- 您现在的位置：买卖IC网 > Datasheet目录363 > SSL1750T/N1,518 (NXP Semiconductors)IC LED DRVR HI PWR AC IN 16-SOIC Datasheet资料下载
参数资料
| 型号： | SSL1750T/N1,518 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 18/29页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR HI PWR AC IN 16-SOIC |
| 标准包装： | 2,500 |
| 拓扑： | 交直流离线开关，反激式，PFC |
| 输出数： | 2 |
| 内部驱动器： | 无 |
| 类型 - 主要： | 通用 |
| 频率： | 100kHz ~ 150kHz |
| 电源电压： | 70 V ~ 276 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SO |
| 包装： | 带卷 (TR) |
| 工作温度： | -20°C ~ 150°C |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
NXP Semiconductors
S2
Istart(soft)fb ≤ 60 μ A
SSL1750
SMPS control IC for LED drivers
SOFT START
CONTROL
RSS2
CSS2
10
FBSENSE
+
0.5 V
OCP
RSENSE2
014aaa020
Fig 13. Soft start-up of ?yback
7.3.7 Maximum on-time
The ?yback controller limits the ‘on-time’ of the external MOSFET to 25 μ s (typ). When the
‘on-time’ is longer than 25 μ s, the IC stops switching and enters the safe restart mode.
7.3.8 Overvoltage protection (pin FBAUX)
An output overvoltage protection is implemented in this IC. This works for the SSL1750 by
sensing the auxiliary voltage via the current ?owing into pin FBAUX during the secondary
stroke. The auxiliary winding voltage is a well-de?ned replica of the output voltage.
Voltage spikes are averaged by an internal ?lter.
If the output voltage exceeds the OVP trip level, an internal counter starts counting
subsequent OVP events. The counter has been added to prevent incorrect OVP detection
which might occur during ElectroStatic Discharge (ESD) or lightning events. If the output
voltage exceeds the OVP trip level a few times and not again in a subsequent cycle, the
internal counter counts down at twice the speed it uses when counting up. However, when
typically 8 cycles of subsequent OVP events are detected, the IC assumes a true OVP
and the OVP circuit switches the power MOSFET off. As the protection is latched, the
converter only restarts after the internal latch is reset. In a typical application the mains
should be interrupted to reset the internal latch.
The output voltage V ovp(FBAUX) at which the OVP function trips, can be set by the
demagnetization resistor, R FBAUX . See Equation 5 .
V o ( ovp ) = ----------- ( I ovp ( FBAUX ) × R FBAUX + V clamp ( FBAUX ) )
N s
N aux
(5)
where N s is the number of secondary turns and N aux is the number of auxiliary turns of the
transformer. Current I ovp(FBAUX) is internally trimmed.
The value of R FBAUX can be adjusted to the turns ratio of the transformer, thus making an
accurate OVP detection possible.
SSL1750_1
? NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 01 — 15 September 2008
18 of 29
相关PDF资料 |
PDF描述 |
|---|---|
| SSL2103T/1,518 | IC LED DRIVER SMPS DIMM 14SOIC |
| SSL21081T/1,118 | IC LED DRIVER 300V 8-SOIC |
| SSL21153T/1,118 | IC DRIVER LED SSL 7SOIC |
| SSL3250AHN/C1,528 | IC LED DRVR PHOTO FLASH 16-HVQFN |
| SST25LF020A-33-4C-QAE-T | IC FLASH SER 2MB 33HZ SPI 8WSON |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SSL1A12ND | 制造商:Schneider Electric 功能描述:SSR Slim 1 Chann, 2A@24-280VAC zero, 38-72VDC |
| SSL1D03BD | 制造商:Schneider Electric 功能描述:SSR Slim 1 Channel, 3.5A@1-24VDC, 15-30VDC |
| SSL1D03JD | 制造商:Schneider Electric 功能描述:SSR Slim 1 Channel, 3.5A@1-24VDC, 3-12VDC |
| SSL1D101BD | 制造商:Schneider Electric 功能描述:SSR Slim 1 Channel, 0.1A@1-48VDC, 16-30VDC |
| SSL1D101JD | 制造商:Schneider Electric 功能描述:SSR Slim 1 Channel, 0.1A@1-48VDC, 3-12VDC |
发布紧急采购，3分钟左右您将得到回复。