参数资料
型号: TC9401CPD
厂商: Microchip Technology
文件页数: 7/28页
文件大小: 545K
描述: IC V-FREQ/FREQ-V CONV 14DIP
标准包装: 30
类型: 电压至频率和频率至电压
频率 - 最大: 100kHz
全量程: ±40ppm/°C
线性: ±0.02%
安装类型: 通孔
封装/外壳: 14-DIP(0.300",7.62mm)
供应商设备封装: 14-PDIP
包装: 管件
其它名称: 158-1141
158-1141-ND
?2007 Microchip Technology Inc.
DS21483D-page 7
TC9400/9401/9402
2.6  Pulse Freq Out
This output is an open-drain N-channel FET, which
provides a pulse waveform whose frequency is propor-
tional to the input voltage. This output requires a pull-
up resistor and interfaces directly with MOS, CMOS,
and TTL logic (see Figure2-1).
2.7  Output Common
The sources of both the FREQ/2 OUT and the PULSE
FREQ OUT are connected to this pin. An output level
swing from the drain voltage to ground, or to the V
SS
supply, may be obtained by connecting this pin to the
appropriate point.
2.8  Freq/2 Out
This output is an open-drain N-channel FET, which
provides a square-wave one-half the frequency of the
pulse frequency output. The FREQ/2 OUT output will
change state on the rising edge of PULSE FREQ OUT.
This output requires a pull-up resistor and interfaces
directly with MOS, CMOS, and TTL logic.
2.9  Threshold Detector Input
In the V/F mode, this input is connected to the AMPLI-
FIER OUT output (Pin 12) and triggers a 3祍 pulse
when the input voltage passes through its threshold. In
the F/V mode, the input frequency is applied to this
input.
The nominal threshold of the detector is half way
between the power supplies, or (V
DD
 + V
SS
)/2 ?00
mV. The TC9400s charge balancing V/F technique is
not dependent on a precision comparator threshold,
because the threshold only sets the lower limit of the op
amp output. The op amps peak-to-peak output swing,
which determines the frequency, is only influenced by
external capacitors and by V
REF
.
2.10  Amplifier Out
This pin is the output stage of the operational amplifier.
During V/F operation, a negative going ramp signal is
available at this pin. In the F/V mode, a voltage
proportional to the frequency input is generated.
FIGURE 2-1:    Output Waveforms.
3ms
Typ.
1/f
F
OUT
F
OUT
/2
Amp Out
V
REF
0V
C
REF
C
INT
 
Note1: To adjust F
MIN
, set V
IN
 = 10mV and adjust the 50k?offset for 10Hz output.
2: To adjust F
MAX
, set V
IN
 = 10V and adjust R
IN
 or V
REF
 for 10kHz output.
3: To increase F
OUTMAX
 to 100kHz, change C
REF
 to 2pF and C
INT
 to 75pF.
4: For high performance applications, use high stability components for R
IN
, C
REF
. V
REF
 (metal film
resistors and glass capacitors). Also, separate output ground (Pin 9) from input ground (Pin 6).
相关PDF资料
PDF描述
RSM30DTBN-S189 CONN EDGECARD 60POS R/A .156 SLD
ASM02DRAN CONN EDGECARD 4POS .156 R/A
SDR2207-4R7ML INDUCTOR POWER 4.7UH 8.5A SMD
IDT71256SA20Y IC SRAM 256KBIT 20NS 28SOJ
VI-JW3-CX-F3 CONVERTER MOD DC/DC 24V 75W
相关代理商/技术参数
参数描述
TC9401EJD 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube
TC9402 制造商:TELCOM 制造商全称:TelCom Semiconductor, Inc 功能描述:VOLTAGE-TO-FREQUENCY/FREQUENCY-TO-VOLTAGE CONVERTERS
TC9402CPD 功能描述:电压频率转换及频率电压转换 V/F Converter RoHS:否 制造商:Texas Instruments 全标度频率:4000 KHz 线性误差:+/- 1 % FSR 电源电压-最大: 电源电压-最小: 最大工作温度:+ 85 C 最小工作温度:- 25 C 安装风格:Through Hole 封装 / 箱体:PDIP-14 封装:Tube
TC9402CPD 制造商:Microchip Technology Inc 功能描述:IC F/V-V/F CONVERTER
TC9402CPD 制造商:Microchip Technology Inc 功能描述:V/F Converter