参数资料
| 型号： | TPS51217DSCR |
| 厂商： | Texas Instruments |
| 文件页数： | 14/29页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM 10-SON |
| 标准包装： | 1 |
| 系列： | D-CAP™ |
| PWM 型： | 控制器 |
| 输出数： | 1 |
| 频率 - 最大： | 368kHz |
| 占空比： | 89% |
| 电源电压： | 4.5 V ~ 6.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 标准包装 |
| 其它名称： | 296-28856-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
SLUS947B – JUNE 2009 – REVISED APRIL 2012
LIGHT LOAD CONDITION IN AUTO-SKIP OPERATION
The TPS51217 automatically reduces switching frequency at light load conditions to maintain high efficiency. As
the output current decreases from heavy load condition, the inductor current is also reduced and eventually
comes to the point that its rippled valley touches zero level, which is the boundary between continuous
conduction and discontinuous conduction modes. The rectifying MOSFET is turned off when this zero inductor
current is detected. As the load current further decreases, the converter runs in to discontinuous conduction
mode. The on-time is kept almost the same as it was in the continuous conduction mode so that it takes longer
time to discharge the output capacitor with smaller load current to the level of the reference voltage. The
transition point to the light load operation I O(LL) (i.e., the threshold between continuous and discontinuous
2 ′ L ′ f SW IN
V
I O ( LL ) =
where
′
1 (V IN - V OUT ) ′ V OUT
?
f SW is the PWM switching frequency (340 kHz)
(3)
Switching frequency versus output current in the light load condition is a function of L, V IN and V OUT , but it
decreases almost proportional to the output current from the I O(LL) given in Equation 3 . For example, it is 68 kHz
at I O(LL) /5.
ADAPTIVE ZERO CROSSING
The TPS51217 has an adaptive zero crossing circuit which performs optimization of the zero inductor current
detection at skip mode operation. This function pursues ideal low-side MOSFET turning off timing and
compensates inherent offset voltage of the ZC comparator and delay time of the ZC detection circuit. It prevents
SW-node swing-up caused by too late detection and minimizes diode conduction period caused by too early
detection. As a result, better light load efficiency is delivered.
OUTPUT DISCHARGE CONTROL
When EN is low, the TPS51217 discharges the output capacitor using internal MOSFET connected between SW
and GND while high-side and low-side MOSFETs are kept off. The current capability of this MOSFET is limited to
discharge slowly.
LOW-SIDE DRIVER
The low-side driver is designed to drive high current low R DS(on) N-channel MOSFET(s). The drive capability is
represented by its internal resistance, which are 1.0 ? for V5IN to DRVL and 0.5 ? for DRVL to GND. A dead time
to prevent shoot through is internally generated between high-side MOSFET off to low-side MOSFET on, and
low-side MOSFET off to high-side MOSFET on. 5-V bias voltage is delivered from V5IN supply. The
instantaneous drive current is supplied by an input capacitor connected between V5IN and GND. The average
drive current is equal to the gate charge at Vgs=5V times switching frequency. This gate drive current as well as
the high-side gate drive current times 5V makes the driving power which need to be dissipated from TPS51217
package.
HIGH-SIDE DRIVER
The high-side driver is designed to drive high current, low R DS(on) N-channel MOSFET(s). When configured as a
floating driver, 5 V of bias voltage is delivered from V5IN supply. The average drive current is also equal to the
gate charge at Vgs = 5V times switching frequency. The instantaneous drive current is supplied by the flying
capacitor between VBST and SW pins. The drive capability is represented by its internal resistance, which are
1.5 ? for VBST to DRVH and 0.7 ? for DRVH to SW.
14
Copyright ? 2009–2012, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| AHA226M63F24B-F | CAP ALUM 22UF 63V 20% SMD |
| RCC49DRTS | CONN EDGECARD 98POS DIP .100 SLD |
| HMC08DRYI-S13 | CONN EDGECARD 16POS .100 EXTEND |
| HBC22DRTN-S13 | CONN EDGECARD 44POS .100 EXTEND |
| AHA106M2AF24B-F | CAP ALUM 10UF 100V 20% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS51217DSCT | 功能描述:DC/DC 开关控制器 3-28V Input 20A Synch St Down Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS51217EVM-533 | 功能描述:电源管理IC开发工具 TPS51217 Eval Module RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS51218 | 制造商:TI 制造商全称:Texas Instruments 功能描述:HIGH PERFORMANCE, SINGLE SYNCHRONOUS STEP-DOWN CONTROLLER FOR NOTEBOOK POWER SUPPLY |
| TPS51218DSCR | 功能描述:DC/DC 开关控制器 3-28V In,20A Synch Step Down Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS51218DSCT | 功能描述:DC/DC 开关控制器 3-28V In,20A Synch Step Down Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
发布紧急采购，3分钟左右您将得到回复。