参数资料
型号: TXS75ZA-NP2R
厂商: POWER-ONE INC
元件分类: 电源模块
英文描述: 1-OUTPUT 112 W DC-DC REG PWR SUPPLY MODULE
封装: 2.400 X 3.450 INCH, 0.500 INCH HEIGHT, 3/4 BRICK PACKAGE-14
文件页数: 8/27页
文件大小: 2635K
代理商: TXS75ZA-NP2R
Product Specification
TXS Series: 75…120 A DC-DC Converters
36 to 75 V DC Input, 1.2, 1.5, 1.8, 2.0 and 2.5 V Output, 90 W to 250 W
REV. FEB 18, 2003
16 of 27
www.power-one.com
Output Over Current Protection
When the converter output is overloaded or
shorted, the module will go into hiccup mode. In
the hiccup mode, the brick is switched off
completely and restarted after a period of
approximately 550 ms. If the overload- or short
circuit is still present then, the converter will hiccup
until the overload is removed.
In order to be capable of starting large capacitive
loads, the converter provides a minimum on time
of approximately 30 ms.
Iolim
Iopeak
delta Io =
Iopeak- Io Lim
R Load
time
Io(t) Hiccup mode
off time = constant
550 ms typ
on - pulse duration
see graph
ton min 30 ms
110
Iolim
Short circuit
Nominal load
Overload
Up to 800 ms
Figure 37:
Hiccup Timing at Overload
With increasing overload, the peak output current
is slightly increased (delta Io typically up to 13 A).
At the same time the on pulse duration is reduced,
so that the total energy in an overload condition is
limited.
Typical "on-pulse" duration in overload
0
2
4
6
8
10
12
14
0
200
400
600
800
1000
Puls duration [ms]
delta
Io
=
(Io
P
eak
-
Io
Lim
)
[A]
Figure 38: Characteristic of over current protection
The off period allows hot tracks and loads to cool
down. The heating energy at the location of the
short circuit and in the PCB is proportional to Irms
2.
The following graph shows, that Irms
2 = Io pulse2
ton/T is reduced at high overload, which reduces
the danger of overheating and further damage to
the system.
Energy of the overload current
0
1000
2000
3000
4000
5000
6000
7000
100
102
104
106
108
110
112
114
Output current TXS100 [A]
Io
r
m
s
2
[A
2 ]
Figure 39: Function of Io rms
2, proportional to the
thermal energy at the overload location
Low Input Voltage
Input under voltage lookout
The unit is equipped with an input under voltage
lockout circuit, which ensures a defined start up
sequence.
0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
29
30
31
32
33
34
35
36
Vi [V ]
Ii[A]
Turn-O n
Turn-O ff
Figure 40: TXS under voltage on / off hysteresis at
light load
Reduced output power of models ZB, ZD
The models ZB (1.8 V) and ZD (2.5 V) have a
reduced output power at minimum input voltage
when operated at highest base plate temperature
and increased Uo Set (over Trim or Sense). The
reduction is due to a duty cycle limitation of the
controller.
The rated output power of these two types [180 W
resp. 250 W] is available under the following
conditions:
Ui min >37 V: for TBP = 100 °C and Uo = Uo nom
Ui min >40 V: for TBP = 100 °C and Uo = 112 % Uo nom
At low input voltage, the ZB and ZD models will
switch off and soft restart periodically. The
operation is very similar to an under voltage
lockout or over current protection.
相关PDF资料
PDF描述
TXS75ZA-R3H 1-OUTPUT 112 W DC-DC REG PWR SUPPLY MODULE
TXS75ZB-R3V 1-OUTPUT 135 W DC-DC REG PWR SUPPLY MODULE
TXS80ZC-N3V 1-OUTPUT 160 W DC-DC REG PWR SUPPLY MODULE
TXS80ZC-P2 1-OUTPUT 160 W DC-DC REG PWR SUPPLY MODULE
TXS80ZD-N2V 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
TXS75ZB 制造商:POWER-ONE 制造商全称:Power-One 功能描述:Input voltage range 36ˇ75V DC Single 80ˇ100A output 1500V DC I/O electrical strength test voltage
TXS75ZY 制造商:POWER-ONE 制造商全称:Power-One 功能描述:Input voltage range 36ˇ75V DC Single 80ˇ100A output 1500V DC I/O electrical strength test voltage
TXS80ZC 制造商:Power-One 功能描述:
TXS80ZD 制造商:Power-One 功能描述:
TXS-86-515-S 制造商:FLOYD BELL 功能描述:Alarm, Piezoelectric, 92 dBA to 103 dBA @ 2 Ft., Extra Loud Siren, 5-15VDC