- 您现在的位置：买卖IC网 > PDF目录380771 > STM704TDS6F (意法半导体) 3V Supervisor with Battery Switchover PDF资料下载
参数资料
| 型号： | STM704TDS6F |
| 厂商： | 意法半导体 |
| 英文描述： | 3V Supervisor with Battery Switchover |
| 中文描述： | 3V的监控与电池切换 |
| 文件页数： | 11/31页 |
| 文件大小： | 194K |
| 代理商： | STM704TDS6F |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
11/31
STM690/704/795/802/804/805/806
Power-fail Input/Output (NOT available on STM795)
The Power-fail Input (PFI) is compared to an inter-
nal reference voltage (independent from the V
RST
comparator). If PFI is less than the power-fail
threshold (V
PFI
), the Power-Fail Output (PFO) will
go low. This function is intended for use as an un-
dervoltage detector to signal a failing power sup-
ply. Typically PFI is connected through an external
voltage divider (see
Figure 11., page 8
) to either
the unregulated DC input (if it is available) or the
regulated output of the V
CC
regulator. The voltage
divider can be set up such that the voltage at PFI
falls below V
PFI
several milliseconds before the
regulated V
CC
input to the STM690/704/795/802/
804/805/806 or the microprocessor drops below
the minimum operating voltage.
During battery back-up, the power-fail comparator
is turned off and PFO goes (or remains) low (see
Figure 14., page 11
). This occurs after V
CC
drops
below V
SW
(2.4V). When power returns, the pow-
er-fail comparator is enabled and PFO follows PFI.
If the comparator is unused, PFI should be con-
nected to V
SS
and PFO left unconnected. PFO
may be connected to MR on the STM704/806 so
that a low voltage on PFI will generate a reset out-
put.
Applications Information
These Supervisor circuits are not short-circuit pro-
tected. Shorting V
OUT
to ground - excluding pow-
er-up transients such as charging a decoupling
capacitor - destroys the device. Decouple both
V
CC
and V
BAT
pins to ground by placing 0.1μF ca-
pacitors as close to the device as possible.
Figure 14. Power-fail Comparator Waveform (STM690/704/802/804/805/806)
AI08861a
VCC
VRST
VSW (2.4V)
trec
RST
PFO
PFO follows PFI
PFO follows PFI
相关PDF资料 |
PDF描述 |
|---|---|
| STM704TM6E | 3V Supervisor with Battery Switchover |
| STM704TM6F | 3V Supervisor with Battery Switchover |
| STM795RDS6E | 3V Supervisor with Battery Switchover |
| STM795RDS6F | 3V Supervisor with Battery Switchover |
| STM795RM6E | 3V Supervisor with Battery Switchover |
相关代理商/技术参数 |
参数描述 |
|---|---|
| STM704TM6E | 功能描述:监控电路 3V Supervisor w/Battery Switchover RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| STM704TM6F | 功能描述:监控电路 4.40V w/Batt Switch RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| STM705 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5V Supervisor |
| STM705_10 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5 V supervisor |
| STM705ADS6E | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:5 V supervisor |
发布紧急采购，3分钟左右您将得到回复。