- 您现在的位置：买卖IC网 > PDF目录69512 > TPS54620RGYR (TEXAS INSTRUMENTS INC) 11 A SWITCHING REGULATOR, 1760 kHz SWITCHING FREQ-MAX, PQCC14 PDF资料下载
参数资料
| 型号： | TPS54620RGYR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 11 A SWITCHING REGULATOR, 1760 kHz SWITCHING FREQ-MAX, PQCC14 |
| 封装： | 3.50 X 3.50 MM, GREEN, PLASTIC, MO-241BA, VQFN-14 |
| 文件页数： | 10/44页 |
| 文件大小： | 1827K |
| 代理商： | TPS54620RGYR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
VSENSE
COMP
VOUT
R1
R3
C1
C2
R2
Coea
Roea
gm
1300 mA/V
0.8 V
PowerStage
PH
RESR
CO
RL
b
a
c
16 A/V
SLVS949C
– MAY 2009 – REVISED MAY 2011
While the low-side MOSFET is turned on its conduction current is monitored by the internal circuitry. During
normal operation the low-side MOSFET sources current to the load. At the end of every clock cycle, the low-side
MOSFET sourcing current is compared to the internally set low-side sourcing current limit. If the low-side
sourcing current is exceeded the high-side MOSFET is not turned on and the low-side MOSFET stays on for the
next cycle. The high-side MOSFET is turned on again when the low-side current is below the low-side sourcing
current limit at the start of a cycle.
The low-side MOSFET may also sink current from the load. If the low-side sinking current limit is exceeded the
low-side MOSFET is turned off immediately for the rest of that clock cycle. In this scenario both MOSFETs are
off until the start of the next cycle.
Thermal Shutdown
The internal thermal shutdown circuitry forces the device to stop switching if the junction temperature exceeds
175
°C typically. The device reinitiates the power up sequence when the junction temperature drops below 165°C
typically.
Small Signal Model for Loop Response
Figure 30 shows an equivalent model for the device control loop which can be modeled in a circuit simulation
program to check frequency response and transient responses. The error amplifier is a transconductance
amplifier with a gm of 1300
μA/V. The error amplifier can be modeled using an ideal voltage controlled current
source. The resistor Roea (2.38 M
) and capacitor Coea (20.7 pF) model the open loop gain and frequency
response of the error amplifier. The 1-mV ac voltage source between the nodes a and b effectively breaks the
control loop for the frequency response measurements. Plotting a/c and c/b show the small signal responses of
the power stage and frequency compensation respectively. Plotting a/b shows the small signal response of the
overall loop. The dynamic loop response can be checked by replacing the RL with a current source with the
appropriate load step amplitude and step rate in a time domain analysis.
Figure 30. Small Signal Model for Loop Response
Simple Small Signal Model for Peak Current Mode Control
Figure 31 is a simple small signal model that can be used to understand how to design the frequency
compensation. The device power stage can be approximated to a voltage controlled current source (duty cycle
modulator) supplying current to the output capacitor and load resistor. The control to output transfer function is
shown in Equation 10 and consists of a dc gain, one dominant pole and one ESR zero. The quotient of the
change in switch current and the change in COMP pin voltage (node c in Figure 30) is the power stage
transconductance (gmps) which is 16 A/V for the device. The DC gain of the power stage is the product of gmps
and the load resistance
L) as shown in Equation 11 with resistive loads. As the load current increases, the DC
gain decreases. This variation with load may seem problematic at first glance, but fortunately the dominant pole
moves with load current (see Equation 12). The combined effect is highlighted by the dashed line in Figure 32.
As the load current decreases, the gain increases and the pole frequency lowers, keeping the 0-dB crossover
frequency the same for the varying load conditions which makes it easier to design the frequency compensation.
18
Copyright
2009–2011, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| TPS54673PWPR | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54673PWP | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54673PWPG4 | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54673PWPRG4 | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54900PWG4 | SPECIALTY ANALOG CIRCUIT, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS54620RGYT | 功能描述:直流/直流开关调节器 4.5-17Vin 6A Synch St Down SWIFT Cnvtr RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS54620RGYT-P | 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述: |
| TPS54620RHLR | 功能描述:直流/直流开关转换器 4.5-17Vin,6A Syn Step Down Cnvrtr RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS54620RHLT | 功能描述:直流/直流开关转换器 4.5-17Vin,6A Syn Step Down Cnvrtr RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS54622 | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5V to 17V Input, 6A Synchronous Step Down SWIFT? Converter With Hiccup |
发布紧急采购，3分钟左右您将得到回复。