参数资料
型号: STM32F103C6T7XXX
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP48
封装: 7 X 7 MM, ROHS COMPLIANT, LQFP-48
文件页数: 7/80页
文件大小: 1067K
代理商: STM32F103C6T7XXX
STM32F103x4, STM32F103x6
Description
Doc ID 15060 Rev 3
in reset mode when VDD is below a specified threshold, VPOR/PDR, without the need for an
external reset circuit.
The device features an embedded programmable voltage detector (PVD) that monitors the
VDD/VDDA power supply and compares it to the VPVD threshold. An interrupt can be
generated when VDD/VDDA drops below the VPVD threshold and/or when VDD/VDDA is higher
than the VPVD threshold. The interrupt service routine can then generate a warning
message and/or put the MCU into a safe state. The PVD is enabled by software.
VPOR/PDR and VPVD.
2.3.11
Voltage regulator
The regulator has three operation modes: main (MR), low power (LPR) and power down.
MR is used in the nominal regulation mode (Run)
LPR is used in the Stop mode
Power down is used in Standby mode: the regulator output is in high impedance: the
kernel circuitry is powered down, inducing zero consumption (but the contents of the
registers and SRAM are lost)
This regulator is always enabled after reset. It is disabled in Standby mode, providing high
impedance output.
2.3.12
Low-power modes
The STM32F103xx performance line supports three low-power modes to achieve the best
compromise between low power consumption, short startup time and available wakeup
sources:
Sleep mode
In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can
wake up the CPU when an interrupt/event occurs.
Stop mode
The Stop mode achieves the lowest power consumption while retaining the content of
SRAM and registers. All clocks in the 1.8 V domain are stopped, the PLL, the HSI RC
and the HSE crystal oscillators are disabled. The voltage regulator can also be put
either in normal or in low power mode.
The device can be woken up from Stop mode by any of the EXTI line. The EXTI line
source can be one of the 16 external lines, the PVD output, the RTC alarm or the USB
wakeup.
Standby mode
The Standby mode is used to achieve the lowest power consumption. The internal
voltage regulator is switched off so that the entire 1.8 V domain is powered off. The
PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering
Standby mode, SRAM and register contents are lost except for registers in the Backup
domain and Standby circuitry.
The device exits Standby mode when an external reset (NRST pin), an IWDG reset, a
rising edge on the WKUP pin, or an RTC alarm occurs.
Note:
The RTC, the IWDG, and the corresponding clock sources are not stopped by entering Stop
or Standby mode.
相关PDF资料
PDF描述
STM32F103R6H7ATR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PBGA64
STM32F103C4T6ATR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP48
STM32F103C4T6TR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP48
STM32F103R6T7AXXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP64
STM32F103R6H6ATR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PBGA64
相关代理商/技术参数
参数描述
STM32F103C6U6A 功能描述:ARM微控制器 - MCU 32-Bit Cortex 64Kb PERFORMANCE LINE RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
STM32F103C6U6ATR 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density performance line, ARM-based 32-bit MCU with 16 or 32 KB Flash, USB, CAN, 6 timers, 2 ADCs, 6 communication interfaces
STM32F103C6U6AXXX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density performance line, ARM-based 32-bit MCU with 16 or 32 KB Flash, USB, CAN, 6 timers, 2 ADCs, 6 communication interfaces
STM32F103C6U6TR 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density performance line, ARM-based 32-bit MCU with 16 or 32 KB Flash, USB, CAN, 6 timers, 2 ADCs, 6 communication interfaces
STM32F103C6U6XXX 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Low-density performance line, ARM-based 32-bit MCU with 16 or 32 KB Flash, USB, CAN, 6 timers, 2 ADCs, 6 communication interfaces