- 您现在的位置：买卖IC网 > PDF目录19664 > TNY265P (Power Integrations)IC OFFLINE SWIT OTP OCP HV 8DIP PDF资料下载
参数资料
| 型号： | TNY265P |
| 厂商： | Power Integrations |
| 文件页数： | 7/22页 |
| 文件大小： | 0K |
| 描述： | IC OFFLINE SWIT OTP OCP HV 8DIP |
| 标准包装： | 3,000 |
| 系列： | TinySwitch®-II |
| 输出隔离： | 隔离 |
| 频率范围： | 124kHz ~ 140kHz |
| 输出电压： | 700V |
| 功率（瓦特）： | 11W |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | 8-DIP（0.300"，7.62mm），7 引线 |
| 供应商设备封装： | DIP-8B |
| 包装： | 管件 |
TNY263-268
C8 680 pF
Y1 Safety
Shield
T1
1
8
D5
1N5819
L2
3.3 μ H
+5V
D1
1N4005
D2
1N4005
R2
200 k Ω
C3
2.2 nF
4
5
C5
330 μ F
16 V
C6
100 μ F
35 V
R8
270 Ω
500 mA
RTN
D6
8 5-265
VAC
RF1
8.2 Ω
Fusible
C1
3.3 μ F
400 V
1N4937
C2
3.3 μ F
400 V
TinySwitch-II
U1
TNY264
D
S
EN/UV
BP
U2
LTV817
R9
47 Ω
Q1
2N3904
R7
100 Ω
R3
22 Ω
VR1
BZX79-
B3V9
D3
1N4005
D4
1N4005
R1
1.2 k Ω
C3
0.1 μ F
C7
10 μ F
10 V
3.9 V
L1
2.2 mH
R4
1.2 Ω
1/2 W
R6
1 Ω
1/2 W
PI-2706-021809
Figure 14. 2.5 W Constant Voltage, Constant Current Battery Charger with Universal Input (85-265 VAC).
reducing the no-load power consumption and improving full-
load ef ?ciency.
Current Limit Operation
Each switching cycle is terminated when the DRAIN current
reaches the current limit of the TinySwitch-II. Current limit
operation provides good line ripple rejection and relatively
constant power delivery independent of input voltage.
BYPASS Pin Capacitor
The BYPASS pin uses a small 0.1 μ F ceramic capacitor for
decoupling the internal power supply of the TinySwitch-II.
Application Examples
The TinySwitch-II is ideal for low cost, high ef ?ciency power
supplies in a wide range of applications such as cellular phone
chargers, PC standby, TV standby, AC adapters, motor
control, appliance control and ISDN or a DSL network
termination. The 132 kHz operation allows the use of a low
cost EE13 or EF12.6 core transformer while still providing good
ef ?ciency. The frequency jitter in TinySwitch-II makes it
possible to use a single inductor (or two small resistors for
under 3 W applications if lower ef ?ciency is acceptable) in
conjunction with two input capacitors for input EMI ?ltering.
The auto-restart function removes the need to oversize the
output diode for short circuit conditions allowing the design to
be optimized for low cost and maximum ef ?ciency. In charger
applications, it eliminates the need for a second optocoupler
and Zener diode for open loop fault protection. Auto-restart
www.powerint.com
also saves the cost of adding a fuse or increasing the power
rating of the current sense resistors to survive reverse battery
conditions. For applications requiring undervoltage lock out
(UVLO), such as PC standby, the TinySwitch-II eliminates
several components and saves cost. TinySwitch-II is well
suited for applications that require constant voltage and
constant current output. As TinySwitch-II is always powered
from the input high voltage, it therefore does not rely on bias
winding voltage. Consequently this greatly simpli?es designing
chargers that must work down to zero volts on the output.
2.5 W CV/CC Cell-Phone Charger
As an example, Figure 14 shows a TNY264 based 5 V,
0.5 A, cellular phone charger operating over a universal input
range (85 VAC to 265 VAC). The inductor (L1) forms a π-?lter
in conjunction with C1 and C2. The resistor R1 damps
resonances in the inductor L1. Frequency jittering operation of
TinySwitch-II allows the use of a simple π-?lter described
above in combination with a single low value Y1-capacitor (C8)
to meet worldwide conducted EMI standards. The addition of
a shield winding in the transformer allows conducted EMI to be
met even with the output capacitively earthed (which is the
worst case condition for EMI). The diode D6, capacitor C3
and resistor R2 comprise the clamp circuit, limiting the leakage
inductance turn-off voltage spike on the TinySwitch-II DRAIN
pin to a safe value. The output voltage is determined by the
sum of the optocoupler U2 LED forward drop (~1 V), and Zener
diode VR1 voltage. Resistor R8 maintains a bias current
through the Zener diode to ensure it is operated close to the
Zener test current.
7
Rev. H 02/09
相关PDF资料 |
PDF描述 |
|---|---|
| RW2-0509D/H2/B | CONV DC/DC 2W 4.5-9VIN +/-09VOUT |
| RW2-0505D/H2/B | CONV DC/DC 2W 4.5-9VIN +/-05VOUT |
| TNY265G-TL | IC OFFLINE SWIT OTP OCP HV 8SMD |
| VE-21Z-CW-F2 | CONVERTER MOD DC/DC 2V 40W |
| ATF1500A-10AC | IC CPLD 32 MACROCELL 10NS 44TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TNY265PG | 功能描述:交流/直流开关转换器 7.5 W (85-265 VAC) 11 W (230 VAC) RoHS:否 制造商:STMicroelectronics 输出电压:800 V 输入/电源电压（最大值）:23.5 V 输入/电源电压（最小值）:11.5 V 开关频率:115 kHz 电源电流:1.6 mA 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SSO-10 封装:Reel |
| TNY265PN | 功能描述:交流/直流开关转换器 7.5W 85-265 VAC 11W/230 VAC RoHS:否 制造商:STMicroelectronics 输出电压:800 V 输入/电源电压（最大值）:23.5 V 输入/电源电压（最小值）:11.5 V 开关频率:115 kHz 电源电流:1.6 mA 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SSO-10 封装:Reel |
| TNY265PN-TL | 制造商:POWERINT 制造商全称:Power Integrations, Inc. 功能描述:Enhanced, Energy Efficient, Low Power Off-line Switcher |
| TNY265PTL | 制造商:POWERINT 制造商全称:Power Integrations, Inc. 功能描述:Enhanced, Energy Efficient, Low Power Off-line Switcher |
| TNY266 | 制造商:POWERINT 制造商全称:Power Integrations, Inc. 功能描述:Generic PCB for DVD Player using TinySwitch-II |
发布紧急采购，3分钟左右您将得到回复。