- 您现在的位置：买卖IC网 > PDF目录98246 > TLE5250 (INFINEON TECHNOLOGIES AG) STEPPER MOTOR CONTROLLER, 3 A, PZFM15 PDF资料下载
参数资料
| 型号： | TLE5250 |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 运动控制电子 |
| 英文描述： | STEPPER MOTOR CONTROLLER, 3 A, PZFM15 |
| 封装： | PLASTIC, SIP-15 |
| 文件页数： | 18/22页 |
| 文件大小： | 142K |
| 代理商： | TLE5250 |
TLE 5250
Semiconductor Group
5
1998-02-01
Application
Two TLE 5250 drivers are required to operate a bipolar stepping motor. To implement
full-step operation, a squarewave voltage with the required stepping frequency is applied
to the phase input of the upper driver, and the same squarewave voltage, but offset in
phase by 90
°el, to the phase input of the lower driver. Motor-current limiting is produced
by a DC signal that is applied to both nominal-current inputs. In microstep operation the
nominal current tracks sinusoidally and synchronously with the required stepping
frequency. This produces a sinusoidal current in the motor windings to ensure very
smooth running and a high stepping frequency. If an instantaneous nominal value (sine
or cosine) is held on the second driver, it is possible to set a certain angle of rotation while
the motor is stationary. The motor current produced by this depends on nominal voltage
and sense resistance (normally 0.5
), i.e.
The actual voltage should be thoroughly filtered for precise current regulation, especially
in microstep operation. So the actual input is accessible, and an RC element is
necessary between the Sense output and Actual input. The resistance R
R should
correspond to the internal resistance of the nominal-current input-voltage source to
prevent additional voltage offset on the nominal/actual comparator.
Circuit Description
Outputs
Outputs Q1 and Q2 are fed by push-pull output stages. Four integrated free-wheeling
diodes referred to ground or the supply voltage protect the integrated circuit against
reverse voltages from an inductive load.
Enable and Phase
Outputs Q1 and Q2 can be disabled by a voltage V
Inh of ≤ 0.8 V on the Enable pin. The
sink transistors are enabled by V
Inh ≥ 2V.
The voltage on the Phase input determines the phase of the output current. Output Q1
acts as a sink for V
Ph ≤ 0.8 V and as a source for VPh ≥ 2V.
For output Q2 this is reversed: sink for V
Ph ≥ 2 V and source for VPh ≤ 0.8 V.
The sink transistors are chopped. Low signal on the Enable pin plus a clock signal on the
Phase pin enable readout of the multiplexer.
IM V
[]
Vnom V
[]
RS
[]
-----------------------
=
相关PDF资料 |
PDF描述 |
|---|---|
| TLE6208-3G | BRUSH DC MOTOR CONTROLLER, 1.2 A, PDSO14 |
| TLE6208-6G | BRUSH DC MOTOR CONTROLLER, 2 A, PDSO28 |
| TLE6210G | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO20 |
| TLE6266G | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| TLE6280GP | BRUSHLESS DC MOTOR CONTROLLER, PDSO36 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLE6208-3G | 功能描述:马达/运动/点火控制器和驱动器 Triple-Half-Bridge RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| TLE6208-3-G | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:Triple-Half-Bridge |
| TLE6208-3G_07 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:Triple Half Bridges Optimized for DC motor management applications |
| TLE62083GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Triple Half Bridge Motor Driver 14-Pin DSO 制造商:Infineon Technologies AG 功能描述:BODY BRIDGES - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MOTOR DRIVER SPI 14DSO |
| TLE6208-6 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:Hex-Half-Bridge / Double Six-Driver |
发布紧急采购，3分钟左右您将得到回复。