- 您现在的位置：买卖IC网 > PDF目录69494 > TLE7242-2G (INFINEON TECHNOLOGIES AG) SPECIALTY ANALOG CIRCUIT, PDSO28 PDF资料下载
参数资料
| 型号： | TLE7242-2G |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 模拟信号调理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| 封装： | GREEN, PLASTIC, DSO-28 |
| 文件页数： | 11/50页 |
| 文件大小： | 1210K |
| 代理商： | TLE7242-2G |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
Data Sheet
19
Rev. 1.0, 2008-07-09
TLE7242-2G
Functional Description and Electrical Characteristics
5.3.1
On-State Diagnostics
When the OUTx pin transitions high, the fault timers are cleared to 0 and the tested timer starts. If the tested timer
expires, the Bit SB-T (in the SPI register #9) is set to 1. If the OUTx pin transitions low, the tested timer is cleared
and then used for the off-state diagnostics.
If the analog SB fault signal (SB-FA) changes to 1, the fault filter timer starts. If the fault filter timer expires, the
digitally filtered SB fault signal (SB-FD) is set to one. If SB-FA changes to 0, SB-FD changes immediately to 0 and
the filter timer is cleared to 0.
A SB-FD=1 and SB-T=1 switches off the OUTx signal and the SB-F bit in the FAULT register will be set. The OUTx
pin remains in the off state until the fault retry PWM period counter expires.
If the SPI fault register is read, then the SB-F bit and the SB-FT bit in the FAULT register are cleared. Also, the
tested timer is cleared to 0.
The Short to Battery (SB) detection functions in both on/off and constant current mode. The SG-FD and OL-OFF-
FD signals are held to 0 while the OUTx pin is high.
If the TLE7242 2G IC is in ON/OFF mode, Open Load ON detection is disabled (OL-ON-F = 0).
If the TLE7242 2G IC is not in ON/OFF mode and the OUTx pin is high for 64 PWM periods, then open load fault
ON mode is detected and the OL-ON-F bit in the FAULT register is set. This bit will be cleared when a SPI fault
read occurs. If the OUTx pin remains in a high state, then the open load - on fault condition is detected again after
another 64 PWM cycles.
Figure 12
On-State Diagnostic Timing - Short to Vbat
PWM_Start
OUTx
Vpos
Load
Current
SB-T
SB-F
SPI READ
ADDR 9
Tested
Timer
Fault
Filter
Fault Retry Time
(Address #8)
Short to Vbat
Load
ok
short
Vsb
Tested
Timer
Fault
Filter
相关PDF资料 |
PDF描述 |
|---|---|
| TLE8242 | SPECIALTY ANALOG CIRCUIT, PQFP64 |
| TLE8386EL | 0.09 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLI4946-2L | MAGNETIC SENSOR, PSIP3 |
| TLI4946K | MAGNETIC SENSOR, PDSO3 |
| TLV431AIDBVR | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PDSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLE72422GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Constant Current Control 28-Pin DSO 制造商:Infineon Technologies AG 功能描述:TRANSMISSION_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC CURRENT SOURCE DSO28 |
| TLE7243SL | 功能描述:电源开关 IC - 配电 MC RELAY + LED RoHS:否 制造商:Exar 输出端数量:1 开启电阻（最大值）:85 mOhms 开启时间（最大值）:400 us 关闭时间（最大值）:20 us 工作电源电压:3.2 V to 6.5 V 电源电流（最大值）: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-5 |
| TLE7243SLFUMA1 | 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED - Tape and Reel |
| TLE7243SLXUMA2 | 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 0.26A 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 0.26A 24-Pin SSOP 制造商:Infineon Technologies AG 功能描述:IC DRIVER SPI 8CH LS 24SSOP |
| TLE7244SL | 功能描述:电源开关 IC - 配电 MC RELAY + LED RoHS:否 制造商:Exar 输出端数量:1 开启电阻（最大值）:85 mOhms 开启时间（最大值）:400 us 关闭时间（最大值）:20 us 工作电源电压:3.2 V to 6.5 V 电源电流（最大值）: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-5 |
发布紧急采购，3分钟左右您将得到回复。