- 您现在的位置：买卖IC网 > PDF目录98281 > TPS40074RHL (TEXAS INSTRUMENTS INC) 2 A SWITCHING CONTROLLER, 550 kHz SWITCHING FREQ-MAX, PQCC20 PDF资料下载
参数资料
| 型号： | TPS40074RHL |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2 A SWITCHING CONTROLLER, 550 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封装： | PLASTIC, QFN-20 |
| 文件页数： | 7/37页 |
| 文件大小： | 448K |
| 代理商： | TPS40074RHL |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
www.ti.com
ISCP u
COUT VOUT
tSTART
) ILOAD (A)
(7)
RILIM +
ISCP RDS(onMAX) ) VILIM (ofst)
IILIM
W
(8)
ISCP(max) +
IILIM(max) RILIM ) 50 mV
RDS(onMIN)
A
(9)
ISCP(min) +
IILIM(min) RILIM ) 10 mV
RDS(onMAX)
A
(10)
CILIM(max) +
VOUT 0.2
VIN RILIM fSW
(Farads)
(11)
TPS40074
SLUS617–APRIL 2005
APPLICATION INFORMATION (continued)
MOSFETs off. Seven soft-start cycles are initiated (without activity on the HDRV and LDRV outputs) and the
PWM is disabled during this period. The counter is decremented on each soft-start cycle. When the counter is
decremented to zero the PWM is re-enabled and the controller attempts to restart. If the fault has been removed
the output starts up normally. If the output fault is still present the counter counts seven overcurrent pulses and
re-enters the second tier fault mode. Refer to Figure 11 for typical fault protection waveforms.
The minimum short circuit limit threshold (ISCP) depends on tSTART,COUT,VOUT, and the load current at turn-on
(ILOAD).
The short circuit limit programming resistor (RILIM) is calculated from:
where
IILIM is the current into the ILIM pin (135 A typical)
VILIM(ofst) is the offset voltage of the ILIM comparator (-30 mV typical)
ISCP is the short-circuit protection current
RDS(on)MAX is the drain-to-source resistance of the high-side MOSFET
To find the range of the short circuit threshold values use the following equations.
The ILIM capacitor maximum value can be found from:
Note that this is a recommended maximum value. If a smaller value can be used, it should be to improve
protection. For most applications, consider using half the maximum value shown in Equation 11.
15
相关PDF资料 |
PDF描述 |
|---|---|
| TPS40075RHLR | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS40075RHLTG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC20 |
| TPS40077PWPR | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40077PWPRG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40077PWPG4 | 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS40074RHLR | 功能描述:DC/DC 开关控制器 Mid Input Sync Buck w/Vltg Feed-Fwd RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40074RHLRG4 | 功能描述:DC/DC 开关控制器 Mid Input Sync Buck w/Vltg Feed-Fwd RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40074RHLT | 功能描述:DC/DC 开关控制器 Mid Input Sync Buck w/Vltg Feed-Fwd RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40074RHLTG4 | 功能描述:DC/DC 开关控制器 Mid Input Sync Buck w/Vltg Feed-Fwd RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40075 | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5V TO 18V INPUT 10 PIN SYNCHRONOUS BUCK CONTROLLER WITH POWER GOOD |
发布紧急采购，3分钟左右您将得到回复。