- 您现在的位置：买卖IC网 > PDF目录98246 > TLE6266G (INFINEON TECHNOLOGIES AG) SPECIALTY ANALOG CIRCUIT, PDSO28 PDF资料下载
参数资料
| 型号： | TLE6266G |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 模拟信号调理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| 封装： | 18 MM, PLASTIC, SOP-28 |
| 文件页数： | 14/50页 |
| 文件大小： | 1020K |
| 代理商： | TLE6266G |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
Datasheet TLE 6266 G
Version 2.21
21
July 29th, 2005
are depending on timing.(e.g. to switch on/off a LED after a certain number of cyclic HS
ON conditions). During the long open window the timebase test is not available.
To measure the internal cyclic timing, the SPI input bit 3 and 4 have to be set HIGH. Then
the HS3 switch is automatically enabled for 3 times during the closed window of the
watchdog (see Figure 7). A correct SPI input word (with IBit 3 and 4 set HIGH) has to
be read in first, to activate the timebase test. Due to he fact, that the input command gets
activated after the CSN LOW to HIGH transition, it takes t=tSYNC to activate the timebase
test. If this SPI input command is given within the open window, tSYNC=max 500ns. If the
command is given during closed window (this is not a watchdog trigger command) the
synchronisation tSYNC can last up to 500s.
Figure 7
Timebase Test Diagram
6.16
Flash program mode
To disable the watchdog feature a flash program mode is available. This mode is
selected by applying a voltage of 6.8V < VPWM < 7.2V at pin PWM. This is useful e.g. if
the flash-memory of the micro has to be programmed and therefore a regular watchdog
triggering is not possible. If the SPI is required in the flash program mode to change e.g.
the mode of the TLE6266, the first input telegram has to be “00000000”.
HS3
t
closed window (12 cycles)
OFF
ON
2cycl.
CSN
t
t
SYNC
SPI Input word with
timebase test
command
相关PDF资料 |
PDF描述 |
|---|---|
| TLE6280GP | BRUSHLESS DC MOTOR CONTROLLER, PDSO36 |
| TLE6361G | SWITCHING REGULATOR, 425 kHz SWITCHING FREQ-MAX, PDSO36 |
| TLE6363G | DUAL SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLE6365G | SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PDSO8 |
| TLE6387GV60 | 1 A SWITCHING CONTROLLER, 430 kHz SWITCHING FREQ-MAX, PDSO14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLE6266GNT | 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Shutdown 5V Automotive 28-Pin DSO |
| TLE6270R | 功能描述:基准电压& 基准电流 POWERTRAIN RoHS:否 制造商:STMicroelectronics 产品:Voltage References 拓扑结构:Shunt References 参考类型:Programmable 输出电压:1.24 V to 18 V 初始准确度:0.25 % 平均温度系数（典型值）:100 PPM / C 串联 VREF - 输入电压（最大值）: 串联 VREF - 输入电压（最小值）: 分流电流（最大值）:60 mA 最大工作温度:+ 125 C 封装 / 箱体:SOT-23-3L 封装:Reel |
| TLE6270RAUMA1 | 制造商:Infineon Technologies AG 功能描述:QUAD LOW SIDE INJECTOR DRIVER 制造商:Infineon Technologies AG 功能描述:ENGINECONTROL_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC DRIVER INJECTOR QUAD DSO-36 |
| TLE6280 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:3-Phase Bridge Driver IC |
| TLE6280GP | 功能描述:马达/运动/点火控制器和驱动器 GATE DRIVER ICS FOR EXTERNAL MOSFETS RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。