- 您现在的位置：买卖IC网 > PDF目录195892 > STK14C88-W35M 32K X 8 NON-VOLATILE SRAM, 35 ns, PDIP32 PDF资料下载
参数资料
| 型号： | STK14C88-W35M |
| 元件分类： | SRAM |
| 英文描述： | 32K X 8 NON-VOLATILE SRAM, 35 ns, PDIP32 |
| 封装： | 0.600 INCH, PLASTIC, DIP-32 |
| 文件页数： | 13/13页 |
| 文件大小： | 387K |
| 代理商： | STK14C88-W35M |
STK14C88
September 2003
9
Document Control # ML0014 rev 0.1
SOFTWARE NONVOLATILE RECALL
A software RECALL cycle is initiated with a sequence
of READ operations in a manner similar to the soft-
ware STORE initiation. To initiate the RECALL cycle,
the following sequence of E controlled READ opera-
tions must be performed:
1. Read address
0E38 (hex)
Valid READ
2. Read address
31C7 (hex)
Valid READ
3. Read address
03E0 (hex)
Valid READ
4. Read address
3C1F (hex)
Valid READ
5. Read address
303F (hex)
Valid READ
6. Read address
0C63 (hex)
Initiate RECALL cycle
Internally, RECALL is a two-step procedure. First, the
SRAM
data is cleared, and second, the nonvolatile
information is transferred into the SRAM cells. After
the t
RECALL cycle time the SRAM will once again be
ready for READ and WRITE operations. The RECALL
operation in no way alters the data in the nonvolatile
elements. The nonvolatile data can be recalled an
unlimited number of times.
AutoStore OPERATION
The STK14C88 can be powered in one of three
modes.
During
normal
AutoStore
operation,
the
STK14C88 will draw current from V
CCX to charge a
capacitor connected to the V
CAP pin. This stored
charge will be used by the chip to perform a single
STORE
operation. After power up, when the voltage
on the V
CAP pin drops below VSWITCH, the part will
automatically disconnect the V
CAP pin from VCCX and
initiate a STORE operation.
Figure 2 shows the proper connection of capacitors
for automatic store operation. A charge storage
capacitor having a capacity of between 68
F and
220
F (± 20%) rated at 6V should be provided.
In system power mode (Figure 3), both V
CCX and
V
CAP are connected to the + 5V power supply without
the 68
F capacitor. In this mode the AutoStore
function of the STK14C88 will operate on the stored
system charge as power goes down. The user must,
however, guarantee that V
CCX does not drop below
3.6V during the 10ms STORE cycle.
If an automatic STORE on power loss is not required,
then V
CCX can be tied to ground and + 5V applied to
V
CAP
(Figure 4). This is the AutoStore Inhibit
mode, in which the AutoStore function is disabled.
If the STK14C88 is operated in this configuration,
references to V
CCX
should be changed to V
CAP
throughout this data sheet. In this mode, STORE
operations may be triggered through software con-
trol or the HSB pin. It is not permissable to change
between these three options “on the fly”.
In order to prevent unneeded STORE operations,
automatic STOREs as well as those initiated by
externally driving HSB low will be ignored unless at
least one WRITE operation has taken place since the
most recent STORE or RECALL cycle. Software-
initiated STORE cycles are performed regardless of
whether a WRITE operation has taken place. An
optional pull-up resistor is shown connected to HSB.
This can be used to signal the system that the
AutoStore cycle is in progress.
Figure 2: AutoStore Mode
1
16
32
31
17
68
F
6v
,±2
0%
0.1
F
By
pa
ss
30
+
10
k
10k
Figure 3: System Power Mode
1
16
32
31
17
30
0.1
F
Byp
as
s
10k
10
k
Figure 4: AutoStore
Inhibit Mode
1
16
32
31
17
0.1
F
By
pa
ss
30
10
k
10
k
*If HSB is not used, it should be left unconnected.
相关PDF资料 |
PDF描述 |
|---|---|
| STK730-010 | Isolated Flyback Switching Regulator with 9V Output |
| STK730-020 | Isolated Flyback Switching Regulator with 9V Output |
| STK730-030 | Isolated Flyback Switching Regulator with 9V Output |
| STK730-040 | Isolated Flyback Switching Regulator with 9V Output |
| STK730-050 | Isolated Flyback Switching Regulator with 9V Output |
相关代理商/技术参数 |
参数描述 |
|---|---|
| STK14CA8-N25ITR | 制造商:Cypress Semiconductor 功能描述:STK14CA8 Series 1 Mb (128 K x 8) 3 V 25 ns AutoStore NVSRAM - SOIC-32 |
| STK14CA8-NF25 | 功能描述:NVRAM 128Kbx8 AutoStore RoHS:否 制造商:Maxim Integrated 数据总线宽度:8 bit 存储容量:1024 Kbit 组织:128 K x 8 接口类型:Parallel 访问时间:70 ns 电源电压-最大:5.5 V 电源电压-最小:4.5 V 工作电流:85 mA 最大工作温度:+ 70 C 最小工作温度:0 C 封装 / 箱体:EDIP 封装:Tube |
| STK14CA8-NF25I | 功能描述:NVRAM 128Kbx8 AutoStore RoHS:否 制造商:Maxim Integrated 数据总线宽度:8 bit 存储容量:1024 Kbit 组织:128 K x 8 接口类型:Parallel 访问时间:70 ns 电源电压-最大:5.5 V 电源电压-最小:4.5 V 工作电流:85 mA 最大工作温度:+ 70 C 最小工作温度:0 C 封装 / 箱体:EDIP 封装:Tube |
| STK14CA8-NF25ITR | 功能描述:NVRAM 128Kbx8 AutoStore RoHS:否 制造商:Maxim Integrated 数据总线宽度:8 bit 存储容量:1024 Kbit 组织:128 K x 8 接口类型:Parallel 访问时间:70 ns 电源电压-最大:5.5 V 电源电压-最小:4.5 V 工作电流:85 mA 最大工作温度:+ 70 C 最小工作温度:0 C 封装 / 箱体:EDIP 封装:Tube |
| STK14CA8-NF25TR | 功能描述:NVRAM 128Kbx8 AutoStore RoHS:否 制造商:Maxim Integrated 数据总线宽度:8 bit 存储容量:1024 Kbit 组织:128 K x 8 接口类型:Parallel 访问时间:70 ns 电源电压-最大:5.5 V 电源电压-最小:4.5 V 工作电流:85 mA 最大工作温度:+ 70 C 最小工作温度:0 C 封装 / 箱体:EDIP 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。