- 您现在的位置：买卖IC网 > PDF目录22163 > TC9401CPD (Microchip Technology)IC V-FREQ/FREQ-V CONV 14DIP PDF资料下载
参数资料
| 型号： | TC9401CPD |
| 厂商： | Microchip Technology |
| 文件页数： | 14/28页 |
| 文件大小： | 545K |
| 描述： | IC V-FREQ/FREQ-V CONV 14DIP |
| 标准包装： | 30 |
| 类型： | 电压至频率和频率至电压 |
| 频率 - 最大： | 100kHz |
| 全量程： | ±40ppm/°C |
| 线性： | ±0.02% |
| 安装类型： | 通孔 |
| 封装/外壳： | 14-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 14-PDIP |
| 包装： | 管件 |
| 其它名称： | 158-1141 158-1141-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
TC9400/9401/9402
DS21483D-page 14
?2007 Microchip Technology Inc.
6.0 F/V CONVERTER DESIGN
INFORMATION
6.1 Input/Output Relationships
The output voltage is related to the input frequency
(F
IN
) by the transfer equation:
EQUATION 6-1:
The response time to a change in F
IN
is equal to (R
INT
C
INT
). The amount of ripple on V
OUT
is inversely
proportional to C
INT
and the input frequency.
C
INT
can be increased to lower the ripple. Values of
1礔 to 100礔 are perfectly acceptable for low frequen-
cies.
When the TC9400 is used in the Single Supply mode,
V
REF
is defined as the voltage difference between Pin7
and Pin 2.
6.2 Input Voltage Levels
The input frequency is applied to the Threshold
Detector input (Pin 11). As discussed in the V/F circuit
section of this data sheet, the threshold of Pin 11 is
approximately (V
DD
+ V
SS
)/2 ?00mV. Pin 11s input
voltage range extends from V
DD
to about 2.5V below
the threshold. If the voltage on Pin 11 goes more than
2.5 volts below the threshold, the V/F mode start-up
comparator will turn on and corrupt the output voltage.
The Threshold Detector input has about 200mV of
hysteresis.
In ?V applications, the input voltage levels for the
TC9400 are ?00mV, minimum. If the frequency
source being measured is unipolar, such as TTL or
CMOS operating from a +5V source, then an AC
coupled level shifter should be used. One such circuit
is shown in Figure6-1(a).
The level shifter circuit in Figure6-1(b) can be used in
single supply F/V applications. The resistor divider
ensures that the input threshold will track the supply
voltages. The diode clamp prevents the input from
going far enough in the negative direction to turn on the
start-up comparator. The diodes forward voltage
decreases by 2.1mV/癈, so for high ambient
temperature operation, two diodes in series are
recommended.
FIGURE 6-1: Frequency Input Level Shifter.
V
OUT
= [V
REF
C
REF
R
INT
] F
IN
+5V
14
6 4
+5V
-5V
V
DD
1.0
11
33k?/DIV>
IN914
V
SS
DET
TC9400
(a) ?V Supply
(b) Single Supply
0.01礔
Frequency
Input
0V
GND
+8V to +15V
14
10k?/DIV>
4
+5V
V
DD
1.0
11
33k?/DIV>
IN914
V
SS
DET
TC9400
0.01礔
Frequency
Input
0V
0.1礔
10k?/DIV>
M?/DIV>
M?/DIV>
相关PDF资料 |
PDF描述 |
|---|---|
| RSM30DTBN-S189 | CONN EDGECARD 60POS R/A .156 SLD |
| ASM02DRAN | CONN EDGECARD 4POS .156 R/A |
| SDR2207-4R7ML | INDUCTOR POWER 4.7UH 8.5A SMD |
| IDT71256SA20Y | IC SRAM 256KBIT 20NS 28SOJ |
| VI-JW3-CX-F3 | CONVERTER MOD DC/DC 24V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TC9401EJD | 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube |
| TC9402 | 制造商:TELCOM 制造商全称:TelCom Semiconductor, Inc 功能描述:VOLTAGE-TO-FREQUENCY/FREQUENCY-TO-VOLTAGE CONVERTERS |
| TC9402CPD | 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube |
| TC9402CPD | 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER |
| TC9402CPD | 制造商:Microchip Technology Inc 功能描述:V/F Converter |
发布紧急采购，3分钟左右您将得到回复。