- 您现在的位置：买卖IC网 > PDF目录4234 > SST39SF040-70-4C-WHE-T (Microchip Technology)IC FLASH MPF 4MBIT 70NS 32TSOP PDF资料下载
参数资料
| 型号： | SST39SF040-70-4C-WHE-T |
| 厂商： | Microchip Technology |
| 文件页数： | 8/28页 |
| 文件大小： | 0K |
| 描述： | IC FLASH MPF 4MBIT 70NS 32TSOP |
| 标准包装： | 1,500 |
| 系列： | SST39 MPF™ |
| 格式 - 存储器： | 闪存 |
| 存储器类型： | FLASH |
| 存储容量： | 4M (512K x 8) |
| 速度： | 70ns |
| 接口： | 并联 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 32-TFSOP（0.488"，12.40mm 宽） |
| 供应商设备封装： | 32-TSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
1 Mbit / 2 Mbit / 4 Mbit Multi-Purpose Flash
A Microchip Technology Company
SST39SF010A / SST39SF020A / SST39SF040
Data Sheet
Write Operation Status Detection
The SST39SF010A/020A/040 provide two software means to detect the completion of a Write (Pro-
gram or Erase) cycle, in order to optimize the system Write cycle time. The software detection includes
two status bits: Data# Polling (DQ 7 ) and Toggle Bit (DQ 6 ). The End-of-Write detection mode is enabled
after the rising edge of WE# which initiates the internal Program or Erase operation.
The actual completion of the nonvolatile write is asynchronous with the system; therefore, either a
Data# Polling or Toggle Bit read may be simultaneous with the completion of the Write cycle. If this
occurs, the system may possibly get an erroneous result, i.e., valid data may appear to conflict with
either DQ 7 or DQ 6 . In order to prevent spurious rejection, if an erroneous result occurs, the software
routine should include a loop to read the accessed location an additional two (2) times. If both reads
are valid, then the device has completed the Write cycle, otherwise the rejection is valid.
Data# Polling (DQ 7 )
When the SST39SF010A/020A/040 are in the internal Program operation, any attempt to read DQ 7 will
produce the complement of the true data. Once the Program operation is completed, DQ 7 will produce
true data. Note that even though DQ 7 may have valid data immediately following the completion of an
internal Write operation, the remaining data outputs may still be invalid: valid data on the entire data
bus will appear in subsequent successive Read cycles after an interval of 1 μs. During internal Erase
operation, any attempt to read DQ 7 will produce a ‘0’. Once the internal Erase operation is completed,
DQ 7 will produce a ‘1’. The Data# Polling is valid after the rising edge of fourth WE# (or CE#) pulse for
Program operation. For Sector- or Chip-Erase, the Data# Polling is valid after the rising edge of sixth
WE# (or CE#) pulse. See Figure 8 for Data# Polling timing diagram and Figure 17 for a flowchart.
Toggle Bit (DQ 6 )
During the internal Program or Erase operation, any consecutive attempts to read DQ 6 will produce
alternating 0s and 1s, i.e., toggling between 0 and 1. When the internal Program or Erase operation is
completed, the toggling will stop. The device is then ready for the next operation. The Toggle Bit is valid
after the rising edge of fourth WE# (or CE#) pulse for Program operation. For Sector- or Chip-Erase,
the Toggle Bit is valid after the rising edge of sixth WE# (or CE#) pulse. See Figure 9 for Toggle Bit tim-
ing diagram and Figure 17 for a flowchart.
Data Protection
The SST39SF010A/020A/040 provide both hardware and software features to protect nonvolatile data
from inadvertent writes.
Hardware Data Protection
Noise/Glitch Protection: A WE# or CE# pulse of less than 5 ns will not initiate a Write cycle.
V DD Power Up/Down Detection: The Write operation is inhibited when V DD is less than 2.5V.
Write Inhibit Mode: Forcing OE# low, CE# high, or WE# high will inhibit the Write operation. This pre-
vents inadvertent writes during power-up or power-down.
?2011 Silicon Storage Technology, Inc.
8
DS25022A
07/11
相关PDF资料 |
PDF描述 |
|---|---|
| SST39VF800A-70-4I-B3KE-T | IC FLASH MPF 8MBIT 70NS 48TFBGA |
| SST39LF400A-55-4C-EKE-T | IC FLASH MPF 4MBIT 55NS 48TSOP |
| 24LC512-E/SN | EEPROM 512KB 2.5V 400KHZ 8SOIC |
| SST39SF020A-70-4I-NHE | IC FLASH MPF 2MBIT 70NS 32PLCC |
| SST39LF040-55-4C-NHE | IC FLASH MPF 4MBIT 55NS 32PLCC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SST39SF040-70-4I-NH | 功能描述:闪存 512K X 8 70ns RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel |
| SST39SF040-70-4I-NHE | 功能描述:闪存 512K X 8 70ns RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel |
| SST39SF040-70-4I-NHE-T | 功能描述:闪存 4M (512Kx8) 70ns 5.0V Industrial RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel |
| SST39SF040-70-4I-PH | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:1 Mbit / 2 Mbit / 4 Mbit (x8) Multi-Purpose Flash |
| SST39SF040-70-4I-WH | 功能描述:闪存 512K X 8 70ns RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。