参数资料
| 型号： | TWL1103GQER |
| 厂商： | Texas Instruments |
| 文件页数： | 25/30页 |
| 文件大小： | 0K |
| 描述： | VOICE BAND AUDIO PROC 80-BGA |
| 标准包装： | 1 |
| 系列： | VBAP™ |
| 类型： | 音频处理器 |
| 应用： | 移动电话 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 80-VFBGA |
| 供应商设备封装： | 80-BGA MICROSTAR JUNIOR（5x5） |
| 包装： | 标准包装 |
| 其它名称： | 296-11095-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页
TWL1103
VOICE-BAND AUDIO PROCESSOR (VBAP
)
SLWS108A – JULY 2000 – JANUARY 2001
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
functional description (continued)
analog modulator
The transmit channel modulator is a third-order sigma-delta design.
transmit filter and PGA
The transmit filter is a digital filter designed to meet CCITT G.714 requirements. The device operates in either
the 15-bit linear or 8-bit companded
-law or A-law mode that is selectable through the I2C interface. The
transmit PGA defaults to 0 dB.
sidetone
A portion of the transmitted audio is attenuated and fed back to the receive channel through the sidetone path.
The sidetone path defaults to –12 dB. The sidetone path can be enabled by writing to the power control register.
receive volume control
The receive volume control block acts as an attenuator with a range of –18 dB to 0 dB in 2 dB steps for control
of the receive channel volume. The receive volume control gain defaults to 0 dB.
receive filter and PGA
The receive filter is a digital filter that meets CCITT G.714 requirements with a high-pass filter that is selectable
through the I2C interface. The device operates in either the 15-bit linear or 8-bit
-law or A-law companded
mode, which is selectable through the I2C interface. The gain defaults to –1 dB representing a 3-dBm0 level
for a 32-
load impedance and the corresponding digital full scale PCMI code. The gain may be set to –2 dB
for the respective 3-dBm0 level for a 16-
load impedance.
digital modulator and filter
The second-order digital modulator and filter convert the received digital PCM data to the analog output required
by the earphone interface.
earphone amplifiers
The analog signal can be routed to either of two earphone amplifiers, one with differential output (EAR1ON and
EAR1OP) and one with single-ended output (EAR2O). Clicks and pops are suppressed for EAR1 differential
output only.
tone generator
The tone generator provides generation of standard DTMF tones and single tone frequencies which are output
to the following devices: 1) The buzzer driver, as a pulse density modulation (PDM) signal 2) The receive path
digital/analog converter (DAC) for outputting through the earphone. There are 255 possible single tones. The
tone integer value is determined by the following formula:
Round (Tone Freq (Hz)/7.8135 Hz)
The value is loaded into one of two 8-bit registers, the high-tone register (04), or the low-tone register (05). The
tone output is 2 dB higher when applied to the high-tone register (04). When generating DTMF tones, the high
DTMF tone must be applied to the high-tone register and the low frequency tone to the low-tone register.
相关PDF资料 |
PDF描述 |
|---|---|
| TXB0102DCUTG4 | IC VOLT-LVL TRANSL BI-DIR 8-US8 |
| TXB0104DG4 | IC VOLT-LEVEL TRANSLATOR 14-SOIC |
| ULN2803ANE4 | IC DARL TRANS ARRAY HV 18-DIP |
| ULQ2003ADR2G | TRANS ARRAY DARL 16-SOIC |
| UPC1663GV-E1-A | IC VIDEO AMP DIFF 8-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TWL1103PBS | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TWL1103PBSR | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TWL1103TPBSQ1 | 功能描述:音频 DSP Auto Cat Voice-Band Audio Processor RoHS:否 制造商:Texas Instruments 工作电源电压: 电源电流: 工作温度范围: 安装风格: 封装 / 箱体: 封装:Tube |
| TWL1103TPBSRQ1 | 功能描述:音频 DSP Auto Cat Voice-Band Audio Processor RoHS:否 制造商:Texas Instruments 工作电源电压: 电源电流: 工作温度范围: 安装风格: 封装 / 箱体: 封装:Tube |
| TWL1103T-Q1 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Automotive Catalog Voice-Band Audio Processor (VBAP) |
发布紧急采购，3分钟左右您将得到回复。