参数资料
型号: TSS461F
厂商: Atmel Corp.
英文描述: VAN Data Link Controller
中文描述: 凡数据链路控制器
文件页数: 19/57页
文件大小: 397K
代理商: TSS461F
19
7615A–AUTO–02/06
TSS461F
Diagnosis
System
The purpose of the diagnosis system is to detect any short or open circuits on either the DATA
or DATA lines and to permit, if it is possible, to carry the communications on the non-defective
line.
The diagnosis system is based on the assumption that three separate line receivers are con-
nected to the VAN bus (see Figure 3):
One of the line receivers is connected in differential mode, sensing both DATA and DATA
signals, and is connected to the RxD0 input.
The other two line receivers are operating in single wire mode and are sensing only one of
the two VAN bus signals:
The line receiver sensing DATA is connected to RxD1
The line receiver sensing DATA is connected to RxD2
The diagnosis system analyzes and compares the data sent over both VAN lines. So, the diag-
nosis system executes a digital filtering and transition analyses. In order to perform its
investigation, three internal signals are generated, RI (Return to Idle), SDC (Synchronous Diag-
nosis Clock) and TIP (Transmission In Progress).
One of four operating modes can be chosen to manage the results of the diagnosis system.
Diagnosis States
If the diagnosis system finds a failure on either of the VAN bus signals, it changes from nominal
to degraded mode, and connects the line receiver not coupled to the failing signal to the recep-
tion logic.
When the diagnosis system finds that the failing signal is working again, it returns to nominal
mode and re-connects the differential line receiver to the reception logic.
A major error occurs when both the VAN bus signals fail.
Figure 16.
Diagnosis States
Status bits give permanent information on the diagnosis performed, whatever the programmed
operating mode. This is encoded over three bits: Sa, Sb and Sc. Sa and Sb bits indicate the four
possible states of the VAN bus.
NONIMAL
MAJOR
ERROR
DEGRATED
DATA
DEGRATED
DATA
- Failure during the frame.
- Default of transitions on the valid input between 2 consecutive SDC rising edges.
- Protocol fault
- In specified selection mode, every RI pulse when an EOF is detected or through an active SDC.
- In automatic selection mode and SDC active, no failure sampled by 2 consecutive SDC rising edges.
- General reset
相关PDF资料
PDF描述
TSS463-AAR VAN Data Link Controller with Serial Interface
TSS463A-TERZ VAN Data Link Controller with Serial Interface
TSS463C VAN Data Link Controller with Serial Interface
TSS4B02G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B03G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
相关代理商/技术参数
参数描述
TSS461F-TDRZ-9 功能描述:网络控制器与处理器 IC Van Data Link Controller RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray
TSS461F-TDSZ-9 功能描述:网络控制器与处理器 IC ASICS RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray
TSS463 制造商:Atmel Corporation 功能描述:LAN Node Controller, 16 Pin, SOP 制造商:Temic 功能描述:LAN Node Controller, 16 Pin, SOP
TSS463-AA 制造商:未知厂家 制造商全称:未知厂家 功能描述:TSS463-AA [Updated 3/03. 60 Pages]