参数资料
型号: ST52F510Y3B6
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PDIP16
封装: PLASTIC, DIP-16
文件页数: 14/106页
文件大小: 648K
代理商: ST52F510Y3B6
ST52F510/F513/F514
15/106
1.3 Pin Description
ST52F510/F513/F514 pins can be set in digital
input mode, digital output mode, interrupt mode or
in
Alternate
Functions.
Pin
configuration
is
achieved by means of the configuration registers.
The functions of the ST52F510/F513/F514 pins
are described below:
VDD. Main Power Supply Voltage.
VSS. Digital circuit Ground.
VPP. Programming/Working mode selector. During
the Programming phase VPP must be set to VDD.
In Working phase VPP must be equal to VSS.
OSCin and OSCout. These pins are internally
connected to the on-chip oscillator circuit. A quartz
crystal or a ceramic resonator can be connected
between these two pins in order to allow correct
use of ST52F510/F513/F514 with various stability/
cost trade-offs. An external clock signal can be
applied to OSCin: in this case OSCout must be
grounded. To reduce costs, an RC circuit can be
applied to the OSCin pin to establish the internal
clock frequency, instead of the quartz. Without any
connection, the device can work with its internal
clock generator (10 MHz)
RESET. This signal is used to reset the ST52F510/
F513/F514 and re-initialize the registers and
control signals. It is also used when switching from
the Programming Mode to Working Mode and vice
versa.
PA0-PA7, PB0-PB7,PC0-PC5. These lines are
organized as I/O ports. Each pin can be configured
as an input, output (with pull-up, push-pull, weak-
pull-up, open-drain, high-impedance), or as an
interrupt source.
VREF, AIN0-AIN7. These pins are used to input
the analog signals into the A/D Converter. An
analog multiplexer is available to switch these
inputs to the A/D Converter. The pin VREF is used
to input an external A/D Reference Voltage.
T0OUT, T1OUT. These pins output the signals
generated by the PWM/Timer 0 and PWM/Timer 1
peripheral.
TRES, TSTRT, TCLK . These pins are related to
the PWM/Timer 0 peripheral and are used for Input
Capture and event counting. The TRES pin is used
to set/reset the Timer; the TSTRT pin is used to
start/stop the counter. The Timer can be driven by
the internal clock or by an external signal
connected to the TCLK pin.
INT. This pin is used as input for the Non-Maskable
(top level) interrupt. The interrupt signal is detected
only if the pin is configured in Alternate Function.
SCL, SDA. These pin are used respectively as
Serial Clock and Serial Data I/O in I
2C peripheral
protocol. They are used also in Programming
Mode to receive and transmit data.
TX, RX. Serial data output of SCI Transmitter block
(TX) and Serial data input of the SCI Receiver
block (RX).
SCK, MISO, MOSI, SS. These pins are used by
the Serial Peripheral Interface (SPI) peripheral.
SCK is the serial clock line. MISO (Master In Slave
Out) and MOSI (Master Out Slave In) are the serial
data lines, which work in input or in output
depending on if the device is working in slave or
master mode. The SS pin allows the selection of
the device master/slave mode.
相关PDF资料
PDF描述
ST52F514Y2B6 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PDIP16
ST52T430K3B6 8-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PDIP32
ST52T430K3T6 8-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP32
ST5X86V12HS 64-BIT, 120 MHz, MICROPROCESSOR, CPGA168
ST6235Q6 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP52
相关代理商/技术参数
参数描述
ST52F510YMM6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Two Timer/PWMs, ADC, I2C, SPI, SCI
ST52F513 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Two Timer/PWMs, ADC, I2C, SPI, SCI
ST52F513FMB6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Two Timer/PWMs, ADC, I2C, SPI, SCI
ST52F513FMM6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Two Timer/PWMs, ADC, I2C, SPI, SCI
ST52F513GMB6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Two Timer/PWMs, ADC, I2C, SPI, SCI