参数资料
| 型号： | TPS62125DSGT |
| 厂商： | Texas Instruments |
| 文件页数： | 22/38页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 0.3A 8WSON |
| 标准包装： | 1 |
| 系列： | DCS-Control™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.2 V ~ 10 V |
| 输入电压： | 3 V ~ 17 V |
| PWM 型： | 混合物 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 300mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘 |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-WSON 裸露焊盘（2x2） |
| 其它名称： | 296-30461-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
SLVSAQ5C – MARCH 2012 – REVISED DECEMBER 2013
ENABLE COMPARATOR (EN / EN_hys)
The EN pin is connected to an On/Shutdown detector (ON/SD) and an input of the Enable Comparator. With a
voltage level of 0.4V or less at the EN pin, the ON/SD detector turns the device into Shutdown mode and the
quiescent current is reduced to typically 350nA. In this mode the EN comparator as well the entire internal-control
circuitry are switched off. A voltage level of typ. 900mV (rising) at the EN pin triggers the ON/Shutdown detector
and activates the internal reference VREF (Typ.1.2V), the EN comparator and the UVLO comparator. In
applications with slow rising voltage levels at the EN pin, the quiescent current profile before this trip point needs
to be considered, see Figure 27 . Once the ON/SD detector has tripped, the quiescent current consumption of the
device is typ. 6μA. The TPS62125 starts regulation once the voltage at the EN pin trips the threshold V EN_TH ON
(typ. 1.2V) and the input voltage is above the UVLO threshold. It enters softstart and ramps up the output
voltage. For proper operation, the EN pin must be terminated and must not be left floating. The quiescent current
consumption of the TPS62125 is typ. 13μA under no load condition (not switching). See Figure 25 . The DC/DC
regulator stops operation once the voltage on the EN pin falls below the threshold V EN_TH OFF (typ. 1.15V) or the
input voltage falls below UVLO threshold. The enable comparator features a built in hysteresis of typ. 50mV. This
hysteresis can be increased with an external resistor connected to pin EN_hys. See more details in application
information section.
POWER GOOD OUTPUT / OUTPUT DISCHARGE (PG)
The Power Good Output (PG pin) is an open drain output. The circuit is active once the device is enabled. It is
driven by an internal comparator connected to the FB pin voltage and an internal reference. The PG output
provides a high level (open drain high impedance) once the feedback voltage exceeds typical 95% of its nominal
value. The PG output is driven to low level once the FB pin voltage falls below typ. 90% of its nominal value
V REF_FB . The PG output goes high (high impedance) with a delay of typically 2μs. A pull up resistor is needed to
generate a high level. The PG pin can be connected via a pull up resistors to a voltage up to 10V. This pin can
also be used to discharge the output capacitor. See section Application Information for more details.
The PG output is pulled low if the voltage on the EN pin falls below the threshold V EN_TH
OFF
or the input voltage
is below the undervoltage lockout threshold UVLO.
SHORT-CIRCUIT PROTECTION
The TPS62125 integrates a high-side MOSFET switch current limit, I LIMF , to protect the device against a short
circuit. The current in the high-side MOSFET switch is monitored by a current limit comparator and once the
current reaches the limit of I LIMF , the high-side MOSFET switch is turned off and the low-side MOSFET switch is
turned on to ramp down the inductor current. The high-side MOSFET switch is turned on again once the zero
current comparator trips and the inductor current has become zero. In this case, the output current is limited to
half of the high-side MOSFET switch current limit, ? I LIMF , typ. 300mA.
THERMAL SHUTDOWN
As soon as the junction temperature, T J , exceeds 150°C (typical) the device goes into thermal shutdown. In this
mode, the high-side and low-side MOSFETs are turned-off. The device continues its operation when the junction
temperature falls below the thermal shutdown hysteresis.
22
Copyright ? 2012–2013, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| TPS62237DRYT | IC REG BUCK SYNC 3.3V 0.5A 6SON |
| TPS62239DRYR | IC REG BUCK SYNC 1V 0.5A 6SON |
| TPS62410DRCTG4 | IC REG BUCK SYNC ADJ 0.8A 10SON |
| TPS63061DSCT | IC REG BUCK BST SYNC 5V 1A 10SON |
| TPS65217CRSLR | IC PMIC BATT PWR SYST 48VQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62125EVM-044 | 功能描述:电源管理IC开发工具 TPS62125EVM-044 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS6213013AQRGTRQ1 | 功能描述:IC REG BUCK 1.3V 3A 16VFQFN 制造商:texas instruments 系列:汽车级，AEC-Q100，DCS-Control? 包装:剪切带（CT） 零件状态:在售 功能:降压 输出配置:正 拓扑:降压 输出类型:固定 输出数:1 电压 - 输入（最小值）:3V 电压 - 输入（最大值）:17V 电压 - 输出（最小值/固定）:1.3V 电压 - 输出（最大值）:- 电流 - 输出:3A 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:16-VFQFN 裸露焊盘 供应商器件封装:16-QFN（3x3） 标准包装:1 |
| TPS6213013AQRGTTQ1 | 功能描述:IC REG BUCK 1.3V 3A 16VQFN 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:在售 功能:降压 输出配置:正 拓扑:降压 输出类型:固定 输出数:1 电压 - 输入（最小值）:3V 电压 - 输入（最大值）:17V 电压 - 输出（最小值/固定）:1.3V 电压 - 输出（最大值）:- 电流 - 输出:3A 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:16-VFQFN 裸露焊盘 供应商器件封装:16-QFN（3x3） 标准包装:1 |
| TPS62130AQRGTRQ1 | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.9V 1 Output 3A 16-VFQFN Exposed Pad 制造商:texas instruments 系列:汽车级，AEC-Q100，DCS-Control? 包装:剪切带（CT） 零件状态:有效 功能:降压 输出配置:正 拓扑:降压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:3V 电压 - 输入（最大值）:17V 电压 - 输出（最小值/固定）:0.9V 电压 - 输出（最大值）:6V 电流 - 输出:3A 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:16-VFQFN 裸露焊盘 供应商器件封装:16-QFN（3x3） 标准包装:1 |
| TPS62130AQRGTTQ1 | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.9V 1 Output 3A 16-VFQFN Exposed Pad 制造商:texas instruments 系列:汽车级，AEC-Q100，DCS-Control? 包装:剪切带（CT） 零件状态:有效 功能:降压 输出配置:正 拓扑:降压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:3V 电压 - 输入（最大值）:17V 电压 - 输出（最小值/固定）:0.9V 电压 - 输出（最大值）:6V 电流 - 输出:3A 频率 - 开关:2.5MHz 同步整流器:是 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:16-VFQFN 裸露焊盘 供应商器件封装:16-QFN（3x3） 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。