- 您现在的位置：买卖IC网 > PDF目录69522 > TPS65101PWP (TEXAS INSTRUMENTS INC) 2.6 A SWITCHING REGULATOR, 2100 kHz SWITCHING FREQ-MAX, PDSO24 PDF资料下载
参数资料
| 型号： | TPS65101PWP |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2.6 A SWITCHING REGULATOR, 2100 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封装： | GREEN, PLASTIC, HTSSOP-24 |
| 文件页数： | 10/30页 |
| 文件大小： | 1213K |
| 代理商： | TPS65101PWP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
www.ti.com
V
= -V
x
OUT
REF
= -1.213 V x
R
3
R
4
R3 = R4 x
= R4 x
|VOUT|
VREF
1.213
SLVS496C – SEPTEMBER 2003 – REVISED APRIL 2006
Figure 22. Optimum, Rc Is Ideal
Negative Charge Pump
The negative charge pump provides a regulated output voltage by inverting the main output voltage VO1. The
negative charge pump output voltage is set with external feedback resistors.
The maximum load current of the negative charge pump depends on the voltage drop across the external
Schottky diodes, the internal on resistance of the charge pump MOSFETS Q8 and Q9, and the impedance of
the flying capacitor C12. When the voltage drop across these components is larger than the voltage difference
from VO1 to VO2, the charge pump is in dropout, providing the maximum possible output current. Therefore, the
higher the voltage difference between VO1 and VO2, the higher the possible load current. See Figure 12 for the
possible output current versus boost converter voltage VO1.
V
O(min) = -(VO - 2 VD - Io (2 x rDS(on)Q8 + 2 x rDS(on)Q9 + Xcfly))
Setting the output voltage:
The lower feedback resistor value R4 should be in a range between 40 k
to 120 k or the overall feedback
resistance should be within 500 k
to 1 M. Smaller values load the reference too heavily and larger values
may cause stability problems. The negative charge pump requires two external Schottky diodes. The peak
current rating of the Schottky diode has to be twice the load current of the output. For a 20-mA output current,
the dual Schottky diode BAT54 or similar is a good choice.
Positive Charge Pump
The positive charge pump can be operated in a voltage doubler mode or a voltage tripler mode depending on
the configuration of the C2+ and C2-/MODE pins. Leaving the C2+ pin open and connecting C2-/MODE to GND
forces the positive charge pump to operate in a voltage doubler mode. If higher output voltages are required, the
positive charge pump can be operated as a voltage tripler. To operate the charge pump in the voltage tripler
mode, a flying capacitor needs to be connected to C2+ and C2-/MODE.
The maximum load current of the positive charge pump depends on the voltage drop across the internal
Schottky diodes, the internal on resistance of the charge pump MOSFETS, and the impedance of the flying
capacitor. When the voltage drop across these components is larger than the voltage difference VO1 x 2 to VO3
(doubler mode) or VO1 x 3 to VO3 (tripler mode), then the charge pump is in dropout, providing the maximum
possible output current. Therefore, the higher the voltage difference between VO1 x 2 (doubler) or VO1 x 3
(tripler) to VO3, the higher the possible load current. See Figure 13 and Figure 14 for the output current versus
boost converter voltage VO1 and the following calculations.
Voltage doubler:
VO3max = 2 x VO1 - (2 VD + 2 x Io x (2 x rDS(on)Q5 + rDS(on)Q3 + rDS(on)Q4 + XC1))
Voltage tripler:
VO3max = 3 x VO1 - (3 x VD + 2 x Io x (3 x rDS(on)Q5 + rDS(on)Q3 + rDS(on)Q4 + XC1 + XC2))
18
相关PDF资料 |
PDF描述 |
|---|---|
| TPS65120RGTR | 0.2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65120RGTTG4 | 0.2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65121RGT | 0.2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65120RGTRG4 | 0.2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS65121RGTR | 0.2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PQCC16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS65101PWPG4 | 功能描述:LCD 驱动器 Triple Output LCD Supply RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| TPS65101PWPR | 功能描述:LCD 驱动器 Triple Output LCD Supply RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| TPS65101PWPRG4 | 功能描述:LCD 驱动器 Triple Output LCD Supply RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| TPS65101RGER | 功能描述:LCD 驱动器 Triple Output LCD Supply RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| TPS65101RGERG4 | 功能描述:LCD 驱动器 Triple Output LCD Supply RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。