- 您现在的位置：买卖IC网 > PDF目录19516 > TEA1506T/N1,118 (NXP Semiconductors)IC CTLR SMPS PS SW MODE 14SOIC PDF资料下载
参数资料
| 型号： | TEA1506T/N1,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 8/22页 |
| 文件大小： | 0K |
| 描述： | IC CTLR SMPS PS SW MODE 14SOIC |
| 标准包装： | 2,500 |
| 系列： | GreenChip™ II |
| 输出隔离： | 隔离 |
| 频率范围： | 25kHz ~ 175kHz |
| 输入电压： | 8.7 V ~ 20 V |
| 输出电压： | 650V |
| 功率（瓦特）： | 750mW |
| 工作温度： | -20°C ~ 145°C |
| 封装/外壳： | 14-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 14-SO |
| 包装： | 带卷 (TR) |
Philips Semiconductors
GreenChip ? II SMPS control IC
Demagnetization
The system will be in discontinuous conduction mode all
the time. The oscillator will not start a new primary stroke
until the secondary stroke has ended.
Demagnetization features a cycle-by-cycle output
short-circuit protection by immediately lowering the
frequency (longer off-time), thereby reducing the power
level.
Demagnetization recognition is suppressed during the first
t suppr time. This suppression may be necessary in
applications where the transformer has a large leakage
inductance, at low output voltages and at start-up.
If pin DEM is open-circuit or not connected, a fault
condition is assumed and the converter will stop operating
immediately. Operation will recommence as soon as the
fault condition is removed.
Minimum and maximum ‘on-time’
The minimum ‘on-time’ of the SMPS is determined by the
Leading Edge Blanking (LEB) time. The IC limits the
‘on-time’ to 50 μ s. When the system desires an ‘on-time’
longer than 50 μ s, a fault condition is assumed (e.g.
removed C i in Fig.12), the IC will stop switching and enter
the safe restart mode.
OverVoltage Protection (OVP)
An OVP mode is implemented in the GreenChip series.
This works for the TEA1506 by sensing the auxiliary
voltage via the current flowing into pin DEM during the
secondary stroke. The auxiliary winding voltage is a
well-defined replica of the output voltage. Any voltage
spikes are averaged by an internal filter.
If the output voltage exceeds the OVP trip level, an internal
counter starts counting subsequent OVP events. The
counter has been added to prevent incorrect OVP
detections which might occur during ESD or lightning
events. If the output voltage exceeds the OVP trip level a
few times and not again in a subsequent cycle, the internal
counter will count down with twice the speed compared
with counting-up. However, when typical 10 cycles of
subsequent OVP events are detected, the IC assumes a
true OVP and the OVP circuit switches the power
MOSFET off. Next, the controller waits until the UVLO
level is reached on pin V CC . When V CC drops to UVLO,
capacitor C VCC will be recharged to the V start level.
2003 Sep 09
8
Product speci?cation
TEA1506P; TEA1506AP;
TEA1506T; TEA1506AT
Regarding the TEA1506, the IC will not start switching
again. Subsequently, V CC will drop again to the UVLO
level, etc.
Operation only recommences when the V CC voltage drops
below a level of about 4.5 V.
Regarding the TEA1506A, when the V start level is reached,
switching starts again (safe restart mode) when the V start
level is reached. This process is repeated as long as the
OVP condition exists.
The output voltage V o(OVP) at which the OVP function trips,
can be set by the demagnetization resistor, R DEM :
V o ( OVP ) =
N s
N aux
where N s is the number of secondary turns and N aux is the
number of auxiliary turns of the transformer.
Current I (OVP)(DEM) is internally trimmed.
The value of R DEM can be adjusted to the turns ratio of the
transformer, thus making an accurate OVP possible.
相关PDF资料 |
PDF描述 |
|---|---|
| RBM10DCTS | CONN EDGECARD 20POS DIP .156 SLD |
| NMPD0103C | POWER OVER ETHERNET MODULE |
| R15P212S/X2/P/R6.4 | CONV DC/DC 2W 15VIN 12VOUT |
| NPH10S2415IC | CONV DC/DC 10W24VIN 15.1VOUT DIP |
| VE-BT0-CW-B1 | CONVERTER MOD DC/DC 5V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TEA1507 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:GreenChipII SMPS control IC |
| TEA1507P | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:GreenChipII SMPS control IC |
| TEA1507P/N1,112 | 功能描述:转换 - 电压电平 SMPS GREENCHIP II RoHS:否 制造商:Micrel 类型:CML/LVDS/LVPECL to LVCMOS/LVTTL 传播延迟时间:1.9 ns 电源电流:14 mA 电源电压-最大:3.6 V 电源电压-最小:3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MLF-8 |
| TEA1520 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:STARplug |
| TEA1520P | 制造商:STMicroelectronics 功能描述:NXP IC 8-PIN DIP |
发布紧急采购，3分钟左右您将得到回复。