- 您现在的位置：买卖IC网 > PDF目录11502 > SST89C58RC-40-C-QIF-T (Microchip Technology)IC MCU 8BIT FLASH 40WQFN PDF资料下载
参数资料
| 型号： | SST89C58RC-40-C-QIF-T |
| 厂商： | Microchip Technology |
| 文件页数： | 59/88页 |
| 文件大小： | 0K |
| 描述： | IC MCU 8BIT FLASH 40WQFN |
| 标准包装： | 3,000 |
| 系列： | FlashFlex® |
| 核心处理器： | 8051 |
| 芯体尺寸： | 8-位 |
| 速度： | 40MHz |
| 连通性： | EBI/EMI，I²C，SMBus，UART/USART |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 32 |
| 程序存储器容量： | 32KB（32K x 8） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 2K x 8 |
| RAM 容量： | 1K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 振荡器型： | 外部 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 40-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页当前第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页
2011 Silicon Storage Technology, Inc.
DS25100A
12/11
62
FlashFlex MCU
SST89C58RC
Data Sheet
A Microchip Technology Company
Watchdog timer
The programmable Watchdog Timer (WDT) is for fail safe protection against software deadlock and for
automatic recovery.
The Watchdog timer is utilized as a watchdog or a timer. To use the Watchdog timer as a watchdog, set
WDRE (WDTC[3]) to ‘1’. To use the Watchdog timer as a timer only, set WDRE to ‘0’ so timer overflows
generate an interrupt. Set EWD (IEA[6]) to ‘1’ to enable the interrupt.
Watchdog Timer Mode
To protect the system against software deadlock, WDT (WDTC[1]) should be refreshed within a user-
defined time period. Without a periodic refresh, an internal hardware reset will initiate when WDRE
(WDTC[3]) = 1). Only a power-on reset clears the WDRE bit.
Any Write to WDTC must be preceded by a correct feed sequence. If WDTON (WDTC[6])=0, the start
or stop of the watchdog is controlled by SWDT (WDTC[0]). If WDTON = 1, the watchdog starts regard-
less of SWDT and cannot be stopped until overflowed.
The upper 8 bits of the time base register (WDTD) is used as the reload register of the counter. When
WDT (WDTC[1]) is set to ‘1’, the content of WDTD is loaded into the watchdog counter and the pres-
caler is cleared.
If a watchdog reset occurs, the reset pin will output at least 196 system clocks. The code execution will
begin immediately after the reset cycle.
The WDTS flag bit is set by the Watchdog timer overflow and can only be cleared by power-on reset.
Users can also clear the WDTS bit by writing ‘1’ to it following a correct feed sequence.
Pure Timer Mode
In Timer mode, the WDTC and WDTD can be written at any time without a feed sequence. Setting or
clearing the SWDT bit will start or stop the counter. A timer overflow will set the WDTS bit. Writing ‘1’ to
this bit clears it. When an overflow occurs, the content of WDTD is reloaded into the counter and the
Watchdog timer immediately begins to count again. If the interrupt is enabled, an interrupt will occur
when the timer overflows. The vector address is 053H and it has a nine-level priority by default. A feed
sequence is not required in this mode.
Clock Source
The WDT in the device uses the system clock (XTAL1) as its time base, making it a watchdog counter
rather than a Watchdog timer. The WDT register will increment every 344,064 crystal clocks. The
upper 8-bits of the time base register (WDTD) are used as the reload register of the WDT.
Figure 23 provides a block diagram of the WDT. Two SFRs (WDTC and WDTD) control Watchdog
timer operation.
The time-out period of the WDT is calculated as follows:
Period = (255 - WDTD) * 344064 * 1/fCLK (XTAL1)
where WDTD is the value loaded into the WDTD register and fOSC is the oscillator frequency.
相关PDF资料 |
PDF描述 |
|---|---|
| SST89E516RD2-40-C-TQJE | IC MCU 8BIT 72KB FLASH 44TQFP |
| SST89C58RC-40-I-TQJE | IC MCU 8BIT FLASH 40TQFP |
| SST89E516RD2-40-I-TQJE | IC MCU 8BIT 72KB FLASH 44TQFP |
| PIC24F16KA101-E/P | MCU 16KB FLASH 1.5KB RAM 20PDIP |
| VE-B10-IY-B1 | CONVERTER MOD DC/DC 5V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SST89C58RC-40-I-NJE | 制造商:Microchip Technology Inc 功能描述:8 BIT MICROCONTROLLER WITH 40K - Rail/Tube 制造商:Microchip Technology Inc 功能描述:Microchip SST89C58RC-40-I-NJE Microcontrollers (MCU) |
| SST89C58RC-40-I-QIF | 功能描述:8位微控制器 -MCU 40K (32Kx8K) SM-Bus 40MHz 2.7-5.5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| SST89C58RC-40-I-TQJE | 功能描述:8位微控制器 -MCU 40K (32Kx8K) SM-Bus 40MHz 2.7-5.5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| SST89C59 | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:FlashFlex51 MCU |
| SST89C59-33-AC-NI | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:FlashFlex51 MCU |
发布紧急采购，3分钟左右您将得到回复。