- 您现在的位置：买卖IC网 > PDF目录199480 > TSC8051C1XXX-12CGD 8-Bit Microcontroller for Digital Computer Monitors PDF资料下载
参数资料
| 型号： | TSC8051C1XXX-12CGD |
| 元件分类： | 8位微控制器 |
| 英文描述： | 8-Bit Microcontroller for Digital Computer Monitors |
| 中文描述： | 8位数字的电脑显示器微控制器 |
| 文件页数： | 26/31页 |
| 文件大小： | 321K |
| 代理商： | TSC8051C1XXX-12CGD |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页
TSC8051C1
Rev. D (14 Jan. 97)
4
MATRA MHS
5. Pin Description
VSS
Circuit ground.
VCC
Power supply voltage.
RST
A high level on this pin for two machine cycles while the
oscillator is running resets the device. An internal
pulldown resistor permits power–on reset using only a
capacitor connected to VCC.
PORT 0 (P0.0–P0.7)
Port 0 is an 8–bit open–drain bidirectional I/O port. Port
0 pins that have 1’s written to them float, and in that state
can be used as high–impedance inputs.
Port 0 is also the multiplexed low–order address and data
bus during access to external Program and Data memory.
In this application it uses strong internal pull–up when
emitting 1’s.
Port 0 can sink and source 8 LS TTL loads.
PORT 1 (P1.0–P1.7)
Port 1 is an 8–bit bidirectional I/O port with internal
pullups. Port 1 pins that have 1’s written to them are
pulled high by the internal pullups, and in that state can
be used as inputs. As inputs, Port 1 pins that are
externally being pulled low will source current (IIL on
the data–sheet) because of the internal pullups.
Port 1 also serves 4 programmable PWM open drain
outputs, as listed below:
Port Pin
Alternate Function
P1.0
PWM8: Pulse Width Modulation output 8.
P1.1
PWM9: Pulse Width Modulation output 9.
P1.2
PWM10: Pulse Width Modulation output 10.
P1.3
PWM11: Pulse Width Modulation output 11.
Port 1 can sink and source 3 LS TTL loads.
PORT 2 (P2.0–P2.7)
Port 2 is an 8–bit bidirectional I/O port with internal
pullups. Port 2 pins that have 1’s written to them are
pulled high by the internal pullups, and in that state can
be used as inputs. As inputs, Port 2 pins that are
externally being pulled low will source current (IIL on
the data–sheet) because of the internal pullups.
Port 2 emits the high–order 8–bit address during fetches
from external Program Memory and during accesses to
external Data Memory that use 16–bit addresses. In this
application it uses strong internal pull–up when emitting
1’s.
Port 2 can sink and source 3 LS TTL loads.
PORT 3 (P3.0–P3.7)
Port 3 is an 8–bit bidirectional I/O port with internal
pullups. Port 3 pins that have 1’s written to them are
pulled high by the internal pullups, and in that state can
be used as inputs. As inputs, Port 3 pins that are
externally being pulled low will source current (IIL on
the data–sheet) because of the internal pullups.
Each line on this port has 2 or 3 functions either a general
I/O or special control signal, as listed below:
Port Pin
Alternate Function
P3.0
RXD: serial input port.
P3.1
TXD: serial output port.
P3.2
INT0: external interrupt 0.
VSYNC: vertical synchro input.
P3.3
INT1: external interrupt 1.
VOUT: buffered V-SYNC output.
P3.4
T0: Timer 0 external input.
HSYNC: horizontal synchro input.
P3.5
T1: Timer 1 external input.
HOUT: buffered H–SYNC output.
P3.6
WR: external data memory write strobe.
SCL: serial port clock line I2C bus.
P3.7
RD: external data memory read strobe.
SDA: serial port data line I2C bus.
Port 3 can sink and source 3 LS TTL loads.
PWM0–7
These eight Pulse Width Modulation outputs are true
open drain outputs and are floating after reset.
ALE
The Address Latch Enable output signal occurs twice
each machine cycle except during external data memory
access. The negative edge of ALE strobes the address
into external data memory or program memory. ALE
can sink and source 8 LS TTL loads.
If desired, ALE operation can be disabled by setting bit
0 of SFR location AFh (MSCON). With the bit set, ALE
is active only during MOVX instruction and external
fetches. Otherwise the pin is pulled low.
相关PDF资料 |
PDF描述 |
|---|---|
| TSC8051C1XXX-12CGR | 8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-12IDD | 8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-12IDR | 8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-16CAR | 8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-16CBR | 8-Bit Microcontroller for Digital Computer Monitors |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSC8051C1XXX-12CGR | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-12CHB | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-12CHD | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-12CHR | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-Bit Microcontroller for Digital Computer Monitors |
| TSC8051C1XXX-12CIB | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-Bit Microcontroller for Digital Computer Monitors |
发布紧急采购，3分钟左右您将得到回复。