductor
and the output capacitor, and back to pin 9.
The comparator monitors the voltage drop
across the discharge NMOS. As the induc-
tor current approaches zero, the channel
voltage sign goes from negative to positive,
causing the comparator to trigger the driver
latch and open the switch to prevent induc-
tor current reversal. This circuit along with
the on-timer puts the converter into PFM
mode and improves light load efficiency
Date: 3/6/06
SP6656, 400mA Synchronous Buck Regulator with Dynamically Adjustable Voltage Output
10
? Copyright 2006 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| GCM06DTKI | CONN EDGECARD 12POS DIP .156 SLD |
| M7TTK-5010J | IDC CABLE - MDL50K/MC50G/MDL50K |
| GEM08DTBI | CONN EDGECARD 16POS R/A .156 SLD |
| A9BAA-1002F | FLEX CABLE - AFF10A/AF10/AFE10T |
| EBC25DRTI | CONN EDGECARD 50POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP6656ER | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:High Efficiency 400mA Synchronous Buck Regulator with Bit Programmable Output |
| SP6656ER/TR | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:High Efficiency 400mA Synchronous Buck Regulator with Bit Programmable Output |
| SP6656ER3 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:High Efficiency 400mA Synchronous Buck Regulator with Dynamically Adjustable Voltage Output |
| SP6656ER3-L | 功能描述:DC/DC 开关控制器 High Eff. 400mA Sync. Buck Reg RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| SP6656ER3-L/TR | 功能描述:DC/DC 开关控制器 High Eff 400mA Synchronous RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
发布紧急采购，3分钟左右您将得到回复。