参数资料
型号: TLE6368R
厂商: Infineon Technologies
文件页数: 53/59页
文件大小: 0K
描述: IC PS SYSTEM MULTI VOLT PDSO-36
标准包装: 800
应用: 电源,汽车应用
输入电压: 5.5 V ~ 60 V
输出数: 3
输出电压: 2.6V,3.3V,5V
工作温度: -40°C ~ 150°C
安装类型: 表面贴装
封装/外壳: 36-BSSOP(0.433",11.00mm 宽)裸露焊盘
供应商设备封装: PG-DSO-36
包装: 带卷 (TR)
配用: DEMOBOARDTLE6368IN-ND - BOARD DEMO FOR TLE 6368
其它名称: SP000014666
TLE6368RNT
TLE6368RT
TLE 6368 / SONIC
5.2.5
Bootstrap capacitor (C BTP )
The voltage at the Bootstrap capacitor does not exceed 15V, a ceramic type with a
minimum of 2% of the buck output capacitance and voltage class 16V would be
sufficient.
5.2.6
External charge pump capacitors (C FLY , C CCP )
Out of the feedback voltage the charge pump generates a voltage between 8 and 10V.
The fly capacitor connected between C+ and C- is charged with the feedback voltage
level and discharged to achieve the (almost) double voltage level at CCP. C FLY is chosen
to 100nF and C CCP to 220nF, both ceramic types.
The connection of CCP to a voltage source of e.g. 7V (take care of the maximum
ratings!) via a diode improves the start-up behavior at very low battery voltage. The diode
with the cathode on CCP has to be used in order to avoid any influence of the voltage
source to the device’s operation and vice versa.
5.2.7
Input filter components for reduced EME (C I1 , C I2 , C I3 , L I , R Slew )
At the input of Buck converters a square wave current is observed causing
electromagnetical interference on the battery line. The emission to the battery line
consists on one hand of components of the switching frequency (fundamental wave) and
its harmonics and on the other hand of the high frequency components derived from the
current slope. For proper attenuation of those interferers a π -type input filter structure is
recommended which is built up with inductive (L I ) and capacitive components (C I1 , C I2 ,
C I3 ). The inductance can be chosen up to the value of the Buck converter inductance,
higher values might not be necessary, C I1 and C I3 should be ceramic types and for C I2 an
input capacitance with very low ESR should be chosen and placed as close to the input
of the Buck converter as possible.
Inexpensive input filters show due to their parasitics a notch filter characteristic, which
means basically that the lowpass filter acts from a certain frequency as a highpass filter
and means further that the high frequency components are not attenuated properly. For
that reason the TLE 6368 G1 / SONIC offers the possibility of current slope adjustment.
The current transition time can be set by the external resistor (located on the SLEW pin)
to times between 20ns and 80ns by varying the resistor value between 0 ? (fastest
transition) and 20k ? (slowest transition).
5.2.8
Feedback circuit for minimum switching loss (R Boost , C Boost , D Boost )
To decrease the switching losses to a minimum the external components R Boost , C Boost
and D Boost are needed. The current though the feedback resistor R Boost is about a few mA
where the Diode D Boost and the capacitor C Boost run a part of the load current.
If this feature is not needed the three components are not needed and the Boost pin (33)
can be connected directly to the IN pins(32, 30).
Data Sheet
53
Rev. 2.2, 2006-12-01
相关PDF资料
PDF描述
TLE7368-3E IC PS SYSTEM MULTI VOLT PGDSO-36
TLV1117LV25DCYT IC REG LDO 2.5V 1A SOT223-4
TLV431BH6TA IC VREF SHUNT ADJ SC-70-6
TLV70018QDDCRQ1 IC REG LDO 1.8V .2A SOT23-5
TLV70430DBVT IC REG LDO 3V .15A SOT23-5
相关代理商/技术参数
参数描述
TLE6389 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:Step - Down DC/DC Controller
TLE6389_07 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:Step-Down DC/DC Controller
TLE6389-2G V50 功能描述:DC/DC 开关控制器 Step-Dwn DC/DC CTRLR 5V RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TLE63892GV 功能描述:DC/DC 开关控制器 DC/DC CONVERTER RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TLE6389-2GV 功能描述:DC/DC 开关控制器 Step-Dwn DC/DC CTRLR RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK