参数资料
| 型号： | SX8723CWLTDT |
| 厂商： | Semtech |
| 文件页数： | 9/67页 |
| 文件大小： | 0K |
| 描述： | IC DAS ADC 16BIT I2C/SRL |
| 标准包装： | 1 |
| 系列： | ZoomingADC™ |
| 类型： | 数据采集系统（DAS） |
| 输入类型： | 差分 |
| 输出类型： | 数字 |
| 接口： | I²C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 供应商设备封装： | 12-MLPD-EP（4x4） |
| 包装： | 标准包装 |
| 其它名称： | SX8723CWLTDTDKR |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页
www.semtech.com/products/
Page 17
ADVANCED COMMUNICATIONS & SENSING
DATASHEET
SX8723C
ZoomingADC for sensing data acquisition
Revision 1.01
January 2011
Semtech
6.4 Charge Pump
This block generates a supply voltage able to power the analog switch drive levels on the chip higher than VBATT if
necessary.
If VBATT voltage drops below 4.2V then the block should be activated. If VBATT voltage is greater than 4.2V then VBATT
may be switched straight through to the VPUMP output. If the charge pump is not activated then VPUMP = VBATT.
If control input bit MultForceOff = 1 in RegMode (address 0x70) register then the charge pump is disabled and VBATT is
permanently connected to VPUMP output.
If control input bit MultForceOn = 1 in RegMode register then the charge pump is permanently enabled. This overrides
MultForceOff bit in RegMode register.
An external capacitor is required on VPUMP pin. This capacitor should be large enough to ensure that generated
voltage is smooth enough to avoid affecting conversion accuracy but not so large that it gives an unacceptable settling
time. A recommended value is around 2.2nF.
6.5 RC Oscillator
This block provides the master clock reference for the chip. It produces a clock at 4 MHz which is divided internally in
order to generate the clock sources needed by the other blocks.
The oscillator technique is a low power relaxation design and it is designed to vary as little as possible over
temperature and supply voltage.
This oscillator is trimmed at manufacture chip test.
The RC oscillator will start up after a chip reset to allow the trimming values to be read and calibration registers and I2C
address set to their default fused values. Once this has been done, the oscillator will be shut down and the chip will
enter a sleep state while waiting for an I2C communication.
The worst case duration from reset ( or POR ) to the sleep state is 800us.
6.5.1 Wake-up from sleep
When the device is in sleep state, the RC oscillator will start up after a communication. The start up sequence for the RC
oscillator is 450us in worst case.
During this time, the internal blocs using the RC can not be used: no ADC conversion can be started.
Not
Recommended
for
New
Designs
相关PDF资料 |
PDF描述 |
|---|---|
| SX8723E083TDT | IC DAS PRESS/TEMP SENS 12MLPD |
| SX8724CWLTDT | IC DAS ADC 16BIT I2C/SRL |
| SX8724E082TDT | IC DAS PRESS/TEMP SENS 16MLPQ |
| SX8725CWLTDT | IC DAS ADC 16BIT I2C/SRL |
| SX8725E083TDT | IC DAS PRESS/TEMP SENS 12MLPD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SX8723E083TDT | 功能描述:IC DAS PRESS/TEMP SENS 12MLPD RoHS:是 类别:集成电路 (IC) >> 接口 - 传感器和探测器接口 系列:ZoomingADC™ 其它有关文件:Automotive Product Guide 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:74 系列:- 类型:触控式传感器 输入类型:数字 输出类型:数字 接口:JTAG，串行 电流 - 电源:100µA 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:管件 |
| SX8723E083TRT | 功能描述:IC DAS PRESSURE/TEMP SENS 12MLPD RoHS:是 类别:集成电路 (IC) >> 接口 - 传感器和探测器接口 系列:ZoomingADC™ 其它有关文件:Automotive Product Guide 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:74 系列:- 类型:触控式传感器 输入类型:数字 输出类型:数字 接口:JTAG，串行 电流 - 电源:100µA 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:管件 |
| SX8723S | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:ZoomingADC for sensing data acquisition |
| SX8723SWLTDT | 制造商:Semtech Corporation 功能描述:2 INPUTS ZOOMING ADC WITH SPI |
| SX8724 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:ZoomingADC? for Pressure and Temperature Sensing |
发布紧急采购，3分钟左右您将得到回复。