参数资料
型号: TPS63031DSKT
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10
封装: 2.50 X 2.50 MM, PLASTIC, SON-10
文件页数: 7/24页
文件大小: 1326K
代理商: TPS63031DSKT
I
1 +
I
OUT
0.8 )
V
OUT VIN1 * VOUT
2
V
IN1
f
L
(4)
I
2 +
V
OUT
I
OUT
0.8
V
IN2
)
V
IN2
V
OUT * VIN2
2
V
OUT
f
L
(5)
CAPACITOR SELECTION
Input Capacitor
Bypass Capacitor
Output Capacitor
C
OUT + 5
L
mF
mH
(6)
www.ti.com.................................................................................................................................................. SLVS696A – OCTOBER 2008 – REVISED MARCH 2009
With the chosen inductance value, the peak current for the inductor in steady state operation can be calculated.
Equation 4 shows how to calculate the peak current I1 in step down mode operation and Equation 5 shows how
to calculate the peak current I2 in boost mode operation.
In both equations f is the minimum switching frequency. VIN2 is the minimum input voltage. The critical current
value for selecting the right inductor is the higher value of I1 and I2. It also needs to be taken into account that
load transients and error conditions may cause higher inductor currents. This also needs to be taken into account
when selecting an appropriate inductor. The following inductor series from different suppliers have been used
with TPS6303x converters:
Table 1. List of Inductors
VENDOR
INDUCTOR SERIES
LPS3015
Coilcraft
EPL3010
Murata
LQH3NP
Tajo Yuden
NR3015
At least a 4.7
F input capacitor is recommended to improve transient behavior of the regulator and EMI
behavior of the total power supply circuit. A ceramic capacitor placed as close as possible to the VIN and PGND
pins of the IC is recommended.
To make sure that the internal control circuits are supplied with a stable low noise supply voltage, a capacitor can
be connected between VINA and GND. Using a ceramic capacitor with a value of 0.1
F is recommended. The
value of this capacitor should not be higher than 0.22
F.
For the output capacitor, it is recommended to use small ceramic capacitors placed as close as possible to the
VOUT and PGND pins of the IC. If, for any reason, the application requires the use of large capacitors which can
not be placed close to the IC, using a smaller ceramic capacitor in parallel to the large one is recommended.
This small capacitor should be placed as close as possible to the VOUT and PGND pins of the IC.
To get an estimate of the recommended minimum output capacitance, Equation 6 can be used.
A capacitor with a value in the range of the calculated minimum should be used. This is required to maintain
control loop stability. There are no additional requirements regarding minimum ESR. There is also no upper limit
for the output capacitance value. Larger capacitors will cause lower output voltage ripple as well as lower output
voltage drop during load transients.
Copyright 2008–2009, Texas Instruments Incorporated
15
Product Folder Link(s): TPS63030 TPS63031
相关PDF资料
PDF描述
TPS63030DSKRG4 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10
TPS63031DSK 1.1 A SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PDSO10
TPS63700DRC 1.14 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10
TPS64201DBVT 0.15 A SWITCHING CONTROLLER, PDSO6
TPS64202DBVR 0.15 A SWITCHING CONTROLLER, PDSO6
相关代理商/技术参数
参数描述
TPS63031DSKTG4 功能描述:直流/直流开关调节器 Hi Eff Sgl Inductor Buck-Boost Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS63036EVM-163 制造商:Texas Instruments 功能描述:TPS63036EVM-163 制造商:Texas Instruments 功能描述:TPS63036EVM-163 - Boxed Product (Development Kits) 制造商:Texas Instruments 功能描述:EVAL MODULE FOR TPS63036-163 制造商:Texas Instruments 功能描述:TPS63036 Eval Mod
TPS63036YFGR 制造商:Texas Instruments 功能描述:IC REG BUCK BST SYNC ADJ 8WCSP
TPS63036YFGT 功能描述:直流/直流开关转换器 Hi Eff Sgl Inductor Buck-Boost Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TPS63050EVM-180 功能描述:TPS63050 - DC/DC, Step Up or Down 1, Non-Isolated Outputs Evaluation Board 制造商:texas instruments 系列:- 零件状态:有效 主要用途:DC/DC,步升/步降 输出和类型:1,非隔离 功率 - 输出:- 电压 - 输出:3.3V 电流 - 输出:500mA 电压 - 输入:2.5 V ~ 5.5 V 稳压器拓扑:降压-升压 频率 - 开关:2.5MHz 板类型:完全填充 所含物品:板 使用的 IC/零件:TPS63050 标准包装:1