- 您现在的位置：买卖IC网 > PDF目录98193 > TDA6650ATT/C3 (NXP SEMICONDUCTORS) SPECIALTY CONSUMER CIRCUIT, PDSO38 PDF资料下载
参数资料
| 型号： | TDA6650ATT/C3 |
| 厂商： | NXP SEMICONDUCTORS |
| 元件分类： | 消费家电 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO38 |
| 封装： | 4.40 MM, 0.50 MM PITCH, PLASTIC, MO-153, SOT510-1, TSSOP-38 |
| 文件页数： | 52/54页 |
| 文件大小： | 325K |
| 代理商： | TDA6650ATT/C3 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页当前第52页第53页第54页
TDA6650ATT_6651ATT_2
NXP B.V. 2007. All rights reserved.
Product data sheet
Rev. 02 — 2 February 2007
7 of 54
NXP Semiconductors
TDA6650ATT; TDA6651ATT
5 V mixer/oscillator and low noise PLL synthesizer
the reference divider ratio, depending on the step frequency selected. The crystal
oscillator requires a 4 MHz crystal in series with an 18 pF capacitor between pins XTAL1
and XTAL2.
The output of the phase comparator drives the charge pump and the loop amplier
section. This amplier has an on-chip high voltage drive transistor. Pin CP is the output of
the charge pump, and pin VT is the pin to drive the tuning voltage to the varicap diodes of
the oscillators and the tracking lters. The loop lter has to be connected between pins CP
and VT. The spurious signals introduced by the fractional divider are automatically
compensated by the spurious compensation block.
It is possible to drive the clock input of a digital demodulation IC from pin XTOUT with the
4 MHz signal from the crystal oscillator. This output is also used to output 1
2fdiv and fcomp
signals in a specic test mode (see Table 9). It is possible to switch off this output, which is
recommended when it is not used.
For test and alignment purposes, it is also possible to release the tuning voltage output by
selecting the sinking mode (see Table 9), and by applying an external voltage on pin VT.
In addition to the BS1 and BS2 output ports that are used for the band selection, there are
three general purpose ports BS3, BS4 and BS5. All ve ports are PMOS open-drain type,
each with 15 mA drive capability. The connection for port BS5 and the ADC input is
combined on one pin. It is not possible to use the ADC if port BS5 is used.
The AGC detector compares the level at the IF amplier output to a reference level which
is selected from 6 different levels via the I2C-bus. The time constant of the AGC can be
selected via the I2C-bus to cope with normal operation as well as with search operation.
When the output level on pin AGC is higher than the threshold VRMH, then bit AGC = 1.
When the output level on pin AGC is lower than the threshold VRML, then bit AGC = 0.
Between these two thresholds, bit AGC is not dened. The status of the AGC bit can be
7.2 I2C-bus voltage
The I2C-bus lines SCL and SDA can be connected to an I2C-bus system tied to 2.5 V,
3.3 V or 5 V. The choice of the bus input threshold voltages is made with pin BVS that can
be left open-circuit, connected to the supply voltage or to ground (see Table 5).
7.3 Phase noise, I2C-bus trafc and crosstalk
While the TDA6650ATT; TDA6651ATT is dedicated for hybrid terrestrial applications, the
low noise PLL will clean up the noise spectrum of the VCOs close to the carrier to reach
noise levels at 1 kHz offset from the carrier compatible with e.g. ISDB-T reception.
Table 5.
I2C-bus voltage selection
Pin BVS connection
Bus voltage
Logic level
LOW
HIGH
To ground
2.5 V
0 V to 0.75 V
1.75 V to 5.5 V
Open-circuit
3.3 V
0 V to 1.0 V
2.3 V to 5.5 V
To VCC
5 V
0 V to 1.5 V
3.0 V to 5.5 V
相关PDF资料 |
PDF描述 |
|---|---|
| TDA6811 | SPECIALTY CONSUMER CIRCUIT, PDIP18 |
| TDA6812-5 | 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDIP40 |
| TDA6920 | 7-CHANNEL, AUDIO/VIDEO SWITCH, PDIP18 |
| TDA6930S | AM, AUDIO/VIDEO DEMODULATOR, PDIP30 |
| TDA6930X | AM, AUDIO/VIDEO DEMODULATOR, PDSO28 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TDA6650TT | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
| TDA6650TT/C3 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
| TDA6650TT/C3/S2 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
| TDA6651 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
| TDA6651ATT | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog) |
发布紧急采购，3分钟左右您将得到回复。